clock OLDSMOBILE AURORA 2002 Owners Manual

2-14
For battery replacement, use a Duracell
battery,
type DL
-2032, or a similar type.
To replace the battery, do the following:
1. Insert a coin, or similar object, into the notch near
the key ring. Turn it counterclockwise to separate the
two halves of the transmitter.
2. Once the transmitter is separated, use a pencil eraser
to remove the old battery. Do not use a metal object.
3. Replace the battery as the instructions under the
cover indicate.
4. Snap the transmitter back together tightly to be sure
no moisture can enter.
5. Check the operation of the transmitter.
ProCarManuals.com

2-23
ACC (Accessory): This position lets you use your
electrical accessories such as power windows, power
sunroof (option), radio and the windshield wipers.
ON: This is the position the switch returns to after
you start your engine and release the switch. This is the
position for normal driving. Even when the engine is not
running, you can use ON to operate your electrical
accessories and to display some instrument panel
warning lights.
START: This position starts your engine. When the
engine starts, release the key. The ignition switch will
return to ON for normal driving.Key Reminder Warning
If you leave your key in the OFF ignition position,
you will hear a warning chime when you open the
driver's door.
Always leave your key in OFF. If you leave it in any
other position, you will drain the battery power.
Retained Accessory Power (RAP)
After you turn the ignition off and remove the key, you
will still have power to accessories such as the power
windows, audio steering wheel controls, clock, sunroof
(option), accessory power outlet and the radio for up to
10 minutes. The instrument panel cluster lights will stay
on for a few seconds, then go out. Once you open a
door, the power will shut off.
ProCarManuals.com

2-47
Interior Lamps
Instrument Panel Brightness Knob
This feature controls the brightness of the instrument
panel lights.
The knob for this feature is
located on the driver's side
of the instrument panel.
Turn the knob clockwise to brighten the instrument
panel cluster lights and displays. Turn the knob
counterclockwise to dim the instrument panel cluster
lights and displays.
If it is day and your parking lamps are on, the instrument
panel cluster lights and displays will come on at full
intensity and will not be adjustable. If it is dark enough
outside and your parking lamps are on, the instrument
panel cluster lights and displays and the backlighting for
the door switches will come on, and can also be adjusted.
Courtesy Lamps
If it is dark enough outside and the front reading lamp
slider lever, located on the overhead console, is in the
AUTO position, when any door is opened all of the
vehicles courtesy lamps will come on. See ªReading
Lampsº in the Index. They make it easier for you to
enter and leave the vehicle. The courtesy lamps will
remain on for about 25 seconds after all doors have
been closed. They will then theater dim to off.
Move the front reading lamp slider lever to ON to turn
on the interior courtesy lamps. When the control is
moved back to either OFF or AUTO, the courtesy
lamps will immediately turn off.
If the control is OFF when the doors are opened, only
the lower instrument panel courtesy lamps will come on.
Also, if the control is OFF when illuminated entry or
delayed exit lighting are active, only the lower
instrument panel courtesy lamps will be on.
If a door is left ajar, your interior lamps will turn
off after 10 minutes to save your battery.
ProCarManuals.com

3-
3-1
Section 3 Comfort Controls and Audio Systems
In this section, you'll find out how to operate the comfort control and audio systems offered with your vehicle.
Be sure to read about the particular systems supplied with your vehicle.
3
-2 Comfort Controls
3
-2 Automatic Electronic Climate Control
3
-5 Passenger Temperature Control (Option)
3
-6 Comfort Controls Personalization
(If Equipped)
3
-6 Air Conditioning
3
-7 Heating
3
-7 Defogging and Defrosting
3
-8 Rear Window Defogger
3
-8 Ventilation System
3
-10 Steering Wheel Controls for Climate Control
3
-10 Audio Systems
3
-10 Setting the Clock3
-11 AM-FM Stereo with Cassette Tape and
Compact Disc Player with Programmable
Equalization and Radio Data System (RDS)
3
-20 Navigation/Radio System (Option)
3
-21 Trunk-Mounted CD Changer (Option)
3
-25 Personal Choice Radio Controls (If Equipped)
3
-25 Theft-Deterrent Feature
3
-26 Audio Steering Wheel Controls
3
-26 Understanding Radio Reception
3
-27 Tips About Your Audio System
3
-28 Care of Your Cassette Tape Player
3
-29 Care of Your Compact Discs
3
-29 Care of Your Compact Disc Player
3
-30 Diversity Antenna System
3
-30 Chime Level Adjustment
ProCarManuals.com

3-2
Comfort Controls
This section tells you how to operate your climate
control system.
Your vehicle may be equipped with a passenger
compartment air filter. For more information, see
ªPassenger Compartment Air Filterº in the Index.
Automatic Electronic Climate Control
Your vehicle is equipped with an automatic electronic
climate control system, which can be operated either
manually or automatically. Your vehicle also has the
flow
-through ventilation system, which is described
later in this section.Mode Control
Turn the left mode knob to deliver airflow through the
instrument panel or windshield outlets, or the floor
ducts. The system will stay in the selected mode until
the left mode knob is turned again.
The right mode knob controls the fan speed in both the
manual mode and the automatic mode.

Turn the right mode knob to select a manual fan
speed. Turn this knob clockwise to raise the fan
speed. Turn this knob counterclockwise to lower the
fan speed. Turning the right mode knob overrides
the automatic fan control mode. The fan speed
indicators will be illuminated while in the manual
fan control mode.

Press the right mode knob to put the fan control in
the automatic mode. The AUTO FAN light below
the knob will illuminate. The fan speed indicators
will not be illuminated when the system is in the
automatic fan control mode.
ProCarManuals.com

3-3
Temperature Buttons
Maintain the temperature inside the vehicle by using the
red and blue arrows located below the digital display. If
you want a warmer comfort level, push the red arrow. If
you want a cooler comfort level, push the blue arrow.
Your selected comfort setting will be shown on the
digital display for five seconds, then the outside
temperature will be displayed.
Manual Operation
Use the left and right mode knobs, along with the
buttons on your climate control system to operate the
system manually.
OFF: Turning the left mode knob to OFF will cause
the fan to turn off and the airflow to be directed through
the floor ducts. The system will work to maintain the
previously chosen temperature setting. The display will
show the outside temperature when the system is set
to OFF.
(Panel): This setting directs the airflow through
the instrument panel outlets.
(Bi-Level): This setting directs the airflow
through both the instrument panel outlets and the floor
ducts. There is also a small amount of air directed to the
front defroster and the side window defrosters.
(Floor): This setting directs most of the airflow
to the floor ducts. There is also some airflow directed
to the side window defrosters and a small amount of
airflow directed to the front defroster.
(Defogger): This setting directs the majority
of the airflow to the floor ducts and the front defroster,
with a small amount of airflow to the side window
defrosters. This can be useful in helping to remove
moisture from the inside of the windshield when the
outside temperature is cold or the humidity is high. The
air conditioning indicator light will come on to show the
air compressor is working to dehumidify the air.
(Defroster): This setting directs the majority of the
airflow to the windshield with some airflow to the side
window defrosters and the floor ducts. To increase the
fan speed, turn the right mode knob clockwise.
Even though air conditioning is not selected, in defrost
mode the air conditioning compressor will run
automatically at temperatures over approximately 40
F
(4
C) to improve windshield clearing performance. This
dehumidifies the air to help dry the windshield. Even
though the compressor may be running, the air
conditioning indicator light will not come on in defrost
unless you select air conditioning.
ProCarManuals.com

3-5
In cold weather, the system will delay turning on the fan
to avoid blowing cold air into the vehicle. The length of
the delay depends on the engine coolant temperature and
the outside temperature. Turning the right mode knob
will override this delay by turning off the automatic
mode and changing the fan speed.
Your automatic electronic climate control system has a
sun sensor located on the top of the instrument panel
that detects direct sunlight. To keep you and your
passengers comfortable, the system may supply cooler
air to the side of the vehicle toward the sun. Be careful
not to put anything over this sun sensor. The automatic
electronic climate control system may not operate
correctly if this sensor is covered.
To change the automatic electronic climate control
display from an English display to a metric display, push
the OFF button located in the Driver Information Center
(DIC) for two seconds. The display in the DIC will also
change from an English to a metric display. To return to
an English display, repeat the above procedure.Passenger Temperature Control (Option)
With this feature, the right
front seat passenger can
control the temperature
setting for his or her own
zone. To use this feature,
turn the knob on the
passenger's door clockwise
or counterclockwise to a
cooler or warmer setting.
The temperature can be set up to 8
F (4
C) cooler or
warmer than the main setting.
ProCarManuals.com

3-7
On very hot days, open the windows long enough to let
the hot air out. This reduces the time required to cool the
interior of the vehicle to a comfortable temperature. If
the system is in the automatic mode (left and right mode
knob indicator lights are on), during very hot days the
system will automatically go to the recirculation mode
and the temperature door will initially be at the full cold
position for maximum cooling. You can choose the
extreme temperature setting of 60
F (16
C), but the
system will not cool any faster by choosing this setting.
Heating
In cold weather, if the automatic mode is selected
(left and right mode knob indicator lights are on), the
system will automatically direct the airflow out of the
floor ducts and the temperature door will initially be
positioned at the full hot position. You can choose
the extreme temperature setting of 90
F (32
C),
but the system will not warm up any faster by selecting
this setting.In cold weather, the system will delay turning on the fan
to avoid blowing cold air into the vehicle. The length of
the delay depends on the engine coolant temperature and
the outside temperature. The fan speed will increase as
the temperature of the engine coolant rises. Turning the
right mode knob will override this delay by cancelling
the automatic fan control mode.
Defogging and Defrosting
On cool, humid days, use the defog setting to keep
the windows clear while also providing heat through
the floor ducts. Turn the left mode knob clockwise
to defrost to quickly remove fog or ice from
the windshield.
For maximum front defrost performance under extreme
icing or frosting conditions, increase the temperature
setting to 90
F (33
C) and increase the fan speed
to high.
ProCarManuals.com

3-10 Steering Wheel Controls for
Climate Control
Some heating and cooling
controls can be adjusted
at the steering wheel.
Other touch controls
also operate some audio
controls. See ªAudio
Steering Wheel Controlsº
later in this section.
~!(Fan): Press the up arrow on the fan button to
override the automatic fan control and increase the fan
speed in manual mode. Press the down arrow on the fan
button to override the automatic fan control and reduce
the fan speed in manual mode.
~TEMP! (Temperature): Press either arrow on the
TEMP button once to display your current temperature
setting in the digital display. Press the up arrow on the
TEMP button again to provide a warmer temperature
setting or press the down arrow on the TEMP button
again to provide a cooler temperature setting.
Audio Systems
Your audio system has been designed to operate easily
and give years of listening pleasure. You will get the
most enjoyment out of it if you acquaint yourself with it
first. Find out what your audio system can do and how
to operate all of its controls to be sure you're getting the
most out of the advanced engineering that went into it.
Your vehicle has a feature called Retained Accessory
Power (RAP). With RAP, you can play your audio
system even after the ignition is turned off. See
ªRetained Accessory Power (RAP)º in the Index.
Setting the Clock
Press and hold HR until the correct hour appears. The
letters AM or PM will appear on the display. Then, press
and hold MN until the correct minute appears. The clock
may be set with the ignition on or off.
To set the clock to the time of an FM station
broadcasting Radio Data System (RDS) information,
press and hold HR and MN at the same time until
UPDATED appears on the display. If the time is not
available from the station, NO UPDATE will appear on
the display instead.
ProCarManuals.com

3-11 AM-FM Stereo with Cassette Tape and
Compact Disc Player with Programmable
Equalization and Radio Data System (RDS)
Standard Radio -- Bose
Not Shown
Playing the Radio
POWER: Press this knob to turn the system on and off.
VOLUME: Turn the knob clockwise to increase
volume. Turn it counterclockwise to decrease volume.SCV (Speed
-Compensated Volume): With SCV, your
audio system adjusts automatically to make up for road
and wind noise as you drive. Set the volume at the
desired level. Press this button to select MIN, MED or
MAX. Each higher choice allows for more volume
compensation at faster vehicle speeds. Then, as you
drive, SCV automatically increases the volume, as
necessary, to overcome noise at any speed. The volume
level should always sound the same to you as you drive.
If you don't want to use SCV, select OFF.
Finding a Station
BAND: Press this button to switch between AM, FM1
and FM2. The display shows your selection.
TUNE: Turn this knob to select radio stations.
SEEK : Press the right or left arrow to go to the
next or previous station and stay there. The radio will
seek to stations with a strong signal only. The sound will
mute while seeking.
SCAN : Press and hold either arrow for two
seconds until SC appears on the display and you hear
a beep. The radio will go to a station, play for a few
seconds, then go on to the next station. Press either
SCAN arrow again to stop scanning. The radio will
scan to stations with a strong signal only. The sound will
mute while scanning.
ProCarManuals.com