bulb Oldsmobile Achieva 1997 Owner's Manuals

Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions
allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the
turn is finished, the lever will return automatically.
An arrow on the instrument
panel will flash in the
direction of the
turn or
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold
it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change,
if the arrows flash
rapidly, a signal bulb may be burned out and other
drivers won’t see your
turn signal. If a signal bulb is
burned out, replace
it to help avoid an accident. (See
“Bulb Replacement”
in the Index).
If the arrows don’t go on at all when you signal a turn, check
the fuse
(see “Fuses and Circuit Breakers” in the Index) or
contact your Oldsmobile retailer service department).
Turn Signal On Chime
A warning chime signal will come on if you have left
your turn signal on for more than
3/4 mile ( 1 km).
2-36

Oil Pressure Warning Light
This light tells you if there
could be a problem with
your engine oil pressure.
This light can come on briefly, which is normal and
doesn’t show a problem:
0 As a bulb check, the light comes on when you turn
your key
to RUN and goes off when the engine is
started. If it doesn’t, be sure to have it fixed so it will
be there
to warn you.
For the four cylinder engine, when idling at a stop
sign, the light may blink on and then off. In addition,
if you make
a hard stop, the light may come on for
a moment.
But, when this light comes on and stays on, it means oil
isn’t going through your engine properly.
You could be
low on oil, or you might have some other oil problem.
Don’t keep driving
if the oil pressure is low. If
you do, your engine can become so hot that it
catches fire.
You or others could be burned.
Check your oil
as soon as possible and have your
vehicle serviced.
NOTICE:
Damage to your engine from neglected oil
problems can be costly and
is not covered by
your warranty.

Backing Up
Hold the bottom of the steering wheel with one hand.
Then, to move the trailer
to the left, just move that hand
to the left.
To move the trailer to the right, move your
hand to the right. Always back up slowly and, if
possible, have someone guide you.
Making Turns
NOTICE:
Making very sharp turns while trailering could
cause the trailer to
come in contact with the
vehicle. Your vehicle could be damaged. Avoid
making very sharp turns while trailering.
When you’re turning with a trailer, make wider turns than
normal.
Do this so your trailer won’t strike soft shoulders,
curbs, road signs, trees or other objects. Avoid jerky or
sudden maneuvers. Signal well in advance.
Turn Signals When Towing a Trailer
The green arrows on your instrument panel will flash
whenever you signal a turn or lane change. Properly
hooked up, the trailer lamps will also flash, telling other
drivers you’re about to turn, change lanes or stop.
When towing a trailer, the green arrows on your
instrument panel will flash for turns even
if the bulbs on
the trailer are burned out. Thus, you may think drivers
behind you are seeing your signal when
they are not. It’s
important to check occasionally to be sure the trailer
bulbs are still working.
Driving On Grades
Reduce speed and shift to a lower gear before you start
down a long or steep downgrade.
If you don’t shift
down, you might have to
use your brakes so much that
they would get hot and no longer work well.
On a long uphill grade, use the highest gear possible.
If you
cannot maintain posted speeds, driving at a lower speed may
help avoid overheating your engine and transaxle.
If you have a manual transaxle with
FIFTH (5) gear,
it’s better not
to use FIFTH (5) gear. Just drive in
FOURTH
(4) gear (or, as you need to, a lower gear).
4-40

Section 6 Service and Appearance Care
Here you will find information about the care of your Oldsmobile. This section begins with service and fuel
information, and then it shows how to check important fluid and lubricant levels. There is also technical information
about your vehicle, and a part devoted
to its appearance care.
6-3
6-4
6-5
6-8
6- 12
6-18 6-
19
6-22
6-23
6-24
6-28
6-28
6-28 6-29
6-30
6-35
6-35 Fuel
Fuels
in Foreign Countries
Filling Your Tank
Checking Things Under the
Hood
Engine Oil
Air Cleaner
Automatic Transaxle Fluid
Manual Transaxle Fluid
Hydraulic Clutch
Engine Coolant Surge Tank Pressure Cap
Thermostat
Power Steering Fluid
Windshield Washer Fluid
Brakes
Battery Bulb Replacement 6-40
6-48
6-49
6-5
1
6-52
6-54
6-55
6-56
6-56
6-6 1
6-62 6-62
6-63
6-63
6-1
Windshield Wiper Blade Replacement
Appearance Care
Cleaning the Inside of Your Oldsmobile
Care of Safety Belts
Cleaning the Outside
of
Your Oldsmobile
Cleaning Tires
Appearance Care Materials Chart
Vehicle Identification Number (VIN)
Electrical System
Replacement Bulbs
Capacities and Specifications
Air Conditioning Refrigerants
Normal Maintenance
Replacement Parts
Dimensions

Battery
Every new Oldsmobile has a Delco Freedom@ battery.
You never have to add water to one of these. When it’s
time for a new battery, we recommend a Delco Freedom
battery. Get one that has the replacement number shown
on the original battery’s label.
Vehicle Storage
If you’re not going to drive your vehicle for 25 days or more,
take
off the black, negative (-) cable from the battery. This
will help keep your battery from running down.
I
A CAUTLN:
Contact your retailer to learn how to prepare your
vehicle for longer storage periods.
Also, for your audio system, see “Theft-Deterrent
Feature” in the Index.
Bulb Replacement
This section describes bulb changing procedures for
some of your interior and exterior lamps. For bulb sizes,
see “Replacement Bulbs” in the Index. For any bulbs not
listed in this section, contact your Pontiac dealer service
department.
Batteries have acid that can burn you and gas
that can explode.
You can be badly hurt if you
aren’t careful. See “Jump Starting”
in the Index
for tips on working around a battery without
getting hurt.
Halogen Bulbs
Halogen bulbs have pressuri,J gas inside and
can burst if
you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions on the bulb package.

,,,adlamp Bulb RepL,.nent
When replacing a halogen bulb, do not touch the glass
portion of the bulb. The oil from your fingers will
shorten the life
of your new halogen bulb. For the type
of bulb to use, see “Replacement Bulbs” in the Index.
1. On the driver’s side only, unscrew the butterfly
fasteners. Then lift the plate.
6-36
Both Sides:
2. Twist the lock ring clockwise one-sixth of a turn and
pull out the bulb assemblv.

3.
4.
r His d Stc L
1. Use a flat screwdriver to gently release
the
trim cover. the tabs on
Unclip the bulb assembly from the wiring harness.
Reverse these steps to replace the bulb assembly and
headlamp housing.
2. Using a flat screwdriver, remove the screws holding
the bulb assembly.

5. Use a flat screwdriver to release the tabs holding the
socket in place.
4. Gently remove and replace the bulbs.
5. Reverse this procedure to reassemble the lamp.
Back-up Lamps
1. Open the trunk lid and locate the back-up lamps on
the inside
of the lid.
2. Gently remove the bulbs from the socket.
3. Replace the bulb in the socket.
4. Close the trunk lid.
Tail/Stop/Turn Signal Lamps
For the type of bulb to use, see “Replacement Bulbs” in
the Index.
1. Pull back the trunk trim.
2. Carefully pull tab A of the plastic taillamp bracket
away from the center of the trunk, then forward.
When the bracket releases from its mount, pull the
taillamp assembly forward.
6-38

omeLa
3. Wiggle the bulb out of the socket.
4. Replace the bulb.
5. Reverse the steps to reassemble the taillamp,
stoplamp
or rear turn signal lamp. To
change your dome lamp bulb, grasp the center rront
and center rear portion
of the housing and squeeze
firmly but gently. The housing should pop
off.
If this doesn’t work, you may need to use a small
flat-head screwdriver under the side
of the housing to
help pry
it off.

Fuse
IGN MOD
HVAC BLO MOT
PCM BATT
CLG FAN
HDLP
STOP
LPS PWR
ACC
RR DEFG
ABS
IGN SW
Usage
Ignition System
Heater/ Air Conditioner-High
Blower, Generator-Voltage
Sense
Powertrain Computer
Engine Cooling Fan
Lighting Circuits
Power Accessory,
Stoplamp Circuits,
Rear Window Defogger
Anti-Lock Brakes,
Variable
Effort Steering
Ignition Switched Circuits
Replacement Bulbs
Outside Lamps Bulb
Headlamp .............................. 9004
Back-up ............................... 2057
High Level Stop
.......................... 912
Tail/Stop/Turn
.......................... 3057
Inside Lamps Bulb
Dome .................................. 562
6-61
- . -