engine oil OPEL CORSA 2009 User Guide

236 Opel Service, maintenance⊕Additional work.
o The intervals are shorter where driving conditions are more arduous or country-specific.
Service work
after year
1)
km (x1000)
1)
1)Depending on what occurs first.
1
15 2
30 3
45 4
60 5
75
⊕
Replace timing belt and tension pulley
Z 16 LEL, Z 16 LER, Z 17 DTR every 10 years/150000 km
Change engine oil and replace filter xxxxx
⊕o
Drain water from fuel filter, diesel (if the air humidity is high or the fuel of lower quality)xxxxx
Replace fuel filter and drain water, diesel (grade EN590)
Z 13 DTJ, Z 17 DTH xx
Replace fuel filter, petrol (g rade EN228), outer Z 16 LEL, Z 16 LER every 4 years/60000 km
Check handbrake, adjust if necessary (unl aden wheels); carry out a visual check of
wheel suspension and suspension front and re ar, brake lines, brake pressure hose, fuel
lines and exhaust system xx
Check external bodywork / underseal, note any damage in the Service and Warranty
Booklet. xxxxx
⊕o
Carry out a visual check on the front and rear wheel brakes
2)
2)If the loss is too great or there are leaks, carry
out remedial work in agreement with the customer.
xx
Annual service check if the annual distance travelled is greater than 20000 km.
Carry out a visual check of the engine, tran smission (AT, MT), check air conditioning
compressor for leaks
2)
xxxxx
Back to overview

237
Opel Service, maintenance
⊕ Additional work.
o The intervals are shorter where driving conditions are more arduous or country-specific.
Service work
after year
1)
km (x1000)
1)
1)Depending on what occurs first.
1
15 2
30 3
45 4
60 5
75
⊕o
Remove brake drum, clean, carry out visual check every 4 years/60000 km
Visually inspect steering system boots, track rods, final drive xxxxx
Check track rod end and supporting ball joint xxxxx
⊕
Change brake and clutch fluids (manual transmission automated) every 2 years
Loosen wheel mountings and tighten to 110 Nm
xx
Grease or apply oil to
bolt taper when fitting.
Check tyre condition and pressure (inclu ding spare wheel), correct if necessary.
If there is a tyre inflation system, check that the set is complete and the use-by date is
still valid. Replace sealant bottle every four years.
⊕
Annual service check if the annual distance travelled is greater than 20000 km.
Visually check the first aid kit (that it is wher e it should be, that it is undamaged and that
the use by date is still valid), lashing eyes and warning triangle every 2 years
Check headlamp settings (including auxi liary headlamps), adjust if necessary x x
⊕o
Lubricate door hinges, check arms, cylinder lo ck, door latch, bonnet catch, rear panel
hinge xx
OPC: check function of central locking system
clean door lock from outside and grease xxxxx
Test run, final check (check steering and ig nition lock, instrument and warning lamps,
entire brake system, steering, air conditioni ng system, engine, bodywork and chassis,
reset service/interval display with TECH 2. xxxxx
Back to overview

238 Opel Service, maintenanceAdditional service workAdditional work ⊕
Additional work is not always necessary at
each service, but can be carried out at the
same time as a regular service.
T h e c o s t o f th i s t y p e o f w o r k i s n o t i n c l ud e d
in the charge for a regular service and will
be invoiced separately. It is, however, more
c o s t - e f f e c t i v e t o h a v e t h i s w o r k d o n e a t t h e
same time as a scheduled service rather
than have it done separately.
Hard driving conditions o
Conditions are considered hard when one
or more of the following situations occurs
more frequently:
z cold start,
z stop and go,
z caravan/trailer towing,
z inclines or steep climbs,
z poor road conditions,
z sand and dust,
z extreme temperature fluctuations.
Police vehicles, taxis and driving school
vehicles are classified as being subjected to
hard driving conditions. With hard driving conditions it might be
necessary to carry out certain service work
more frequently than the scheduled
intervals.
We recommend seeking technical advice
with regard to servic
ing requirements for
your particular driving circumstances.
Recommended fluids and
lubricants Only use products which have been tested
and approved. Damage caused by using
operating materials which have not been
approved is not covere d by the guarantee.
Engine oil
Engine oil is graded by quality and
viscosity. When choosing an engine oil, the
quality grade is more important than the
viscosity. Engine oil for Service schedule Europe
Opel engine oil is GM-LL-A-025
and GM-LL-B-025 grade and therefore
suitable for both petrol and diesel engines.
Engine oil for International service
9
Warning
Operating materials are dangerous and
must be handled carefully. If swallowed,
seek medical help immediately. Do not
breath in fumes and avoid contact with
the skin. Keep away from children.
These materials are forbidden to con-
taminate waste water, surface water,
groundwater or soil. Dispose of empty
containers correctly. Always remember
that operating materials are dangerous.
GM-LL-A-025: Petrol engines
GM-LL-B-025: Diesel engines
GM General Motors Europe
LL Long life A or B Details of engine oil grade
025 Validity code
Back to overview

239
Opel Service, maintenance
scheduleEngine oil: top up
Oils from different manufacturers and
different brands of oil can be mixed as long
as the grades (quality and viscosity) are
the same.
Not all the engine oils available on the
market are of a suitable quality. Always
check that the required specification and
classification are given on the cans.
If engine oil of a suitable quality cannot be
obtained, use no more than 1 litre of
category ACEA A3/B4 or A3/B3 (once
between two oil changes). The viscosity
must be suitable for requirements.
It is forbidden to use engine oil of
grades ACEA A1/B1 and A5/B5. Under
certain circumstances, these oils can
cause long-term damage to the engine. Engine oil additives
The use of motor oil additives can lead to
damage and will invalidate the guarantee.
Engine oil viscosity
Only use engine oils with viscosity
grades 0W-30, 0W-40, 5W-30 or 5W-40.
The SAE viscosity grading system indicates
the oil’s flowability. Oil is more viscous
when cold than when warm.
Multigrade oil has two numbers. The first,
followed by a W, indicates the viscosity at
low temperatures and the second indicates
the viscosity at high temperatures.
ACEA-A3: Petrol engines
ACEA-B4: Diesel engines without
diesel particulate filter
ACEA-C3 Diesel engines with diesel particulate filter
Back to overview

241
Opel Service, maintenance
Genuine Opel Parts and
Accessories We recommend that you use "Genuine
Opel Parts and Accessories" and
conversion parts expressly approved for
your vehicle model. These parts have
undergone special tests to establish their
reliability, safety and specific suitability for
Opel vehicles. Despit e continuous market
monitoring, we cannot assess or guarantee
these attributes for other products, even if
they – have been granted approval – by
the relevant authorities or in some other
form.
"Genuine Opel Parts and Accessories" and
conversion parts approved by Opel can of
course be obtained from your Opel
Partner, who can provide – comprehensive
advice about permissible technical
changes – and ensure that the part is
installed correctly.
Picture no: 17304t.tif
Performing work To avoid injury from moving parts and
cables conducting ignition voltage, only
carry out engine compartment checks
(e. g. checking brake fluid or engine oil
level) when the igniti on is switched off.
Picture no: 18145s.tif
To aid identification, the caps to be
removed for topping up engine oil, coolant
and washer fluid and the dipstick handle
may be coloured yellow.
9
Warning
Only perform engine compartment
checks when the ignition is off.
The cooling fan may start operating
even if the ignition is off.
9
Warning
The ignition system 3 and Xenon head-
lamps 3 use extremely high voltage. Do
not touch.
Back to overview

242 Opel Service, maintenance
Picture no: 18152s.tif
Engine oil In vehicles fitted with engine oil level
monitoring 3, the engine oil level is
checked automatically 386. We
recommend checking the engine oil level
before embarking on long journeys.
Picture no: 18146s.tif
Check with the vehicle on a level surface.
The engine must be at operating
temperature and switched off for at least
5minutes.
Picture no: 18466s.tif
Pull out the dipstick, wipe it clean, insert it
to the stop on the handle, pull out and read
the engine oil level.
Push the dipstick in as far as it will go and
twist it by half a turn.
Different dipsticks are used depending on
engine variant.
When the engine oil level has dropped to
the MIN mark, top up engine oil.
Back to overview

243
Opel Service, maintenance
Picture no: 18153s.tif
We recommend that you use the same
engine oil as was used the last time it was
topped up.
Picture no: 18147s.tif
The engine oil level must not exceed the
MAX mark on the dipstick.
Picture no: 18467s.tif
The amount filled must be between the
MIN and MAX marks 3267.
Fit the cap on straig ht and tighten it.
Caution
If there is too much engine oil, the excess
must be drained or suctioned out.
Back to overview

244 Opel Service, maintenanceDiesel fuel filter On the event of engine oil change, have
fuel filter checked for possible water
residue by a workshop.
Illumination of A indicates water in the
fuel filter 3.
Have fuel filter checked at shorter intervals
if the vehicle is subjected to extreme
operating conditions such as high humidity
(primarily in coastal areas), extremely high
or low outside temperatures and
substantially varying daytime and
night-time temperatures.
Coolant The coolant provid es anti-freeze
protection down to approx. -28 C. .
Picture no: 18148s.tif
Antifreeze and corrosion protection
Have the concentration of the radiator
contents tested by a workshop before
winter starts. The amount of
antifreezemust provide protection down to
approx. -28 C. A lower antifreeze
concentration will reduce the amount of
protection from fros t and corrosion. Add
antifreeze if necessary.
If coolant loss is topped up with water,
have concentration checked and add
antifreeze if necessary.
Caution
Only use approved anti-freeze.
Coolant additives used to give addi-
tional protection aga inst corrosion and
prevention against small leaks can lead
to functional problems. No liability is
accepted for damage caused by using
coolant additives.
9
Warning
Antifreeze is a danger to health; it must
therefore be kept in the original con-
tainer and out of the reach of children.
Back to overview

249
Opel Service, maintenance
Protecting electronic components In order to prevent faults in electronic
components in the electrical system, never
connect or disconnect battery with engine
running or ignition switched on. Never start
engine with battery disconnected, e.g.
when starting using jump leads.
To avoid damaging th e vehicle, do not
make any modifications to the electrical
system, e. g. connecting additional
consumers or tampering with electronic
control units (chip tuning).
Laying the vehicle up for a long
period of time If the vehicle is to be laid up for several
months, the following work should be
undertaken to prevent damage:
z Wash and wax the vehicle 3228.
z Have the wax in the engine
compartment and underbody checked.
z Clean and preserve rubber seals.
z Change engine oil.
z Check antifreeze and corrosion
protection 3244.
z Check coolant level, add antifreeze if
necessary 3245.
z Drain the windscreen washer system.
z Increase tyre pressure to value given for
full load 3264. z
Park the vehicle in dry and well
ventilated place. Select first gear or
reverse gear, and with automatic
transmission 3 move selector lever to P.
Use chocks or something similar to
prevent vehicle from rolling.
z Do not apply hand brake.
z Disconnect the clamp from the negative
terminal of the vehicle battery.
Putting the vehicle back into
servicePerform the following work before
recommissioning the vehicle:
zConnect the clamp to the negative
terminal of the vehicle battery.
z Check tyre pressure 3264.
z Top up windscreen washer system 3248.
z Check engine oil level 3242.
z Check coolant level 3245.
z Fit the number plate if necessary.
9
Warning
Electronic ignition systems generate very
high voltages. Do not touch the ignition
system; high voltage can be fatal.
Back to overview

252 Technical DataEngine data Sales designation
Engine identifier code1.0
Z 10 XEP1.2
Z 12 XEP 1.4
Z 14 XEP 1.6
Z 16 LEL 1.6 OPC
Z 16 LER
Number of cylinders 3 4 4 4 4
Piston displacement [cm
3] 9981229 13641598 1598
Brake horse power [kW/bhp] at rpm 44
560059
5600 66
5600 110
5000 141
5850
Torque [Nm] at rpm 88
3800110
4000 125
4000210
1850 to 5000 230
1980 to 5850
Fuel type PetrolPetrol PetrolPetrol Petrol
Octane rating RON
1)
recommended
possible
possible1)Standard high-quality fuels, e.g. unleaded DIN EN 228; N = Normal (Regular), S = Super (Premium), SP = Super Plus (Premium Plus ); value printed in
bold: recommended fuel.
95 (S)
2)
98 (SP)
2)
91 (N)
2)3)
2)Knock control system automatically adjusts ignition timing according to type of fuel used (octane number).
95 (S)
2)
98 (SP)
2)
91 (N)
2)3)
95 (S)
2)
98 (SP)
2)
91 (N)
2)3)
3)Use of 91 RON fuel reduces power and torque. Slight increase in fuel consumption.
95 (S)
2)4)

98 (SP)2)
–
5)
4)Use of 95 RON fuel reduces power and torque. Slight increase in fuel consumption.
95 (S)
2)4)
98 (SP)
2)
–
5)
5)91 RON fuel must not be used. Max. permissible engine speed,
continuous operation (rpm) approx. 6200 6200 6200 6500 6500
Oil consumption [l/1000 km] 0.6 0.6 0.6 0.6 0.6
Back to overview