OLDSMOBILE SILHOUETTE 1996 Manual PDF

Unlock the Driver’s Door Only: To program the
automatic door locks system to unlock only the driver’s
door
when the shift lever is returned to PARK (P), press
the unlock symbol on your remote transmitter once. The
driver’s door will unlock, indicating that this mode has
been successfully programmed.
Unlock All Doors: To program the automatic door locks
system to unlock all doors when the shift lever
is returned
to PARK
(P), press the unlock symbol on your remote
transmitter once
‘(the driver’s door will unlock), then press
the unlock symbol again. All doors will unlock, indicating
that this mode has been successfully programmed.
All Doors Remain Locked: To program the automatic
door locks system to leave all doors locked when the
shift lever is returned
to PARK (P), press the lock
symbol
on your remote transmitter once. All doors
will lock, indicating that this mode has been successfully programmed.
Disengage the Automatic Door Locks System: To
disengage the automatic door locks system, press the
lock symbol
on your remote transmitter once (all doors
will lock). Press the lock symbol again.
All doors will
lock again, indicating that this mode has been
successfully programmed.
You can reprogram
the automatic door locks system at
any time.
If you do not program the automatic door
locks system, all doors will remain locked when the shift
lever is returned to PARK
(P).
If you have more than one remote transmitter for your
vehicle, your automatic door locks system will operate
as programmed with any of them. There is no need to
program each one individually.
Leaving Your Vehicle
If you are leaving the vehicle, take your keys, open your
door and set the locks from inside. Then get
out and
close
the door.
2-7
ProCarManuals.com

Remote Lock Control (Option)
If your Oldsmobile has this option, you can lock and unlock
your doors and liftgate from up to
30 feet (9 m) away using
the key chain transmitter supplied with your vehicle. Your
Remote Lock Control operates
on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
This device complies with
Part 15 of the FCC Rules.
Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Should interference to this system occur, try this:
Check to determine if battery replacement is necessary.
See the instructions
on battery replacement.
Check the distance. You may be too far from your
vehicle. This product has a maximum range.
blocking the signal.
Check the location. Other vehicles or objects may be
See your Oldsmobile retailer or a qualified
technician for service.
Changes
or modifications to this system by other than an
authorized service facility could void authorization
to
use this equipment.
2-8
ProCarManuals.com

Operation
The driver’s door will unlock and the interior lamps will
go on when the unlock symbol is pressed (see
“Illuminated Entry System” later in this section). If
pressed again within five seconds, all doors and the
liftgate will unlock. All doors and the liftgate will lock
when the lock symbol is pressed.
If the driver’s door
is open and your key is in the
ignition in the OFF position, you
won’t be able to set the
door lock with
the power door lock switch or the remote
transmitter. This security feature is designed to help
keep you from locking your keys in your vehicle.
Lock Delay
The lock delay feature can be operated using either the
remote key chain transmitter or the power door lock
switch (see “Power Door Locks” earlier in this section). For the lock delay feature to work, the ignition and the
interior lamps control (located to
the left of the instrument
panel cluster) must be
off. If you wish to lock the doors
with the interior lamps on, press the lock symbol or the
rear
of either power door lock switch twice.
If any door is open when you press the lock symbol or
the rear of either power door lock switch, a chime will
sound three times. This indicates that all doors and the
liftgate will lock about five seconds after the last door
has been closed.
To override the lock delay feature, press the lock symbol
or the rear of either power door lock switch again, and
the doors and liftgate will lock immediately. If the
sliding door is open,
it will lock automatically within
five seconds after it is closed.
To cancel the lock delay feature, press the unlock
symbol or the front of either power door lock switch.
ProCarManuals.com

If you have the optional power sliding door (see “Power
Sliding Door” later
in this section), your remote
transmitter will have
a third button that has a van
symbol on
it. Press it to open or close the sliding door.
If the sliding door is locked, first press the unlock
symbol twice to unlock all doors, then press the van
symbol
to open the sliding door.
You can operate the power sliding door with
the remote
transmitter only when the power sliding door
ON/OFF
switch on the overhead console is in the ON position.
atchin- n-.smitter(s) To Your Vehicle -
Each
key chain transmitter is coded to prevent another
transmitter from unlocking your vehicle.
If a transmitter
is lost or stolen, a replacement can be purchased through
your retailer. Remember
to bring any remaining
transmitters with you when you go to your retailer.
When
the retailer matches the replacement transmitter to
your vehicle, any remaining transmitters must also be
matched. Once the new transmitter is coded, the lost
transmitter will not unlock your vehicle. Each vehicle
can have only four transmitters matched to it.
n 1tt acement
Under-normal use, the battery in your key chain
transmitter should last about two years.
You can tell the battery is weak if the transmitter won’t
work at the normal range in any location.
If you have to
get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
ProCarManuals.com

Replacing the Battery in the Remote Transmitter
1. Insert a coin into the slot in the back of the transmitter,
and
turn it counterclockwise to open the cover.
2. Remove the cover.
3. Remove and replace the 3-volt battery (CR2032).
4. Reassemble the transmitter.
5. Check the transmitter operation.
Illuminated Entry System (Option)
This option comes with the optional Remote Lock
Control system.
When
you open the driver’s door (by itself or in
combination with any passenger door or
the liftgate) the
interior lamps will come on and then gradually dim to
off, 10 seconds after the last door is closed. (If the
driver’s door has not been opened, the interior lamps
will immediately dim to off.)
When you press the unlock symbol on your remote
transmitter, the lamps inside your vehicle will go on,
then gradually dim to off after about
40 seconds, unless
a door or the liftgate is opened.
When you turn on the ignition, the interior lamps will
immediately dim to off.
2-11
ProCarManuals.com

ding Door
To open the sliding door from outside the vehicle, pull
the front
of the latch release out and then toward the
rear.
If you slide the door all the way back, it will latch
in the open position.
To move the door forward, you must first pull the inside
or outside latch release
out and then forward, or the door
will remain latched in the open position.
ProCarManuals.com

Sliding Door Lock
Lock the sliding door from the inside by sliding the
manual locking lever down. Unlock it
by sliding the
lever up.
If you have the optional power door locks, the sliding
door lock has a delay feature. See “Power Door Locks”
or “Automatic Door Locks” in the Index.
Power Sliding Door (Option)
A
With this option, you can open and close the sliding
door
with switches inside your vehicle. If you have the
optional Remote Lock Control system,
you can also
operate the sliding door with your remote transmitter.
See “Remote Lock Control” in the Index.
ProCarManuals.com

Leaving young children or pets unattended in
your vehicle can be dangerous. They could operate the power sliding door.
A child or others
could be injured.
Do not leave children or pets
unattended in your vehicle.
To operate the power sliding door, the power sliding
door
ON/OFF switch must be in the ON position. This
switch is the forward-most of two power door switches
located on the side of the overhead console. (If you have
the compact overhead console, this switch is located
between the reading lamps.)
To disable the power
sliding door feature, slide the switch to
OFF.
When your vehicle goes through an automatic car wash,
be sure the power sliding door
ON/OFF switch is in the
OFF position.
To open or close the sliding door, press and release one
of two PWR DOOR switches. There is one mounted on
the wall, just in front of the sliding door; the other is the
rear-most switch on the side of the overhead console. (If
you have the compact overhead console, this switch
is
located between the reading lamps.)
The sliding door must be unlocked for the power sliding
door to operate. The ignition does not have to be on and
the key does not have to be in the ignition.
To prevent
accidental operation of the sliding door, disable the
power sliding door by placing the power sliding door
ON/OFF switch in the OFF position.
2-14
ProCarManuals.com

When the key is in the ignition in the RUN position,
the power sliding door will only open if
the transaxle
is
in PARK (P). The transaxle does not have to be in
PARK (P) to close the door.
If the ON/OFF switch is in
the
ON position and the power sliding door is open or in
the process
of closing when you shift out of PARK (P), a
tone will sound and the power sliding door warning light
on your instrument panel will flash (see “Power Sliding
Door Warning Light”
in the Index). This is a warning
light that the sliding door is not completely closed.
IAC TION: I
If you shift the transaxle out of PARK (P) and
accelerate before the power sliding door latches
closed, the door may reverse to the open position.
A child or others could fall out of the vehicle and
be injured.
Always make sure the power sliding
door
is closed and latched before you drive away.
If anything obstructs the power sliding door while it is
closing, the door will automatically reverse to the open
position, provided it meets sufficient resistance. Resistance must be
as strong as the force of the closing
door, or stronger.
The force of the closing door increases
significantly
as the door approaches the latch position.
ProCarManuals.com

You or others could be injured if caught in the
path of the sliding door. Make sure the door path
is clear before closing the door.
Objects caught in the path of the sliding door may be
damaged. Make sure the door path is clear before
closing the door.
To manually open the power sliding door when the
sliding door ON/OFF switch is in the ON position, pull
the inside or outside latch release and let go; the door
will open fully and remain latched in the open position.
To manually open the power sliding door when the
ON/OFF switch is in the OFF position, pull the inside or
outside latch release and slide the door all the way back
to the latch position.
If your vehicle is facing downward on a steep grade
(20% or more), the door may not stay open and
could slam shut, possibly injuring someone.
To
make sure the door does not slam shut, turn the
ON/OFF switch ON. Then if the door closes, it will
close under the control of the power door system.
2-16
ProCarManuals.com