OPEL COMBO D 2018 Manual user

Service and maintenance179Dexos is the newest engine oil quality
that provides optimum protection for
petrol and diesel engines. If it is
unavailable, engine oils of other listed qualities must be used.
Recommendations for petrol engines
are also valid for Compressed Natural
Gas (CNG) fuelled engines.
Select the appropriate engine oil
based on its quality and on the
minimum ambient temperature
3 182.
Topping up engine oilCaution
In case of any spilled oil, wipe it up and dispose it properly.
Engine oils of different manufacturersand brands can be mixed as long as
they comply with the required engine
oil quality and viscosity.
Use of engine oil with only
ACEA A1/B1 or only A5/B5 quality is
prohibited, since it can cause long-
term engine damage under certain
operating conditions.
Select the appropriate engine oil
based on its quality and on the
minimum ambient temperature
3 182.
Additional engine oil additives
The use of additional engine oil
additives could cause damage and
invalidate the warranty.
Engine oil viscosity
The SAE viscosity grade gives
information on the thickness of the oil.
Multigrade oil is indicated by two
figures, e.g. SAE 5W-30. The first
figure, followed by a W, indicates the low temperature viscosity and the
second figure the high temperature viscosity.
Select the appropriate viscosity grade depending on the minimum ambient
temperature 3 182.
All of the recommended viscosity grades are suitable for high ambient
temperatures.
Coolant and antifreeze
Use only antifreeze approved for the
vehicle. Consult a workshop.The system is factory filled with
coolant designed for excellent
corrosion protection and frost
protection down to approx. -28 °C. In
regions with very low temperatures,
the factory filled coolant provides frost
protection down to approx. -37 °C.
This concentration should be
maintained all year round.
The use of additional coolant
additives that intend to give additional corrosion protection or seal against
minor leaks can cause function
problems. Liability for consequences
resulting from the use of additional
coolant additives will be rejected.
Washer fluid Use only washer fluid approved for
the vehicle to prevent damage of wiper blades, paintwork, plastic and
rubber parts. Consult a workshop.
Brake and clutch fluid Over time, brake fluid absorbs
moisture which will reduce braking
effectiveness. The brake fluid should
therefore be replaced at the specified interval.

180Technical dataTechnical dataVehicle identification..................180
Vehicle Identification Number ..180
Identification plate ...................181
Engine identification ................181
Vehicle data ............................... 182
Recommended fluids and lubricants ................................ 182
Engine data ............................. 183
Performance ............................ 186
Vehicle weight ......................... 187
Vehicle dimensions .................188
Capacities ................................ 190
Tyre pressures ........................ 191Vehicle identification
Vehicle IdentificationNumber
The Vehicle Identification Number is
visible through the windscreen.
The Vehicle Identification Number is
also found in the front foot well, on the right-hand side of the vehicle, behind
a cover.

Technical data181Identification plate
The identification plate is located in
the door frame.
Information on identification label:1:vehicle identification number2:permissible gross vehicle weight
rating in kg3:permissible gross train weight
in kg4:maximum permissible front axle
load in kg5:maximum permissible rear axle
load in kg6:engine type
Note
The identification plate on your
vehicle may differ from the
illustration shown.
The combined total of front and rear
axle loads must not exceed the
permissible gross vehicle weight. For
example, if the front axle is bearing its
maximum permissible load, the rear
axle can only bear a load that is equal
to the gross vehicle weight minus the front axle load.
The technical data is determined in
accordance with European
Community standards. We reserve
the right to make modifications.
Specifications in the vehicle
documents always have priority over
those given in this manual.
Engine identification
The engine number is stamped on the
engine block.
The technical data tables show the
engine identifier code.
Engine data 3 183.
To identify the respective engine,
refer to the engine power in the EEC
Certificate of Conformity provided
with your vehicle or other national
registration documents.

182Technical dataVehicle dataRecommended fluids andlubricants
Required engine oil qualityEngine oil quality: Europedexos 2✔
For countries with International
service interval 3 177, you may use
the oil qualities listed below:
Engine oil quality: Internationaldexos 2✔ACEA C3✔ACEA A3/B4✔Engine oil viscosity gradesAmbient temperaturedown to
-25 °CSAE 0W-30 or
SAE 0W-40
SAE 5W-30 or
SAE 5W-40below
-25 °CSAE 0W-30 or
SAE 0W-40

Technical data183Engine dataSales designation1.41.41.4Engine identifier code1.4i1.4 Turbo1.4 CNGPiston displacement [cm3
]136813681368Engine power [kW]708888at rpm600050005000Torque [Nm]127206206at rpm450030003000Fuel typePetrolPetrolCompressed Natural Gas/PetrolOctane rating RON 1)recommended959595possible989898Gas––CNG1)
A country-specific label at the fuel filler flap can supersede the engine specific requirement.

184Technical dataSales designation1.3 Turbo2)1.3 Turbo 3)1.6 Turbo2)1.6 Turbo 2)Engine identifier code1.3 CDTI1.3 CDTI1.6 CDTI1.6 CDTIPiston displacement [cm 3
]1248124815981598Engine power [kW]66706677at rpm4000350040004000Torque [Nm]200200290 / 200 4)290at rpm1500150015001500Fuel typeDieselDieselDieselDiesel2)
Euro 5+.
3) Euro 6.
4) Manual transmission / Manual transmission automated.Sales designation1.6 Turbo 5)2.0 TurboEngine identifier code1.6 CDTI2.0 CDTIPiston displacement [cm 3
]15981956Engine power [kW]70/74/77/88 6)99at rpm3500 - 40003500

Technical data185Sales designation1.6 Turbo5)2.0 TurboEngine identifier code1.6 CDTI2.0 CDTITorque [Nm]280 - 320320at rpm1500 - 17501500Fuel typeDieselDiesel5)
Euro 6.
6) Depending on output code.

186Technical dataPerformanceEngine1.4i1.4Turbo1.4CNGMaximum speed [km/h]161172/1677)172/1677)7)
H1/H2.
Euro 5+ engine
1.3CDTI
(66 kW)1.6CDTI
(66 kW)1.6CDTI
(77 kW)
2.0CDTI
Maximum speed [km/h]158/153 8)158/1538)164/1598)179/1748)8)
H1/H2.
Euro 6 engine
1.3CDTI
(70 kW)1.6CDTI
(70 kW)1.6CDTI
(74 kW)1.6CDTI
(77 kW)1.6CDTI
(88 kW)Maximum speed [km/h]159160/155 9)160/1559)166/1619)172/1679)16110)164/159 9)10)164/1599)10)170/165 9)10)176/1719)10)9)
H1/H2.
10) Euro 6 Eco-Pack.

Technical data187Vehicle weightKerb weight, basic model without any optional equipment
The maximum permissible loads must not be exceeded. These weights are specified in the vehicle documents or on the identification plate 3 181.LengthRoof heightVanCombiCombo TourL1H11355-15351421-16051445-1615H21360-1555-1505-1615L2H11360-16151466-16151600-1615H21535-15501600-16751615–1675
Optional equipment and accessories increase the kerb weight. The EC certificate of conformity states the kerb weight for
a specific vehicle.
Loading information 3 68.

188Technical dataVehicle dimensionsTypeVanCombi / Combo TourWheelbaseL1L2L1L2Length [mm]4390474043904740Width without exterior mirrors [mm]1832-18501832-18501832-18501832-1850Width with exterior mirrors [mm]2119211921192119Height [mm]; Standard roof (H1)11)1895/184512)1927/188012)1895/184512)1927/188012)Height [mm]; High roof (H2) 11)2125212521252125/211513)Wheelbase [mm]2755310527553105Turning circle kerb to kerb [m]11.212.511.212.511)
Without antenna.
12) With/without roof rack installed.
13) Combi/Combo Tour.