check engine NISSAN CUBE 2014 3.G Quick Reference Guide
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2014, Model line: CUBE, Model: NISSAN CUBE 2014 3.GPages: 20, PDF Size: 1.16 MB
Page 7 of 20

5
NISSAN INTELLIGENT KEY® SYSTEM (if so equipped)
The NISSAN Intelligent key® System allows you to lock or 
unlock the vehicle, open the back door and start the engine.  
It is important to make sure the Intelligent 
k
ey is with you  
(that is, in your poc
ket or purse).
    The operating range of the Intelligent  key is within   
31.5 in (80 cm) from each request switch.
    To lock the vehicle, push either door handle request   
switch  
01, push the back door request switch  02,  
or press the  
 button
 03 on the key fob.
   To unlock the vehicle, perform one of the 
 
following procedures:
 
 
• 
  
Push either door handle request switc
 h 
01 once 
 
or the back door request switch  02 once; the  
corresponding door will unlock. Push the request   
switch again within 1 minute; all other doors   
will unlock, or
 
 
• 
 
Press the   button
 04 on the key fob to unlock  
the driver’s side door. Press the   button again; 
 
all other doors will unlock.
    The Intelligent  key can also be used to activate the   
panic alarm by pressing and holding the  
 button
 05  
for more than 1 second. Once activated, the panic   
alarm and headlights will stay on for a period of time.
INTELLIGENT 
k
EY BA
TTERY DIS
cHAR
GE  
   If the battery of the Intelligent  key is disc harged, or  
environmental conditions interfere with the Intelligent   
key operation, st
art the engine according to the   
following procedure:
   1.
 
Move the shift lever to the 
 P (PARK) position. 
 
 
2. 
  
Firmly apply the foot brake.  
 
 
3. 
   
T
ouch the ignition switch with the Intelligent  k
ey
   
and a chime will sound.
 
 
4. 
   
W
ithin 10 seconds after the chime sounds, push the ignition switch while depressing the   
brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” , the “Starting and driving (section 
5)”  and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
02
03
04
05
first drive features
1523989_14_Cube_QRG_091613.indd   59/16/13   3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.  
Page 9 of 20

7
OUTSIDE MIRROR CONTROL SWITCH
   The outside mirror control switch is located on the   
left side of the instrument panel.
    To select the left or right mirror, move the switch 01  
to the left or right
    Adjust eac h mirror to the desired position using   
the control switch  
02.
   To prevent accidentally moving the mirror, move switch
 
01 to the center (neutral) position.
For more information, refer to the “Pre-driving checks and adjustments 
(section 3)” of your Owner’s Manual.
FOLDING DOWN THE REAR BENcH SEAT
  To fold the seats flat, secure the seat belts on 
 
 
the seat belt hooks on the side wall. Release the
  
 
 
connector tongue of the rear center seat belt from
  
 
 
the buc
 kle then store the connector and seat belt 
 
 
tongues on the seat belt hook.
  Before folding down the seatbac k, tuck the seat belt 
 
 
buc
 kles into the seat cushion pockets.
  Fold the seatback down by pulling the adjusting strap  01.
  To raise the seatback, lift up the seatback and push it to the upright position until it is latched.
  After raising the seatback, pull the seat belt buckles out of the seat cushion pockets until they 
 
 
are fully extended before using the seat belts.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (se\
ction 1)” of your 
Owner’s Manual.
01
02
01
STARTING/STOPPING THE ENGINE
cONTINUOUSLY VARIABLE TRANSMISSION 
(N ISSAN Intelligent  k
ey® models only - if so equipped)  
   It is import ant to make sure the Intelligent  key is 
with you (that is, in your poc ket or purse).
   Depress the brake pedal.
  Move the shift lever to the  P (PARK) position.
  Push the ignition switch to start the engine.
 
TURNING THE ENGINE OFF  
   Move the shift lever to the  P (PARK) position, apply  
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features,  please go to www.nissanownersinfo.mobi.
1523989_14_Cube_QRG_091613.indd   79/16/13   3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.