OBD port NISSAN X-TRAIL 2005 Service Repair Manual

REMOVAL AND INSTALLATION
AT-413
[ALL]
D
E
F
G
H
I
J
K
L
MA
B
AT

REMOVAL AND INSTALLATIONPFP:00000
RemovalECS004NC
COMPONENTS
CAUTION:
Before separating transaxle from engine, remove the crankshaft position sensor (Euro-OBD) from
transaxle. Be careful not to damage sensor.
1. Remove battery and bracket, air cleaner and air duct.
2. Remove air breather hose.
3. Disconnect terminal cord assembly harness connector, PNP switch harness connector and revolution
sensor harness connector.
4. Remove crankshaft position sensor (Euro-OBD) from transaxle.
5. Disconnect control cable from transaxle.
6. Remove front exhaust tube. Refer to EX-2, "
Removal and Installation"
7. Disconnect A/T fluid cooler hoses.
8. Remove drive shafts. Refer to FAX-11, "
FRONT DRIVE SHAFT" , RAX-14, "REAR DRIVE SHAFT" .
9. Remove transfer assembly. Refer to TF-57, "
Removal and Installation" .
10. Remove starter motor from transaxle. Refer to SC-27, "
Removal and Installation" .
11. Support transaxle with a transmission jack.
1. Transfer assembly 2. A/T fluid level gauge 3. A/T fluid charging pipe
4. O-ring 5. Center member 6. Front engine mounting insulator
7. Grommet 8. Fluid cooler tube 9. Fluid cooler tube
10. Copper washer 11. Copper washer 12. Transaxle assembly
13. Stopper 14. LH engine mounting insulator
SCIA6893E

HARNESS CONNECTOR
PG-75
C
D
E
F
G
H
I
J
L
MA
B
PG

HARNESS CONNECTOR (SLIDE-LOCKING TYPE)

A new style slide-locking type connector is used on certain systems and components, especially those
related to OBD.

The slide-locking type connectors help prevent incomplete locking and accidental looseness or discon-
nection.

The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure
below.
CAUTION:

Do not pull the harness or wires when disconnecting the connector.

Be careful not to damage the connector support bracket when disconnecting the connector.
[Example]
SEL769V

IDX-4
ALPHABETICAL INDEX
EM-73
Cylinder head bolt tightening(YD22DDTi) ....... EM-211
Cylinder head gasket selection(YD22DDTi) ... EM-212
Cylinder head(QR20DE-QR25DE) ................... EM-70
Cylinder head(YD22DDTi) .............................. EM-209
D
Data link connector ............................ EC-518
, EC-958
Data link connector for Consult ......... EC-105, EC-606,
EC-1034
, EC-1405
DEF - Wiring diagram ....................................... GW-21
Desiccant Assembly ...................................... ATC-156
Diagnosis sensor unit ..................................... SRS-41
Diagnostic trouble code (DTC) ...................... EC-1372
Diagnostic trouble code (DTC) for OBD system EC-19,
EC-55
, EC-533, EC-565, EC-973, EC-998, EC-1351
Diagnostic trouble code (DTC) inspection priority chart
EC-77
, EC-576, EC-1010, EC-1381
Differential gear (FF M/T) ..................... MT-26, MT-44
DLC - Wiring diagram ........................ EC-518, EC-958
Door glass ........................................... GW-80, GW-83
Door glass Fitting Adjustment ............. GW-80, GW-83
Door lock ................................................. BL-91, BL-95
Door mirror ........................................................ GW-86
Door trim ............................................................. EI-32
Door, front .......................................................... BL-18
Door, rear ........................................................... BL-18
Drive belt inspection(QR20DE-QR25DE) ......... MA-20
Drive belt inspection(YD22DDTi) ...................... MA-29
Drive belt(QR20DE-QR25DE) .......................... EM-13
Drive belt(YD22DDTi) ..................................... EM-140
Drive shaft (front) ............................................. FAX-11
Drive shaft (rear) ............................................. RAX-14
Driver air bag .................................................. SRS-30
Dropping resistor (A/T) ...................... AT-160, AT-393
DTC work support ............................................ EC-112
Dual pressure switch ........ ATC-18, ATC-95, ATC-158
Duct and grilles ............................... ATC-137, MTC-33
E
ECM input/output signal ....................... EC-95
, EC-595
ECM power supply EC-125, EC-286, EC-625, EC-719
ECM/PW - Wiring diagram ................. EC-287, EC-720
ECTS - Wiring diagram .... EC-167, EC-654, EC-1095,
EC-1451
EGR function ................ EC-1186, EC-1193, EC-1651
EGR volume control valve ............ EC-1186, EC-1193,
EC-1651
EGRC/V - Wiring diagram ............. EC-1188, EC-1195,
EC-1653
Electric sunroof .................................................. RF-10
Electric throttle control actuator ........ EC-294, EC-296,
EC-314
, EC-723, EC-726, EC-745
Electrical load signal circuit ................ EC-480, EC-920
Electrical unit ..................................................... PG-76
Electrical units location ...................................... PG-69
Electronic ignition (EI) system ............. EC-37, EC-550
Engine control circuit diagram ........... EC-93, EC-593,
EC-1025
, EC-1396
Engine control component parts location .......... EC-88,
EC-588
Engine control module (ECM) .......... EC-283, EC-716,
EC-1227
, EC-1229, EC-1566, EC-1568
Engine control system diagram and chart ........ EC-30,
EC-543
, EC-984, EC-1360
Engine coolant temperature sensor (ECTS) ... EC-165,
EC-652
, EC-1093, EC-1449
Engine coolant(QR20DE-QR25DE) .................... CO-9
Engine coolant(YD22DDTi) .............................. CO-32
Engine fail-safe system ....................... EC-78, EC-577
Engine oil filter replacement(QR20DE-QR25DE) .........
MA-25
Engine oil filter replacement(YD22DDTi) MA-36, MA-37
Engine oil precautions .......................................... GI-7
Engine oil replacement(QR20DE-QR25DE) ..... MA-24
Engine oil replacement(YD22DDTi) .................. MA-35
Engine oil(QR20DE-QR25DE) ............................. LU-7
Engine oil(YD22DDTi) ....................................... LU-20
Engine removal(QR20DE-QR25DE) ................. EM-81
Engine removal(YD22DDTi) ........................... EM-222
ETC1 - Wiring diagram ..................... EC-297, EC-728
ETC2 - Wiring diagram ..................... EC-308, EC-739
ETC3 - Wiring diagram ..................... EC-315, EC-746
EVAP canister purge volume control solenoid valve ....
EC-269
, EC-522, EC-884, EC-962
EVAP vapor lines inspection(QR20DE-QR25DE) ........
MA-28
Evaporative emission (EVAP) system EC-522, EC-962
Evaporator .................................................... ATC-158
Exhaust manifold(QR20DE-QR25DE) .............. EM-25
Exhaust manifold(YD22DDTi) ......................... EM-151
Exhaust system ................................................... EX-2
Exhaust system inspection ..................... EX-2, MA-39
Expansion valve ............................................ ATC-159
Exterior EI-21, EI-22, EI-24, EI-25, EI-26, EI-27, EI-28,
EI-30
, EI-31
F
F/FOG - Wiring diagram ..................... LT-108
, LT-109
F/PUMP - Wiring diagram EC-467, EC-907, EC-1270,
EC-1609
Fan control amp. ............................. ATC-84, ATC-129
Fan switch ....................................................... MTC-18
FIAR - Wiring diagram .................. EC-1253, EC-1592
Final drive (FF M/T) .............................. MT-26, MT-44
Finisher, interior - See Trim ................................ EI-32
Finisher, rear panel ............................................. EI-31
Floor trim ............................................................. EI-38
Flow charts ......................................................... GI-23
Fluid temperature sensor (A/T) ........................ AT-111
Fluorescent leak detector ............................. ATC-160
Flywheel (clutch) ................................................ CL-16
Flywheel runout(QR20DE-QR25DE) .............. EM-116
Flywheel runout(YD22DDTi) ........................... EM-255
Fog lamp, front ................................................. LT-108