check engine NISSAN CUBE 2012 3.G Quick Reference Guide

NISSaN INTeLLIGeNT K eY® SYSTe M (if so equipped)
The niSSAn intelligent k ey® System allows you to lock or
unlock the vehicle, open the back door and start the engine.
n OTe: it is important to make sure the intelligent k ey is
with you (that is, in your pocket or purse).

The operating range of the intelligent k ey is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle request
switch

01 , push the back door request switch
02 ,
or press the

button
03 on the keyfob.

To unlock the vehicle, perform one of the following
procedures:
• Push either door handle request switch

01 once
or the back door request switch
02 once; the
corresponding door will unlock. Push the request
switch again within 1 minute; all other doors
will unlock, or
• Press the

button
04 on the keyfob to unlock
the driver’s side door. Press the
button again;
all other doors will unlock.

The intelligent k ey can also be used to activate the
panic alarm by pressing and holding the

button
05
for more than 1 second. Once activated, the panic

alarm and headlights will stay on for 25 seconds.
inTe LLiGenT keY BATTe RY diSc HARG e

if the battery of the intelligent k ey is discharged, or
environmental conditions interfere with the intelligent
k ey operation, start the engine according to the
following procedure:
1. Move the shift lever to the P (P arK) position.
2. firmly apply the foot brake.
3. Touch the ignition switch with the intelligent k ey
and a chime will sound.
4. Within 10 seconds after the chime sounds, push the ignition switch while depressing the
brake pedal and the engine will start.
for more information, refer to the “Pre-driving checks and adjustments (section 3)” , the “Starting and driving (section 5)”
and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
4
first drive features
01
02
03
04
05
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

OuTSIDe MIrrOr CONTr OL SwITCH
The outside mirror control switch is located on the
left side of the instrument panel.

To select the left or right mirror, move the switch
01 .

Adjust each mirror to the desired position using the
switch

02 .

To prevent accidentally moving the mirror, move this
switch

01 to the center “neutral” position.
f
or more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
6
first drive features
fOLdinG dOWn TH e ReAR B encH SeAT

To fold the seats flat, secure the seat belts on
the seat belt hooks on the side wall. Release the
connector tongue of the rear center seat belt from
the buckle, then store the connector and seat belt
tongues on the seat belt hook.

Before folding down the seatback, tuck the seat belt
buckles into the seat cushion pockets.

fold the seatback down by pulling the adjusting strap
01 .

To raise the seatback, lift up each seatback and push it to the upright position until it is latched.

After raising the seatback, pull the seat belt buckles out of the seat cushion pockets until they
are fully extended before using the seat belts.
for more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
01
02
01
ST arTING/STOPPING TH e eNGIN e
CONTIN uOu SLY V arIaBLe TraNSMISSION
(NISSaN Intelligent Key® models only - if so equipped)

depress the brake pedal.

Move the shift lever to P (P arK).

Push the ignition switch to start the engine.
n OTe: it is important to make sure the intelligent k ey is
with you (that is, in your pocket or purse).

T uRnin G THe enGine Off

Move the shift lever to the P (P arK) position, apply
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.