parking brake NISSAN VERSA SEDAN 2017 2.G Quick Reference Guide

4
ESSENTIAL INFORMATION
TIRE PRESSURE MONITORING SYSTEM (TPMS)
WITH EASY-FILL TIRE ALERT (if so equipped)
A CHECK TIRE PRES warning message will appear in the trip computer 1
and the low tire pressure warning light
2 will illuminate when one or more
tires are low in pressure and air is needed.



• The tir

e pressures should be checked
when the tires are cold. The tires are
considered cold af ter the vehicle has been
parked for 3 hours or more or driven less
than 1 mi (1.6 km) at moderate speeds.
Af ter the tire pressures are adjusted, drive the vehicle at speeds above 16 mph
(25 km/h). The CHECK TIRE PRES warning
message and low tire pressure warning light
2 will extinguish.
When adding air to an under -inflated tire, the TPMS with Easy-Fill Tire Alert
(if so equipped) provides visual and audible signals to help you inflate the
tire to the recommended COLD tire pressure.



T
o use the Easy-Fill Tire Alert (if so equipped):



1.

Mo
ve the shif t lever to the P (PARK) position and apply the parking brake.



2. Plac
e the ignition switch in the ON position. Do not start the engine.



3.

A
dd air to the under-inflated tire, and within a few seconds, the hazard
warning lights will start flashing.



4.

When the designated tir
e pressure is reached, the horn will beep once
and the hazard warning flashers will stop flashing.



5
.
R
epeat this procedure for any additional under-inflated tires.
When the lo w tire pressure warning light 2 flashes for 1 minute and then
remains on, the TPMS is not functioning properly. Have the system checked.
It is recommended you visit a Nissan dealer for this service.
Tire pressure rises and falls depending on the heat caused by the vehicle’s operation and the outside temperature. Low outside temperature can
lower the temperature of the air inside the tire, which can cause a lower tire
inflation pressure. This may cause the low tire pressure warning light
2 to
illuminate. If the warning light illuminates, check the tire pressure in your tires.



•


Check the tir

e pressure (including the spare tire) of ten and always prior to
long distance trips.
The Tire and Loading Information label contains valuable information. Please refer to the “Technical and consumer information (section 10)” of your
Owner’s Manual for the location of the Tire and Loading Information label.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving
(section 5)” and the “Do-it-yourself (section 8)” of your Owner’s Manual.
1
2
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

10
STARTING/STOPPING THE ENGINE
STARTING THE ENGINE
It is important to make sure the Intelligent
Key is with you (that is, in your pocket
or purse).
CONTINUOUSLY VARIABLE TRANSMISSION
(Nissan Intelligent Key® models only –
if so equipped)
Depress the brake pedal.



•

If the br
ake pedal is not depressed,
pushing the ignition switch once enters the ACC mode.



•

If the ignition switch is pushed a sec
ond time, the vehicle will enter the
ON mode.
Move the shif t lever to the P (PARK) position.
Press the ignition switch START/STOP button to start or stop the engine.
CONTINUOUSLY VARIABLE
TRANSMISSION/AUTOMATIC/MANUAL
TRANSMISSION (if so equipped)
Depress the brake pedal.
Move the shif t lever to the N (NEUTRAL) position (automatic transmission only).
Depress the clutch pedal to the floor (manual transmission only).
Turn the ignition switch to the S TA R T position.
TURNING THE ENGINE OFF
For a Continuously Variable Transmission (Nissan Intelligent Key® models only – if so equipped), apply the brake pedal, move the shif t lever to the
P (PARK) position, apply the parking brake and press the ignition switch
START/STOP button to turn the engine off.
For a manual transmission, apply the brake pedal, place the vehicle in 1 (FIRST) gear, apply the parking brake and turn the ignition switch to the
LOCK position.
For the automatic transmission and Continuously Variable Transmission, apply the brake pedal, move the shif t lever to the P (PARK) position, apply
the parking brake and turn the ignition switch to the LOCK position.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
FIRST DRIVE FEATURES
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.