cruise control Oldsmobile Cutlass 1998 Owner's Manuals

Cruise Control
With cruise control, you can maintain a speed of about
25 mph (40 lun/h) or more without keeping your
foot
on the accelerator. This can really help on long
trips. Cruise control does not work at speeds below
25 mph (40 km/h).
When you apply your brake, the cruise control shuts off.
e
e
Cruise control can be dangerous where you
can’t drive safely at a steady speed.
So,
don’t use your cruise control on winding
roads or in heavy traffk.
Cruise control can be dangerous
on
slippery roads. On such. roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don’t
use cruise control on slippery roads.
2-33

Setting Cruise Control
If you leave your cruise control switch on when
you’re not using
cruise, you might hit a button
and go into cruise when you don’t want to. You
could be startled and even lose control. Keep the
cruise control switch
off until you want to use it.
The cruise control buttons are located on the center of
the steering wheel.
1. Press the cruise control ON/OFF button. Resuming a Set Speed
Suppose you
set your cruise control at a desired speed
and then you apply the brake.
This, of course, shuts off
the cruise control. But you don’t need to reset it. Once
you’re going about
25 mph (40 km/h) or more, you can
press the cruise control ACCEL
RESUME button for
about half a second.
You’ll go right back up to your chosen speed and
stay there.
If you press the ACCEL RESUME button longer than
half a second, the vehicle will keep going faster until
you release the switch or apply the brake.
So unless you
want to go faster, don’t hold down the
ACCEL
RESUME button.
2. Get up to the speed you want.
3. Press the SET DECEL button and release it.
4. Take your foot off the accelerator pedal.
2-34

Your instrument panel is designed to let you know at a glance how your vehicle is running. You’ll k\
now how fast
you’re going, how much fuel you’re using, and many other things you’ll need to drive \
safely and economically.
The main components of your instrument panel
are:
A. Fog Lamp Switch
B. Instrument Panel Intensity Control
C. Turn SignaVMultifunction Lever
D. Cruise Control Switches (If Equipped)
E. Horn
F. Instrument Panel Cluster
G. Windshield Wiper/Washer Lever
H. Ignition Switch
I. Hazard Warning Flashers Switch
J. Fuse Panels
K. Climate Control System
L. Accessory Power Outlets
M. Gear Shift Lever
N. Audio System
0. Park Brake Pedal
P. Tilt Wheel Lever
Q. Hood Release Lever
R. Trunk Release Button
S. Instrument Panel Cupholder
2-47

Passlock Warning Light Low Washer Light
This light
will come on
briefly when you
turn the
ignition on. The light
will stay on until the
engine starts.
If the light flashes for several seconds, the passlock
system has entered a tamper mode.
If the vehicle fails to
start, see “Passlock” in the Index.
If the light comes on continuously while driving and
stays on, there may be a problem with the passlock
system. Your vehicle will not be protected by passlock,
and you should see your retailer.
Cruise Light
CRUISE
The CRUISE light comes
on whenever you set your
cruise control.
LOW
WASH
The LOW WASH light will
come on briefly when you
turn on the ignition.
It will also come on, chime and stay on if the fluid
reservoir is less than one-third full.
Service Vehicle Soon Light
SERVICE
VEHICLE
SOON
This light will come on
briefly when you turn
on the ignition.
It will stay on
if it detects a problem on the vehicle, such
as a
DRL or an ALC malfunction. If this happens, see
your retailer service department as soon as possible.
2-59

Instrument Panel Fuse Block - Right
SEE OTHER END CAP FOR FUSE PULLER AND SPARE FUSES
A. INST LPS E. CRUISE SW C. HVAC BLOWER D. CRUISE
E. FOG LPS F. INT LPS GtRGUIT G. RDO BATT H. SUNROOF
G)
H>
CIRCUIT BRKR
PWR
mows
MICRO RELAY
FOG LPS
Usage
Instrument Panel Lights, Dimtiiler
Cruise Control
Climate Control System
Cruise Control
Fog Lamps
Interior
Lamps, Body Function
Control Module
Radio
Sunroof
Power Windows
Fog
Lamps
6-55