ABS NISSAN PICK-UP 2003 Repair Manual

Function and System Application
Diagnostic test
modeFunction ENGINE A/T ABS AIR BAG
Work supportThis mode enables a technician to
adjust some devices faster and more
accurate by following the indications
on CONSULT-II.xxÐÐ
Self-diagnostic
resultsSelf-diagnostic results can be read
and erased quickly.xxxx
Trouble diagnos-
tic recordCurrent self-diagnostic results and all
trouble diagnostic records previously
stored can be read.ÐÐÐ x
ECU discrimi-
nated No.Classification number of a replace-
ment ECU can be read to prevent an
incorrect ECU from being installed.ÐÐÐ x
Data monitorInput/Output data in the ECU (ECM)
can be read.xxxÐ
DTC work sup-
portThis mode enables a technician to
set operating conditions to confirm
self-diagnosis status/results.ÐxÐÐ
Active testDiagnostic Test Mode in which CON-
SULT-II drives some actuators apart
from the ECMs and also shifts some
parameters in a specified range.xÐxÐ
ECU (ECM) part
numberECU (ECM) part number can be
read.xxxÐ
Function testConducted by CONSULT-II instead
of a technician to determine whether
each system is ªOKº or ªNGº (No
Good).xxxx
x: Applicable
Nickel Metal Hydride Battery Replacement
CONSULT-II contains a nickel metal hydride battery. When replacing the battery obey the following:
WARNING:
Replace the nickel metal hydride battery with Genuine CONSULT-II battery only. Use of another bat-
tery may present a risk of fire or explosion. The battery may present a fire or chemical burn hazard
if mistreated. Do not recharge, disassemble of dispose of in fire.
Keep the battery out of reach of children and discard used battery conforming to the local regula-
tions.
CONSULT-II CHECKING SYSTEM
GI-4002

Propeller Shaft
2WD models (For Europe)
Applied modelKA24DE YD25DDTi
Single cab, King cab
Without ABS With ABS 4WD appearance
Without ABS With ABS
Propeller shaft model 3S71H 3S80B
Number of joints3
Coupling type with transmission Sleeve type
Type of journal bearing Solid type (disassembly type)
Shaft length (Spider to spider)
mm (in) 1st 641 (25.24) 642 (25.28) 667 (26.26)
2nd 1,004 (39.53) 978 (38.50) 1,005 (39.57) 979 (38.54)984 (38.74)*1
964 (37.95)*2
Shaft outer diameter
mm (in) 1st 75 (2.95) 65 (2.56)
2nd 65 (2.56) 65 (2.56)
4WD models
Location Front Rear
Applied model KA24DE YD25DDTi KA24DE YD25DDTi
Propeller shaft model 2F63H 2F71H 3S71H 3S80B
Number of joints 2 3
Coupling type with transmis-
sionFlange type Sleeve type
Type of journal bearing Solid type (disassembly type) Solid type (disassembly type)
Shaft length (Spider to spider)
mm (in) 1st 546 (21.50) 565 (22.24) 392 (15.43)372 (14.65)*1
377 (14.84)*2
2nd Ð Ð 870 (34.25)872 (34.33)*1
847 (33.35)*2
Shaft outer diameter
mm (in) 1st 50.8 (2.000) 75 (2.95) 65 (2.56)
2nd Ð 65 (2.56) 65 (2.56)
*1: With C200 final drive
*2: With H233B final drive
SERVICE DATA AND SPECIFICATIONS (SDS)
PD-4002