ignition NISSAN ROGUE SELECT 2014 2.G Quick Reference Guide
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2014, Model line: ROGUE SELECT, Model: NISSAN ROGUE SELECT 2014 2.GPages: 20, PDF Size: 1.1 MB
Page 6 of 20

4
TowiNG Your  veHiC le
    ALL-W HEEL d RIVE ( AW d)  V EHICLE (if so equipped)
  •
		
An
 	 all-wheel 	 drive 	 vehicle 	 must 	 be 	 towed 	 with 	 all 	 wheels 	 off 	 the 	 ground.
    For proper towing and to avoid accidental damage to your vehicle, NISSAN recommends that a service operator tow your vehicle after carefully reading the Own\
er’s Manual precautions.
For more information, refer to the “in case of emergency (section 6)” of your Owner’s Manual.
ouTSiDe  T eM P eraT ure  DiS P laY
    When the ignition switch is in the o N position, the 
outside air temperature will appear in the vehicle 
information display  
01.
    If the outside air temperature is below 25°F (-4°C), the  
outside temperature display will blink for 20 seconds 
then remain on when the ignition is switched on.
    If the outside air temperature is between 2 7°F and 
37°F (-3°C and +3°C), the outside temperature display will bli\
nk continuously with the 
ignition switch in the 
o N position.
    To stop the outside temperature display from blinking, stop the vehicle i\
n a safe place and 
move the shift lever to the P (P
ar
 k ) position. Perform the following procedure:
 
 
1.
  
Press the control c
 hange button 
02 until the Settings mode is displayed. 
 2.
 T
urn the control button until it reaches the  alarms  mode then press to select.
 
 
3.
 
T
urn the control button until it reaches the  o utside temp mode then press to select.
 
 
4.
 
T
urn the control button until it reaches the  o ff mode then press to select.
 
 
5.
 
T
o exit, press the control button again.
LOW OUTSI
d
E
 TEMPERATURE WARNING
     The l ow outside temperature warning message will appear in the vehicle information 
display 
03  when the outside temperature drops below 37°F (+3°C) with the ignition switch 
in the 
o
N position.
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
01
03
02
esse ntial i n for mation
1512586_14_RogueSelect_QRG_111313.indd   411/13/13   9:04 AM
To view detailed instructional videos regarding these and other features, please go\
 to www.nissanownersinfo.mobi.  
Page 10 of 20

8
first drive features
HeaDliGHT C o NT rol
HEAdLIGHT CONTROL SWITCH
    Turn the headlight control switch to the
   
position  01 to turn on the front parking, side  
marker, tail, license plate and instrument panel lights.  
Turn the switch to the  
 position
 02 to turn on  
the headlights.
AUTOLIGHT SYSTEM (if so equipped)
    The autolight system will automatically turn the headlights on when it is\
 dark and off when it is   
light. The system will keep the headlights on for a period of time after you tur\
n the ignition off   
and all doors are closed.
    To activate the autolight system, turn the headlight control switch to the  auTo position
 03  
then turn the ignition switch to 
o
N. To deactivate the autolight system, turn the headlight   
control switch to the 
o
FF,  
 position 01 or
  position
 02. 
HIGH BEAM SELECT
    Push the headlight control switc h forward
 04 to 
 
select the high beam function. The blue indicator   
light 
 illuminates in the instrument panel. Pull the   
headlight switch back to the original position to select   
the low beam. The blue indicator light extinguishes.
    Pull and release the headlight control switc h
 05 to 
 
flash the headlight high beams on and off.
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
04
05
01
03
02
STar T iNG/STo PP iN G THe   eN GiNe
   depress the brake pedal.
    Move the shift lever to the P (Par k ) position or  
N (N
e
 u T ral ) position.
  Turn the ignition switch to STar T.
TURNING THE ENGINE OFF
    Move the shift lever to the  P (Par k ) position, apply  
the parking brake and turn the ignition switch to the  lo C k  position.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1512586_14_RogueSelect_QRG_111313.indd   811/13/13   9:04 AM
To view detailed instructional videos regarding these and other features, please go\
 to www.nissanownersinfo.mobi.  
Page 15 of 20

13
TriP Co MP u T er
    With the ignition switch in the  o N position, trip  
computer  
01 modes can be selected by pressing the   
control change button  
02 on the instrument panel.
    The following modes can be selected in the display:
	 	 • 		
F
 uel  e conomy – displays the current and average   
fuel consumption.
	 	 •
		a
verage Speed
 – displays the average vehicle  
speed since the last reset.
	 	 •
		
Driving Distance
  – displays the distance driven since the last reset.
	 	 •
		e
lapsed Time – displays the time since the last reset.
	 	 •
		r
ange (dte)– displays the estimated distance to empty (dte) the vehicle can be driven  
before refueling.
	 	 •
		
Settings
  – allows you to set the clock, preferences for alerts, maintenance intervals or   
language displays. Turn the control change button 
02 to select or adjust menu items   
and press the button to set.
    To reset Fuel Economy, Average Speed,  d riving  d istance and Elapsed Time press the control 
change button 
02 for more than 3 seconds. 
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
02
01
Blue TooTH® HaNDS-Free PHo Ne  SYST eM (if so equipped)
    A cellular telephone should not be used while driving  
so full attention may be given to vehicle operation. *
SYSTEM OPERATING TIPS
    Press  the  button to interrupt the voice prompts 
at any time and speak a command after the tone. 
    To use the system faster, you may speak the second   level commands with the main menu command on  
the main menu. For example, press the 
 button  
and after the tone say, “Call Redial”. 
    The “Help” command can be used to hear a list of   
available commands at any time.
    Reduce bac kground noise as much as possible by  
closing windows and pointing HVAC vents away from  
the ceiling.
    Speak naturally without long pauses and without raising   
 your voice.
    When speaking Phonebook names, please be aware  
some phones require the last name to be spoken before   
the first name. For example, “Michael Smith” may be   
spoken as “Smith Michael”.
system guide
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g.
1512586_14_RogueSelect_QRG_111313.indd   1311/13/13   9:04 AM
To view detailed instructional videos regarding these and other features, please go\
 to www.nissanownersinfo.mobi.