brake light NISSAN ALTIMA COUPE 2009 D32 / 4.G Warranty Booklet
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2009, Model line: ALTIMA COUPE, Model: NISSAN ALTIMA COUPE 2009 D32 / 4.GPages: 55, PDF Size: 2.24 MB
Page 9 of 55
6
2009 NEW VEHICLE LIMITED WARRANTY
WHAT IS NOT COVEREDDAMAGE, FAILURES OR CORROSION DUE TO
ACCIDENTS, MISUSE OR ALTERATIONS
This warranty does not cover damage, failures or corrosion
resulting from:
Q Accident, theft, fi re, driving through water (including
engine water ingestion) or misuse, which includes
racing of any sort whatsoever (Proper use is outlined
in your OWNER’S MANUAL) .
Q Alteration, tampering or improper repair.
Q Installation of non-Nissan approved accessories or
components.
Q Improper installation of any Nissan approved or
aftermarket accessory or component.
Q Glass breakage, unless resulting from defects in
material or workmanship.
Q Normal wear and tear, including dings, dents, chips
or scratches.
ALTERED OR UNCERTAIN ODOMETER MILEAGE
This warranty does not cover repair of any vehicle or any part
of a vehicle whose odometer mileage has been altered, or the
odometer repaired or replaced and the actual vehicle mileage
cannot be correctly and readily determined.
SALVAGE TITLE
This limited warranty does not apply to any vehicle, and is
rendered VOID if the vehicle is (or ever has been) issued a
“salvage” or similar title under any state’s law; or has ever been
determined to be a “total loss” or equivalent by any insurance
company, such as by payment of a cash payment of claim in lieu
of repairs because of a determination that the cost of repairs
exceeded the actual cash value of the vehicle.
DAMAGE, FAILURES OR CORROSION FROM
ENVIRONMENTAL CONDITIONS
This warranty does not cover damage, failures or corrosion
resulting from: Q Stone chipping, chemical fallout (acid rain) , tree sap, salt,
hail, wind-storm, lightning, fl ood or other environmental
conditions.
Q The items listed below are not covered under corrosion
coverage (perforation from corrosion) .
• Exhaust system components.
• Corrosion of outer trim parts, such as moldings.
However, corrosion of outer trim parts is warranted for
12 months or 12,500 miles, whichever comes fi rst.
• Corrosion other than perforation, such as cosmetic
or surface corrosion due to defects in materials
or workmanship. This is covered under the Basic
Coverage of the New Vehicle Limited Warranty.
• Special bodies or equipment not manufactured or
supplied by Nissan.
DAMAGE, FAILURES OR CORROSION DUE TO LACK
OF OR IMPROPER MAINTENANCE
This warranty does not cover damage, failures or corrosion
resulting from:
Q Lack of performance of proper maintenance services as
outlined in your NISSAN SERVICE & MAINTENANCE
GUIDE.
Q Use of improper or dirty fuel, fl uids or lubricants.
Q Use of parts not equivalent in quality or design to parts
supplied by Nissan.
MAINTENANCE SERVICE EXPENSE
This warranty does not cover normal maintenance services
as specifi ed in your NISSAN SERVICE & MAINTENANCE
GUIDE such as engine tune-up; cleaning and polishing; wheel
alignment; headlight aiming; replacement of fi lters, replacement
of windshield wiper inserts, replacement of key fob batteries,
lubricants, coolant; worn brake shoes, pads, drums and rotors
and worn clutch discs.
SEAT BELTS, TIRES, DROP-IN BEDLINERS AND
EMISSION CONTROL SYSTEM
Seat belts, tires, drop-in bedliners and the emission control
system are not covered by this warranty, but are covered by
separate warranties.NISSAN SPRAY-IN BEDLINERS
Nissan Spray-in Bedliners will be repaired to commercially
acceptable standards which may include minor appearance
differences from the original bedliner.
(See following pages for
separate
warranties which may apply
to your Nissan, such as those covering vehicle emissions,
seat belts, and tires.)
Page 33 of 55
30
(9) Replacement of four (4) or more tires from the same
vehicle will not be accepted for ride disturbance
complaints i.e. vibration, out of round, out of balance,
pulling, noise, due to the unlikely event of multiple
tires with uniformity problems.
(10) Claims for weather/ozone cracking after 5 years from
the date of manufacture.
(11) Any tire which has been run with low air pressure or
while fl at.
(12) Tires used in commercial service.
(13) Tires on vehicles regularly operated outside the United
States.
(14) Claims made by anyone other than the original retail
purchaser of the vehicle.
(15) Tires with the D.O.T. identifi cation number removed
or rendered illegible.
(16) Any tire not presented and available for Toyo’s inspec-
tion.
(17) Any tire for which mileage and tire rotation records
are not available or verifi able.
(18) Any tires worn beyond the wear bars (less than
2/32
nds of an inch of tread remaining) .
(19) Tires not supplied as original equipment on new
vehicles (refer to Owner’s Manual for coverage) .
(20) “T” Type temporary spare tires used at speeds over
50 miles per hour, exhibiting such damage.
(21) Dealer service charges are not covered for routine or
required maintenance of the tires such as alignments,
rotation or balancing.
(22) The cost of applicable federal, state and local taxes
and fees.
(23) Retreaded passenger and light truck tires are not
warranted.
TOYO TIRE LIMITED WARRANTY
(5) Check infl ation pressure before use. Failure to have
proper infl ation pressure when using your spare tire
can result in serious personal injury or death. Maintain
infl ation pressure of 35 psi for the temporary full size
spare and 60 psi for the “T” Type, high pressure,
temporary spare tire. When infl ating or adding air to
a “T” Type temporary spare tire, be very careful since
the smaller tire volume can gain pressure much more
rapidly than a normal full size tire.
(6) Placing (mounting) your temporary use tire on a wheel
which is not specifi cally designed for use with the
temporary use tire or placing another type tire on
your temporary use wheel can be dangerous. Your
vehicle’s handling characteristics can be seriously
affected. You could have an accident resulting in
serious personal injury or death. Consult your vehicle
Owner’s Manual for proper use of your “temporary
use” spare tire.
(7) The “T” Type high pressure temporary spare tire
should not be used with any other wheel nor should
standard tires, snow tires, wheel covers or trim rings
be used on the high pressure spare tire wheel.
(8) Do not operate your vehicle with more than one
temporary spare in use (this does not apply to a full
size spare) and only at limited speeds and distances
as indicated on the sidewall of the tire.
(9) The “T” Type temporary spare tire may lower ground
clearance when used. Avoid driving over large ob-
stacles and other road hazards. Check your vehicle
Owner’s Manual for other special clearance precau-
tions when using the “T” Type temporary spare tire
provided in your vehicle.
(10) Follow the maintenance recommendations and safety
warnings contained in the Owner’s Manual and in
the Important Tire Safety Information section of this
booklet.
WHAT IS NOT COVERED BY THIS
LIMITED WARRANTY(1) Mileage is not warranted.
(2) Damage due to road hazards, whether repairable or
not (such as cut, snag, bruise, impact break, bulge,
puncture, improper use of tire chains, stone drill, chip,
scale) . These types of damages or air loss always
require tire removal and inspection by a qualifi ed tire
professional.
(3) Irregular tread wear or rapid tread wear due to failure
to rotate the tires at recommended intervals or from
vehicle misalignment.
(4) Damage resulting from improper repair materials or
procedures such as rope type plugs. Toyo does not
warrant any inspection or repair process. The repair
is entirely the responsibility of the repairer and should
be made in accordance with procedures as specifi ed
by the Rubber Manufacturers Association (RMA) .
(5) Damage from incorrect mounting or dismounting of
the tire, incorrect wheel size, water or other material
trapped inside the tire during mounting or failure to
balance the tires.
(6) Damage or uneven tread wear from incorrect infl ation,
overloading, fi re, theft, defective mechanical condi-
tions such as brakes, shocks, rims, wreck or collision,
misuse, misapplication, negligence, willful damage or
abuse, vandalism, tire alteration, tire spinning, racing
or competition purposes.
(7) Damage, corrosion or rubber deterioration due to
the use of oil-based chemicals, water-based sealers,
balancing substances, or fl ammable gases.
(8) Uniformity problems such as ride, balance and vibra-
tion complaints after the fi rst 25% of tread wear.
(Continued on page 31)
Page 38 of 55
35
HAZARDSObjects in the road that threaten a tire should be safely
avoided. These objects are potholes, glass, metal, rocks,
wood debris and the like. Unavoidable contact should
prompt a thorough tire inspection.
You may not always recall hitting an object that can damage
or injure your tires. If while driving your vehicle experiences
any unusual vibrations, ride disturbance or noise and/or
you suspect that possible damage to the tires or vehicle
has occurred, DO NOT JAM OR LOCK YOUR BRAKES!
Rather reduce your speed and drive with caution until you
can safely pull off the road. Stop and inspect the tires. If
the tire is underinfl ated or damaged, defl ate, remove the
tire and rim assembly and replace it with your spare. If you
cannot detect a cause, have the vehicle towed to the nearest
vehicle or tire dealer to have the vehicle inspected.REPAIRING, MOUNTING AND
DEMOUNTING OF TIRESDo not attempt to repair, mount or demount a
tire yourself. Tire changing can be dangerous and
must be done by professionally trained persons using
proper tools and procedures as specifi ed by the Rubber
Manufacturers Association (RMA) . Follow these
mounting recommendations. Your tires should be
mounted on wheels of correct size and type and which are
in good, clean condition. Bent, chipped or rusted wheels
may cause tire damage. The inside of the tire must be free
from foreign materials. Have your dealer check the
wheels before mounting new tires. Mismatched tires
and rims can explode during mounting. Also, mismatched
tires and rims can result in dangerous tire failure on the
road. If a tire is mounted by error on the wrong-sized rim,
do not remount it on the proper rim - scrap it. It may be damaged internally (which is not externally visible) by being
dangerously stretched and could fail on the highway.
Old valves may leak. When new tubeless tires are mounted,
have new valves of the correct type installed. Tubeless tires
must be mounted only on wheels designed for tubeless
tires, i.e., wheels which have safety humps or ledges.
Never perform a temporary repair, use an innertube or
inject sealant as a permanent substitute for a proper
repair. Only qualifi ed persons should repair tires.
Be sure that all your valves have suitable valve caps. This
will keep valve cores clean and clear and guard against
leakage.
REPAIRS - WHENEVER POSSIBLE, SEE A TIRE
DEALER AT ONCE. Some tire manufacturers do not
warrant any inspection or repair process. The repair is
entirely the responsibility of the repairer. Punctures in the
tread of a passenger tire which do not exceed 1/4 of an inch
(6mm) in diameter can usually be repaired by following the
Rubber Manufacturer's Association (RMA) Passenger and
Light Truck Repair procedures. Contact the manufacturer of
your tires for its position and assistance as to the acceptable
location for a proper repair and the repair of speed rated
tires. Do not use plug repairs. They may cause further
damage to the tire. They are not always air tight and
the plug may fail. Do not exceed posted speed limits on
any repaired tire. Certain tire manufacturers speed ratings
are voided if the tire is repaired.
Although a tire was properly repaired, internal structural
damage resulting from the puncture may have occurred. Sometime later the damage may cause the tire to be
removed from service.
If the tire has a puncture in the tread which exceeds 1/4 inch
(6mm) , the tire must be replaced. If any tire has sustained a
puncture, have the tire inspected internally by a tire dealer
for possible damage that may have occurred.
Improper mounting and infl ation procedures can cause an
explosion of the tire/rim assembly. Only specially trained
persons should perform these tasks. Contact your tire store
or dealer for assistance.
CAUTION - Never, under any circumstance,
introduce a fl ammable substance into a tire.
WHEEL ALIGNMENT AND BALANCINGWheel alignment and balancing are important for safety
and maximum mileage from your tires. Check how your
tires are wearing at least once a month. If your tires are
wearing unevenly, such as the inside shoulder of the tire
wearing faster than the rest of the tread, or if you detect
excessive vibration, your vehicle may be out of alignment
or balance. These conditions not only shorten the life of
your tires, but adversely affect the handling characteristics
of your vehicle which could be dangerous. If you detect
irregular wear or vibration, have your alignment and
balance checked immediately. Tires which have been run
underinfl ated will show more wear on the shoulders than
in the center of the tread.
* Provided by and published at the request of the tire
manufacturers/warrantors.
IMPORTANT TIRE SAFETY INFORMATION*
(Continued on page 36)