Condition NISSAN TERRANO 2002 Service Repair Manual

Trouble Diagnoses
Before conducting an alternator test, make sure that the battery is fully charged. A 30-volt voltmeter and suit-
able test probes are necessary for the test. The alternator can be checked easily by referring to the Inspec-
tion Table.
IBefore starting, inspect the fusible link.
IUse fully charged battery.
WITH IC REGULATOR
NOTE:
IIf the inspection result is OK even though the charging system is malfunctioning, check the B terminal
connection. (Check the tightening torque.)
IWhen field circuit is open, check condition of rotor coil, rotor slip ring and brush. If necessary, replace faulty
parts with new ones.
MALFUNCTION INDICATOR
The IC regulator warning function activates to illuminate ªCHARGEº warning lamp, if any of the following
symptoms occur while alternator is operating:
IExcessive voltage is produced.
INo voltage is produced.
SEL338V
CHARGING SYSTEM
SC-26

Inspection
BALL JOINT AND SWIVEL JOINT
1. Check joints for play. If ball or swivel stud is worn and play in
axial direction is excessive or joint is hard to swing or does not
meet the specified values, replace as a complete unit.
Swinging force (Measuring point: Cotter pin hole) ªAº:
The ball joint must rotate smoothly in all direc-
tions.
Rotating torque ªBº: (both)
0.5 - 5.0 N×m (0.05 - 0.51 kg-m,4-44in-lb)
Axial end play ªCº: (both)
0 - 0.2 mm (0 - 0.008 in)
Radial play ªDº (both)
0mm(0in)
2. Check condition of dust cover. If it is cracked excessively,
replace ball joint or swivel joint as an assembly.
ICheck rotating torque ªBº.
EST015
EST016
YST025
STEERING LINKAGE
ST-20

Installation
Install a new oil seal, using a suitable tool.
Rear Case
REAR OIL SEAL
Removal
Remove the oil seal. Be careful not to damage its housing. Always
replace after every disassembly.
Installation
Install a new oil seal, using the Special Tool.
AIR BREATHER
Install as shown in the illustration.
Shift Control Components
INSPECTION
ICheck contact surface and sliding surface for wear, scratches,
projections or other faulty conditions.
SMT315A
YMT025
YMT026
SMT318A
SMT360A
REPAIR FOR COMPONENT PARTS
Bearing Retainer (Cont'd)
TF-24