spare tire location NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual PATHFINDER 2006 R51 / 3.G NISSAN NISSAN https://www.carmanualsonline.info/img/5/710/w960_710-0.png NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual

Page 93 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual For additional information, see “Tire pressure
monitoring system” in the “Starting and driving”
section.
WARNING
cIf the light does not illuminate with the
ignition switch turned ON, have the

Page 214 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual cTire pressure rises and falls depending on
the heat caused by the vehicle’s operation
and the outside temperature. Low outside
temperature can lower the temperature of
the air inside the tire which

Page 240 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual If the light comes on during the self-test or while
driving, take the vehicle to a NISSAN dealer for
repair.
WARNING
cThe anti-lock brake system is a sophis-
ticated device, but it cannot prevent ac-

Page 244 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual 3. Tire chains may be used.
Use of tire chains may be prohibited accord-
ing to location. Check the local laws before
installing tire chains. When installing tire
chains, make sure they are the proper

Page 249 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual WARNING
cIf the low tire pressure warning light
illuminates while driving, avoid sudden
steering maneuvers or abrupt braking,
reduce vehicle speed, pull off the road
to a safe location and stop the ve

Page 304 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual Wheel nut tightening torque:
98 ft-lb (133 N·m)
The wheel nuts must be kept tight-
ened to specifications at all times. It
is recommended that wheel nuts be
tightened to specification at each
tire ro

Page 318 of 344

NISSAN PATHFINDER 2006 R51 / 3.G Owners Manual Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Ins