alarm NISSAN ROGUE SELECT 2015 2.G Quick Reference Guide

4
TOWING YOUR VEHICLE
ALL-WHEEL DRIVE (AWD) VEHICLE (if so equipped)

An all-wheel drive vehicle must be towed with all wheels off the ground \
even if the
vehicle is placed in the 2WD mode.
For proper towing and to avoid accidental damage to your vehicle, NISSAN recommends
that a service operator tow your vehicle after carefully reading the Own\
er’s Manual precautions.
For more information, refer to the “In case of emergency (section 6)” of your Owner’s Manual.
OUTSIDE TEMPERATURE DISPLAY
When the ignition switch is in the ON position, the
outside air temperature will appear in the vehicle
information display
1.

If the outside air temperature is below 25°F (-4°C),
the outside temperature display will blink for 20
seconds then remain on when the ignition is
switched on.

If the outside air temperature is between 27°F and 37°F (-3°C and +3°C), the outside
temperature display will blink continuously with the ignition switch in the ON position.

To stop the outside temperature display from blinking, stop the vehicle i\
n a safe place
and move the shift lever to the P (PARK) position. Perform the following procedure:
1. Press the
switch
2 until the Settings mode is displayed.
2. Turn the switch 2 until it reaches the Alarms mode then press to select.
3. Turn the switch until it reaches the Outside temp mode then press to select.
4. Turn the
switch until it reaches the Off mode then press to select.
5. To exit, press the
switch again.
LOW OUTSIDE TEMPERATURE WARNING

The Low outside temperature warning message will appear in the vehicle information
display
3 when the outside temperature drops below 37°F (+3°C) with the ignition
switch in the ON position.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
1
3
2
ESSE NTIAL I N FOR MATION
1706218_15a_Rogue_Select_QRG_111814.indd 411/18/14 2:44 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

6
LIFTGATE RELEASE
To open the liftgate, unlock the liftgate using one
of the following methods:
• Press the
button 1 on the key fob twice.
• Push the power door lock switch to the
unlock position.
• Insert the key into the driver’s door key cylinder
and turn it toward the rear of the vehicle twice.

Then push the liftgate release switch 2 just
above the license plate and pull the liftgate up.
For more information, refer to the “Pre-driving checks and
adjustments (section 3)” of your Owner’s Manual.
1
REMOTE KEYLESS ENTRY SYSTEM
To lock the vehicle, press the button 1 on
the key fob.

To unlock the vehicle, perform the
following procedures:
• Press the

button 2 on the key fob to unlock

the driver’s side door.
• Press the
button 2 again within 5 seconds;
all other doors and the liftgate will unlock.

The key fob can also be used to activate the panic
alarm by pressing and holding the
button 3

for more than 1 second. Once activated, the
panic alarm and headlights will stay on for a
period of time.
For more information, refer to the “Pre-driving checks and
adjustments (section 3)” of your Owner’s Manual.
1
3
2
FIRST DRIVE FEATURES
2
1706218_15a_Rogue_Select_QRG_111814.indd 611/18/14 2:44 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.