driver seat adjustment NISSAN MURANO 2014 2.G Quick Reference Guide
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2014, Model line: MURANO, Model: NISSAN MURANO 2014 2.GPages: 28, PDF Size: 1.54 MB
Page 11 of 28
9
AUTOMATIC DRIVE POSITIONER (if so equipped)
Two positions for the driver’s seat and outside
mirrors can be stored in the automatic drive
positioner memory.
Follow these procedures to set the memory positions:
• Confirm the shift lever is in the P (PARK) position.
• Push the ignition switch to the ON position.
• Adjust the driver’s seat and outside mirrors to the desired positions using the adjusting
switches for each feature.
• Push the SET switch and within 5 seconds push the memory switch (1 or 2) for at
least 1 second.
• The indicator light on the memory switch you select will illuminate for approximately
5 seconds.
• The driver’s seat and outside mirror positions are now set to your preference.
These memorized positions can also be linked to your NISSAN Intelligent Key®.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
FRONT SEAT ADJUSTMENTS
MANUAL SEATS (Passenger’s side only)
To slide the seat forward or backward, pull up on
the lever 01 under the front of the seat and slide
forward or backward. Release the lever to lock the
seat in position.
To adjust your seatback forward or backward, lift the
lever 02 on the side of the seat.
Release the lever when you have found a comfortable
angle and the seat belt fits properly.
POWER SEATS (Driver’s side only)
To slide the seat forward or backward, push the control switch
03
forward or backward.
To recline the seatback, push the switch
04 forward or backward.
SEAT LIFTER
To adjust the angle of the front seat cushion or
height of the seat, push the front or rear end of the
switch
03 up or down.
LUMBAR SUPPORT
To adjust the seat lumbar support, push the front or back end of the switch
05.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)”\
of your
Owner’s Manual.
01
02
030405
1591421_14d_Murano_QRG_012714b.indd 91/27/14 3:11 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
Page 12 of 28
10
FIRST DRIVE FEATURES
REAR SEAT ADJUSTMENTS (Hardtop models)
FOLDING DOWN THE REAR SEAT
To fold the seats flat, release the connector tongue of
the rear center seat belt from the buckle, then store
the connector and seat belt tongues in the retractor
base on the ceiling
01.
Fold the seatback forward using either the pull strap
02, located on the outside edge of the rear seat, or
the release lever
03 in the cargo area.
To raise the seatback manually, lift up each seatback
and push it to the upright position until it is latched.
To raise the seatback automatically (if so equipped),
push and hold the power seatback switch
located in
the cargo area
04 or the corresponding seat switch
on the lower side of the instrument panel 05.
– A beep sounds once and the seatback begins to
move automatically.
– A beep sounds twice when the seatback is fully
returned to the upright seating position.
RECLINING THE REAR SEATS
Brace the back of the seat with your arm while
pulling on the strap. The seatback will release quickly.
Pull the reclining strap 02, and move the seatback to the desired angle.
Release the reclining strap after positioning the seat at the desired an\
gle.
For more information, refer to the “Safety – Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
04
02
01
03
05
REAR SEAT ENTRY/EXIT (CrossCabriolet models)
DRIVER’S SIDE
Pulling the strap behind the driver’s seat does not
slide the driver’s seat forward. You cannot slide the
driver’s seat manually.
To enter the rear seat, push and hold the front end of
the slide switch
01 to slide the driver’s seat forward.
Then push and hold the front end of the reclining
switch
02 until the desired angle is obtained.
To exit the rear seat from the driver’s side, pull the
strap
03 behind the driver’s seat to release the
driver’s seatback. The driver’s seatback will tilt
forward so that you can exit the vehicle.
01
02
03
1591421_14d_Murano_QRG_012714b.indd 101/27/14 3:11 PM
To view detailed instructional videos regarding features in this Quick Reference Guide, please go to www.nissanownersinfo.mobi.