key NISSAN CUBE 2014 3.G Quick Reference Guide

4
FUEL-FILLER DOOR
To open the fuel-filler door, pull the release 01
located on the driver
’s side instrument panel.
The fuel-filler door is located on the right, rear side of



the vehicle.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
01
esse ntial i n for mation
CLOCK SET/ADJUSTMENT
To adjust the time and the
appearance of the clock on
the display:



1.

Press the
SETUP button
01.



2.


Select the “System” key

.



3.


Select the “

c
lock” key.
The following settings can be adjusted:



•

T
ime Format: The clock can be
set to 12 hours or 24 hours.



•

Use G
PS Clock: When this setting is activated,
the clock is set and continually updated via the GPS
used by the Navigation System.



•

Set Cloc
k Manually: When this setting is
activated, the clock can be set manually. Touch the
“+” or “−” key to adjust the hours and minutes up
or down.



•

Daylight Savings T
ime: When this setting is activated, daylight savings time is on.
Touch the “Daylight Savings Time” key to toggle the setting on or off.



•
Time Zone: c hoose the applicable time zone from the list.
For more information, refer to the “Instruments and controls (section 2)” and the “Heater, air conditioner, audio and
phone systems (section 4)” of your Owner’s Manual.
01
1523989_14_Cube_QRG_091613.indd 49/16/13 3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

5
NISSAN INTELLIGENT KEY® SYSTEM (if so equipped)
The NISSAN Intelligent key® System allows you to lock or
unlock the vehicle, open the back door and start the engine.
It is important to make sure the Intelligent
k
ey is with you
(that is, in your poc

ket or purse).
The operating range of the Intelligent key is within
31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request
switch
01, push the back door request switch 02,
or press the
button
03 on the key fob.
To unlock the vehicle, perform one of the

following procedures:



•

Push either door handle request switc
h
01 once

or the back door request switch 02 once; the
corresponding door will unlock. Push the request
switch again within 1 minute; all other doors
will unlock, or



•


Press the button
04 on the key fob to unlock
the driver’s side door. Press the button again;

all other doors will unlock.
The Intelligent key can also be used to activate the
panic alarm by pressing and holding the
button
05
for more than 1 second. Once activated, the panic
alarm and headlights will stay on for a period of time.
INTELLIGENT
k
EY BA

TTERY DIS
cHAR

GE
If the battery of the Intelligent key is disc harged, or
environmental conditions interfere with the Intelligent
key operation, st

art the engine according to the
following procedure:
1.


Move the shift lever to the
P (PARK) position.



2.

Firmly apply the foot brake.



3.

T

ouch the ignition switch with the Intelligent k
ey

and a chime will sound.



4.

W

ithin 10 seconds after the chime sounds, push the ignition switch while depressing the
brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” , the “Starting and driving (section
5)” and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
02
03
04
05
first drive features
1523989_14_Cube_QRG_091613.indd 59/16/13 3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

6
FRONT SEAT ADJUSTMENTS
To slide the seat forward or backward, pull up on the
lever 01 under the front of the seat and slide forward
or bac
kward. Release the lever to lock the seat



in position.

To recline the seatback, pull up on the lever 02 and
lean bac
k. To bring the seatback forward, pull the lever



up and lean your body forward. Release the lever to




loc

k the seatback in position.
S
EA

T


LIFTER
(driver

’s seat only)
To adjust the seat height, pull up or push down
repeatedly on the adjusting lever
03.
For more information, refer to the “Safety — Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
OPENING THE BACK DOOR
Use one of the following methods to unlock the back door
then pull the handle
01 to open:
Press the
button
02 on the key fob twice.
Push the bac
k door request switch
03 while carrying
the N
ISSAN Intelligent
key® with you (if so equipped).
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
03
01
0203
01
0202
REAR SEAT ADJUSTMENTS
ADJUSTING THE REAR BEN
cH S

EAT
To slide the rear bench seat forward or backward,



pull up on the lever 01 under the front of the seat
and slide forward or bac kward. The seat will slide in



3 fixed positions. Release the lever to loc
k the seat



in position.
To recline the seatback, pull the strap 02 and lean back. To bring the seatback forward, pull

the strap and lean forward. Release the strap to loc k the seatback in position.
01
02
first drive features
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
1523989_14_Cube_QRG_091613.indd 69/16/13 3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

7
OUTSIDE MIRROR CONTROL SWITCH
The outside mirror control switch is located on the
left side of the instrument panel.
To select the left or right mirror, move the switch 01
to the left or right
Adjust eac h mirror to the desired position using
the control switch
02.
To prevent accidentally moving the mirror, move switch

01 to the center (neutral) position.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
FOLDING DOWN THE REAR BENcH SEAT
To fold the seats flat, secure the seat belts on



the seat belt hooks on the side wall. Release the




connector tongue of the rear center seat belt from




the buc
kle then store the connector and seat belt



tongues on the seat belt hook.
Before folding down the seatbac k, tuck the seat belt



buc
kles into the seat cushion pockets.
Fold the seatback down by pulling the adjusting strap 01.
To raise the seatback, lift up the seatback and push it to the upright position until it is latched.
After raising the seatback, pull the seat belt buckles out of the seat cushion pockets until they



are fully extended before using the seat belts.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
01
02
01
STARTING/STOPPING THE ENGINE
cONTINUOUSLY VARIABLE TRANSMISSION
(N ISSAN Intelligent k
ey® models only - if so equipped)
It is import ant to make sure the Intelligent key is
with you (that is, in your poc ket or purse).
Depress the brake pedal.
Move the shift lever to the P (PARK) position.
Push the ignition switch to start the engine.

TURNING THE ENGINE OFF
Move the shift lever to the P (PARK) position, apply
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
1523989_14_Cube_QRG_091613.indd 79/16/13 3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

15
To increase or decrease the volume of the voice prompts, push the volume \
control switches
or
on the steering wheel or turn the VOL/ON•OFF control knob on the audio

system while the system is responding.
If the Voice Recognition system does not recognize your voice commands, train th\
e system
using the Speaker Adaptation Mode. See your Owner’s Manual for detailed information.
For more detailed information and instructions, refer to your cellular phone’s Owner’s
Manual and visit www.nissanusa.com/bluetooth.
cONNEcTING PRO c EDURE
The vehicle must be stationary when connecting the phone.
1.


Press the button
on the steering wheel. The system announces the available commands.

2.


S

ay: “
c
onnect phone”. The system acknowledges the command and announces the next set



of available commands.
3.


S

ay: “Add phone”. The system acknowledges the command and asks you to initiate
connecting from the phone handset.
4.


Initiate connecting from the phone:
•



T

he connecting procedure varies according to each cellular phone model. For
detailed connecting instructions and compatible phones, please visit
www.nissanusa.com/bluetooth.
•


W

hen prompted for a Passkey code, enter “1234” from the handset. (The Passkey code
is assigned by NISSAN and cannot be changed.)
5.


S

ay a name for the phone when the system asks you to provide one. You can give the phone
a name of your choice.
PHONEBOOk SE TUP
Depending on your cellular phone, the system may automatically download \
your celluar
phone’s entire phonebook to the vehicle’s Bluetooth® system.
If the phonebook does not download automatically , 40 entries can be individually downloaded.
To manually download entries:



1.

Push the button on the steering wheel.




2.


After the tone, s
ay “Phonebook”.
3.


After the next tone, s

ay “Transfer Entry”. The system acknowledges the command and
asks you to initiate the transfer from the phone handset. The new contact phone number
will be transferred from the cellular phone to the vehicle.
4.


T

he system repeats the number and prompts you for the next command. When you have
finished entering numbers or transferring an entry, choose “Store.”
5.


T

he system confirms the name, location and number.
The transfer procedure varies according to each cellular phone. See your cellular phone’s
Owner’s Manual for details. You can also visit www.nissanusa.com/bluetooth for
instructions on transferring phone numbers from NISSAN recommended cellular phones.
1523989_14_Cube_QRG_091613.indd 159/16/13 3:31 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.