tow NISSAN GT-R 2015 R35 Quick Reference Guide

4
VEHICLE MODIFICATIONS
Do not modify the vehicle with aftermarket parts or accessories.
To maintain your vehicle’s performance, only use genuine GT-R specific components.
For more information, refer to the “GT-R Overview (section GTR)” of your Owner’s Manual.
VEHICLE DYNAMIC CONTROL (VDC)
Always make sure the VDC is ON before driving the vehicle.
The VDC OFF mode should ONLY be used briefly to help free the vehicle if it is stuck in
snow or mud.
For more information, refer to the “GT-R Overview (section GTR)”, the “Instruments and controls (section 2)” and
the “Starting and driving (section 5)” of your Owner’s Manual.
FUEL-FILLER DOOR/CAP
The fuel-filler door is located on the passenger
side, towards the rear of the vehicle.
When the doors of the vehicle are locked or unlocked, the fuel-filler door is automatically locked
or unlocked at the same time.
Push 1 of the power door loc k switches to unlock
the fuel-filler door from inside the vehicle or push the door handle request switch to unlock
the fuel-filler door from outside the vehicle.
To open the fuel-filler door, press the left side of the door to release the door lock then pull the door open.
To tighten, turn the fuel-filler cap clockwise until a single click is heard. If the cap is not fully
tightened, the Malfunction Indicator Light (MIL)
may illuminate.
If the
light illuminates because the fuel-filler
cap is loose or missing, tighten or reinstall the
cap. The
light should extinguish after a few driving trips.
For more information, refer to the “Instruments and controls (section 2)” and the
“Pre-driving checks and
adjustments (section 3)” of your Owner’s Manual.
UNIQUE NOISES
The GT-R is a high-performance vehicle that has unique operating characteristics.
You will hear more noises emitted from this vehicle than from a conventio\
nal
passenger car.
For more information, refer to the “GT-R Overview (section GTR)” and the “Starting and driving (section 5)” of
your Owner’s Manual.
ESSE NTIAL I N FOR MATION
1655184_15b_GTR_QRGText-Insert_062414.indd 46/24/14 9:06 AM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

9
WINDSHIELD WIPER AND WASHER SWITCH
The ignition switch must be in the ON position to activate the windshield wipers.
Move the lever to one of the following positions to
operate the windshield wipers:
1 Mist ( MIST) – Push the lever up for 1 sweep
of the wipers.
2 Speed-sensing Intermittent ( INT) – Push the
lever down. The wipers operate intermittently,
and wiper speed varies in accordance with
vehicle speed. Intermittent operation can be
further adjusted by twisting the time control
ring
3 to increase or decrease wiper speed. 4 Low Speed (
LO) – Push the lever down for
continuous low-speed operation of the wipers.
5 High Speed ( HI) – Push the lever down for
continuous high-speed operation of the wipers.
6 Pull the lever toward you to activate the washer . The wipers will operate several times.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
LANE CHANGE SIGNAL
To signal a lane change, move the lever up or down to the point where the indicator light
begins to flash but the lever does not latch.
The turn signal will flash 3 times automatically.
HIGH BEAM SELECT
Push the headlight control switc h forward 4
to select the high beam function. The blue
indicator light
illuminates in the instrument
panel. Pull the headlight switch back to the
original position to select the low beam. The blue
indicator light extinguishes.
Pull and release the headlight control switc h 5
to flash the headlight high beams on and off.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
45
6
1
4
5
MIST
OFF
INT
LO
HI
2
3
1655184_15b_GTR_QRGText-Insert_062414.indd 96/24/14 9:06 AM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.