refrigerant type NISSAN GT-R 1998 Service Manual

TROUBLE DIAGNOSES
ldle speed adjusting screw
ECL1641 C
ldle Speed Inspection and Adjustment
ldle speed specification (After warm-up)
Engine type I RygE I RB25DE I RB25DET
Base idle speed (Pm)
(Feedback control cancelled) 600
I 1
idle speed [N or P position] (Air conditioner ON)
Ignition timing
(Feedback control cancelled) I 15*2/600
. . I I
650250 Go (700 - 900)'
CO density 0.1, max.
HC density 50, max.
': ldle speed varies with air conditioner refrigerant pressure and engine cool- "" "
ant temperature.
0
a Warm up engine to normal operating temperature.
a Connect "CONSULT' to the data link connector for CON- 87'
SULT (under the instrument lower driver panel) and turn
ignition switch ON.
Connect a tachometer to the engine speed detection ter- R8
minal.
a Check that the air conditioner load, power steering pump ~p, -4 load, and various electrical loads are not applied to the
engine. During inspection and adjustment, the
A/T selec-
tor lever must be in
"N"
or
"P"
position.
a Perform "IACV-AAC VALVE ADJn in "WORK SUPPORT EL
@ mode with CONSULS.
@ a Disconnect throttle position sensor harness connector. 8~
(Above step cancels the idle speed feedback control.)
0 Turn idle speed adjusting screw (IAS) on the AAC valve
assembly to adjust base idle speed to
600 rpm.
a Turning IAS clockwise makes base idle speed lower. Turning
IAS counterclockwise makes base idle speed higher.
a Cancel "IACV-AAC VALVE ADJ" in "WORK SUPPORT'
@ mode with CONSULT.
a Connect throttle position sensor harness connector.
a Check that the actual idle speed is 650-1-50 rpm.

FULLY AUTOMATIC AIR CONDITIONER
System Description
The fully automatic air conditioner system utilizes sensors to detect the in-vehicle temperature, ambient
temperature, temperature of air passing through the evaporator, and
sunload. The detected values are
compared with the temperature adjustment dial setting, and calculated by the microcomputer within the
automatic amplifier. The air inlet and outlet temperatures and airflow rate are adjusted in order to main-
@ tain the in-vehicle temperature.
When an abnormal pressure occurs within the cooler cycle [gauge pressure: approx.
2.7 MPa (28 kg/
cm2G)
or higher; or approx. 0.18
MPa
(1.8
kg/cm2-G)
or lower] the refrigerant pressure sensor operates,
Ec
and stops the compressor.
The
ECM turns off the air conditioner relay, and stops the compressor during engine high load.
The blower fan motor utilizes
a brushless motor, and controls the airflow with a built-in IC that recognizes AT
the driver signal (pulse) from the automatic amplifier.
Step-motor type actuators are employed for intake door, mode door, and air mix door. They are rotated in
response to the signal (pulse) step quantity transmitted from the automatic amplifier to control the target
BR
door position.