ESP NISSAN ALTIMA COUPE 2013 D32 / 4.G Quick Reference Guide
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2013, Model line: ALTIMA COUPE, Model: NISSAN ALTIMA COUPE 2013 D32 / 4.GPages: 26, PDF Size: 2.32 MB
Page 5 of 26

NISSAN INTELLIGENT kEY® SYSTE M
The niSSAn intelligent k ey® system allows you to lock   
or unlock the vehicle, open the trunk and start the engine.
n OTe: it is important to make sure the intelligent k ey is 
with you (that is, in your pocket or purse).
 
  The operating range of the intelligent k ey is within 
    31.5 in (80 cm) from each request switch.
 
  To lock the vehicle, push either door handle request 
   switch
 
01 once or press the
  button
 02 on 
    the keyfob.
 
  To unlock the vehicle, perform one of the following 
   procedures:
    • Push either door handle request switch
 
01 once; 
      the corresponding door will unlock. Push the door 
      handle request switch
 
01 again within 5 seconds; 
      all other doors will unlock, or
    • Press the
 
 button
 03 on the keyfob to unlock the driver’s side door. Press the
  button 
 
      again; all other doors will unlock.
 
  To release the trunk lid, press the  button
 04 for more than 0.5 seconds. Lift the trunk lid 
    to access the trunk.
 
  The Intelligent Key can also be used to activate the panic alarm by pressing and holding the
    
    button
 05 for more than 0.5 seconds. Once activated, the panic alarm and headlight\
s will stay 
    on for 25 seconds. 
ni SSAn inTe LLiGenT keY
® BATTe RY diSc HARG e
 
  If the battery in the Intelligent Key is almost 
    discharged, the guide light
 
06 of the intelligent 
    Key port blinks and the Intelligent Key battery 
    discharge indicator
 
07 is displayed in the vehicle 
    information display.
 
  To start the engine under these circumstances, insert 
    the Intelligent Key into the key port with the buttons 
    facing upward and the key ring end toward you until 
    it latches into place. Then push the ignition switch to 
    start the engine.
 
  To remove the intelligent k ey from the port, push the 
    ignition switch to turn the engine off and then pull the 
    intelligent k ey out of the port.
 
  The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery   
   indicator
 
07 , replace the battery in the Intelligent Key.
f
or more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 
5)” and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
3
first drive features
02
03
04
05
06
F
07
To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\hfo.mobi  
Page 11 of 26

9
FM/AM/SiriusXM™* SATELLITE RADIO WITh CD/DVD PLAYER 
(if so equipped)
01 VOL/ON•OFF CONTROL KNOB
    Press the VOL/ON•OFF control knob to turn the system on or off. 
  
  Turn the VOL/ON•OFF control knob right or left to increase or decrease the volume.
02 SEEk
ING BUTTON
    To scan quickly through each broadcasting station, press the seeking button left  or right  . 
  
  f or SiriusXM™ satellite radio, press  or  to switch to the first channel of the previous or 
      next category.
  
 Press  or  to change tracks on a cd. 
  
  Press and hold  or  to fast forward or rewind a track on a cd.   
03  TUNE/FOLDER/AUDIO CONTROL k
NOB 
    To manually tune the radio, turn the TUNE/FOLDER/AUDIO  control knob left or right. 
04 STATION SELECT BUTTONS
    Twelve stations can be set for the FM band, six for the AM band and eighteen for SiriusXM 
    satellite radio. 
  
  To store a station in a preset, you must first select a radio band by pressing the FM•AM
 05   
     or 
XM  button
 06 , then tune to the desired AM, f
M or SiriusXM satellite station. 
    Then press and hold the desired station select button (1 -6 ) until the preset number is 
      updated on the display and the sound is briefly muted. The channel indicator will then 
      come on and the sound will resume. Programming is now complete. 
  
  To retrieve a previously set station, select the radio band where the preset was stored 
      then press the corresponding station select button (1 -6 ). 
07 CD/DVD OPEN/TILT BUTTON
 
    Press and hold the cd/ dVd OPEN/TILT button and the display screen will move down 
      to expose the cd/ dVd insert slot. 
  
  Press and hold the button again to tilt the screen farther. 
*SiriusXM™ Satellite Radio is only available on vehicles equipped with optional SiriusXM satellite radio subscription service.
for more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4)” of your 
Owner’s Manual.
02
07
05
06
010304
To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\hfo.mobi  
Page 13 of 26

2013 Altima coupe delivery checklist
naVigation s ystem (if so equipped)
\bemonstrate      yes
1.  How to operate the\f touch screen 
 
    and/or scrolling d\fial
2.  How to add a home \flocation 
 
3.  How to set a desti\fnation 
 
4.  How to search for n\fearby places 
5. How to turn the di\fsplay off  
TIRE PRESSURE MONITORING SYSTEM (TPMS) 
            Ye s 
1.  identify TPMS icon in meter cluster 
 
 
2.  identify warning message location in Vehicle 
 
    information display  
3.  demonstrate TPMS reset procedure 
 
4.  Explain effects of low ambient temperatures on  
   tire pressure
eleCtroniC QuiCK referenCe gui\be (eQrg)             yes
1.  Explain that addit\fional vehicle oper\fation information c\fan be viewed via t\fhe  
       
    Nissan EQRG websit\fe at www.nissanownersinfo.mo\fbi
2.  Explain that EQRG \finformation can be \fviewed via SmartPh\fone or personal co\fmputer 
 
3.  Identify where on th\fe vehicle’s Quick \fReference Guide the\fy can find the inter\fnet 
   address (P\b viewing\f) or Quick Respons\fe \bode (SmartPhone \fviewing) to access\f 
    the Nissan EQRG si\fte
All information\f specifications\f photographs and illustrations are those in effect at the time of printing. 
NISSAN reserves the right to change specifications or design without notice and without obligation. 
For  additional  information\f  see  your  NISSAN  dealer  or  contact NISSAN  North  America\f  Inc.  See 
Owner’s Manual for \fimportant warnings\f and details on ve\fhicle operation an\fd maintenance. Sales \bonsultant Si\fgnature   Date 
Sales Manager Sign\fature      Date
\bustomer Signature   Date
Nissan\f the Nissan \fBrand Symbol\f Z and 
Nissan model names\f are Nissan tradem\farks.
© 2012 Nissan North Ame\frica\f Inc.
QR
3E 0L32U0Printing: June 2012 (20)   
Page 17 of 26

13
  Press the
 or  button on the steering wheel to activate voice recognition.
 
 
  Wait for the tone before speaking.  
 
   Begin speaking a command within 5 seconds of the tone.
 
  Speak in a clear and natural voice without pausing between words.  
 
  Look straight ahead and avoid speaking too loudly or too softly.
 
  To go back to the previous command, say “Go back”.
 
  To cancel a voice recognition session, say “exit” or press and hold the
 or
  button.
 
  To interrupt the system voice and give a command quickly, press the
 or
  button.
 
  When speaking Phonebook names, please be aware some phones require the last name to be 
    spoken before the first name. For example, “Michael Smith” may be spoken as “Smith Michael”.
 
  To increase or decrease the volume of the voice prompts, push the volume \
control switches 
      
or
 + on the steering wheel or turn the VOL/ON•OFF control knob on the audio system 
 
    while the system is responding.
 
  if the Voice Recognition system does not recognize your voice commands, train th\
e system 
    using the Speaker Adaptation Mode. See your Owner’s Manual for detailed information.
 
  Some commands are not available while the vehicle is in motion.
 
  The “Help” command can be used to hear a list of available commands at any time.
 
  Please refer to the cellular phone manufacturer’s Owner’s Manual f\
or detailed information 
    regarding your Bluetooth phone.
Bluetooth System without Navigation* (if so equipped)
cOnnec TinG PROcedu Re
NOTE: The vehicle must be stationary when connecting 
the phone.
  1.   Press the
 
button on the steering wheel. The 
    system announces the available commands.  
  2.   Say: “connect phone”. The system acknowledges 
    the command and announces the next set of 
    available commands.  
  3.   Say: “Add phone”. The system acknowledges the command and asks you to initiate connecting   
    from the phone handset.
  4.  initiate connecting from the phone:
    • The connecting procedure varies according to each cellular phone model. For detailed   
      connecting instructions and compatible phones, please visit   
     www.nissanusa.com/bluetooth.
    • When prompted for a Passkey code, enter “1234” from the handset. (The Passkey code is
      assigned by NISSAN and cannot be changed.) 
  5.   Say a name for the phone when the system asks you to provide one. You can give the phone 
    a name of your choice.
To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\hfo.mobi
*Some jurisdictions prohibit the use of cellular telephones while driving.