parking brake NISSAN VERSA SEDAN 2014 2.G Quick Reference Guide

3
esse Ntial i Nfor matio N
looSe Fuel C aP
A looS e Fuel CaP warning message will display
in the odometer 01 when the fuel-filler cap is not
tightened correctly.

To tighten, turn the cap clockwise until a single click
is heard.

The warning message will disappear when the vehicle detects the fuel-filler cap is properly
tightened and the reset button
02 is pressed for more than 1 second.

If the cap is not fully tightened, the Malfunction Indicator light
may also illuminate.
For more information, refer to the “instruments and controls (section 2)” and the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
01
02
Tire Pre
SSure M oNiTori NG SYSTe M (TPMS) wiTh
eaSY Fill Tire alerT (if so equipped)
A Che CK Tire P reS warning message will
appear in the trip computer 01 and the low tire

pressure warning light 02 will illuminate when one

or more tires are low on pressure and air is needed.
• The tire pressures should be checked when the
tires are cold. The tires are considered cold after the
vehicle has been parked for 3 hours or more or driven
less than 1 mi (1.6 km) at moderate speeds.

After tire pressures are adjusted, drive the vehicle at speeds above 16 \
MPH (25 km/h). The
Che CK Tire Pre S warning message and low tire pressure warning light will disappear.

When adding air to an under-inflated tire, the TPMS with Easy Fill Tire Alert (if so equipped) provides
visual and audible signals to help you inflate the tires to the recomm\
ended c OLD tire pressure.
To use the Easy Fill Tire Alert (if so equipped):
1. Move the shift lever to the P (P arK) position and apply the parking brake.
2. Place the ignition switch in the oN position. Do not start the engine.
3. Add air to the under-inflated tire and within a few seconds, the hazar\
d warning lights will
start flashing.
4. When the designated tire pressure is reached, the horn will beep once and the hazard
warning flashers will stop flashing.
5. Repeat this procedure for any additional under-inflated tires.

When the low tire pressure warning light flashes for 1 minute and then \
remains on, the TPMS
is not functioning properly. Have the system checked by a NISSAN dealer.

Tire pressure rises and falls depending on the heat caused by the vehicle\
’s operation and the
outside temperature. Low outside temperature can lower the temperature o\
f the air inside
the tire, which can cause a lower tire inflation pressure. This may cause the low tire pressure
warning light to illuminate. If the warning light illuminates, check the tire pressure in your tires.
• Check the tire pressure (including the spare tire) often and always prior to long distance trips.

The Tire and Loading Information label contains valuable information. Please refer to section 9,
“Technical and consumer information”, in your Owner’s Manual for the location of the Tire and
Loading Information label.
For more information, refer to the “instruments and controls (section 2)” , the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
01
02
1598305_14c_Versa_Sedan_QRG_091013.indd 39/10/13 12:18 PM
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi

7
heaDliGhT CoNTrol SwiTCh
HEADLIGHT c ONTROL

Turn the headlight control switch to the
position
01 to turn on the front parking, tail, license plate and
instrument panel lights. Turn the switch to the
position 02 to turn on the headlights.
01
02
ST
arTi NG/ST oPPiNG The e NGiN e
STARTING THE ENGINE

It is important to make sure the Intelligent k ey is
with you (that is, in your pocket or purse).
cONTINUOUSLY VARIABLE TRANSMISSION
(NISSAN Intelligent k ey
® models only - if so equipped)

Depress the brake pedal.
• If the brake pedal is not depressed, pushing the
ignition switch once enters the A cc mode.
• If the ignition is pushed a second time, the vehicle
will enter the ON mode.

Move the shift lever to P (P arK).

Push the ignition switch to start or stop the engine.
AUTOMATI c/MANUAL TRANSMISSION (if so equipped)

Depress the brake pedal.

Move the shift lever to N (N euTral)
(manual transmission only).

Depress the clutch (manual transmission only) pedal
to the floor.

Turn the ignition switch to ST arT.
TURNING THE ENGINE OFF

For a continuously Variable Transmission (NISSAN Intelligent k ey® models only - if so
equipped), apply the brake pedal, move the shift lever to the P (P arK) position, apply the
parking brake and push the ignition ST arT/SToP switch to turn the engine off.

For a manual transmission, apply the brake pedal, place the vehicle in 1s\
t gear, apply the
parking brake and turn the ignition switch to the loCK position.

For automatic transmission, apply brake pedal, move shift lever to P (P arK) position, apply
the parking brake, and turn the ignition switch to the loCK position.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1598305_14c_Versa_Sedan_QRG_091013.indd 79/10/13 12:18 PM
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi