stop start PEUGEOT 106 2001.5 Owners Manual

Diesel engine pre-heat
W ait until the warning lamp goes
out then operate the starter. On some models the warning lamp willnot light when the engine is hot.
Battery charge warning lamp
Indicates either: - faulty operation of the charging circuit, or
- loose battery or starter terminals,or
- broken or slack alternator belt, or
-a faulty alternator.
Consult a PEUGEOT dealer.
Anti-lock brake systemwarning lamp (ABS)*
Indicates faulty ABS operation.
The vehicle does, however, retain conventional braking.
Consult a PEUGEOT dealer. Coolant temperature gauge -
Needle in zone (A): temperature
correct
- Needle in zone (B): the coolant
temperature is too high Handbrake and brake
fl uid level warning
lamp
Indicates either: - that the engine is not running,
- that the handbrake is on or has not been released correctly (engine running),
- an excessive drop in the brakeßuid level (engine running andhandbrake released).
Note : with the engine running and
the handbrake off, if the warninglight remains lit then you must stop.
Consult a PEUGEOT dealer.
Low engine oil pressure
It is essential to stop. Indicates either:- insufÞcient engine oil pressure, or
-
lack of oil in the lubrication system.
T op up the oil level if necessary.
Consult a PEUGEOT dealer. High coolant temperaturewarning lamp
It is essential to stop. Indicates too high a temperature, caused by: -
a fan malfunction. Check the fuses
and replace them if necessary,
-a coolant leak; the cooling system ispressurised, turn the cap to the 1stnotch, or* unscrew the cap two turns,to let the pressure drop before topping up the level,
-a coolant pump malfunction.
INSTRUMENTS AND CONTROLS21
B
A
W arning lamps
06-05-2002

YOUR 106 IN DETAIL34
CD MULTI-CHANGER (Available as an accessory) Selecting the CD changer Press the “SRC” button until the CD changer is selected.
Selecting a discPress a button from “1”to “6” to select the corresponding disc.
Selecting a trackPress button “J”to select the next track.
Press button “K”to return to the start of the current track or to select the previous track.
Accelerated playPress the “MAN”button.
Keep button “J”or “K” pressed for forwards or backwards accelerated play.
Accelerated play stops as soon as you release the button. Buttons “J”and “K” resume the Òtrack selectionÓ function when the “MAN”button is pressed again.
Shuffle (RAND) When the CD multi-changer is selected, keep the “SRC”button pressed for two seconds. The tracks will be played
in random sequence. Pressing the “SRC”button again for two seconds returns you to normal play.
Note : Do not use blank CDs as these could damage your player.
06-05-2002

YOUR 106 IN DETAIL43
EON system
This connects stations which are part of the same network. It enables broadcasting of traffic information or a PTY programme from a station which is part of the same network as the station to which you are listening.
This service is available when you have selected the TA traffic information programme or the PTY function.
COMPACT DISC Selecting the CD as source
After inserting a disc, with the printed surface upwards, the player starts automatically. If a disc is already inserted, press the"K"button.
Ejecting a disc Press button “A”to eject the disc from the player.
Selecting a trackPress button “G” to select the next track.
Press button “H”to return to the start of the current track or to select the previous track.
Accelerated playPress the “MAN”button.
Keep button “G” or “H” pressed for forwards or backwards accelerated play.
Accelerated play stops as soon as you release the button. Buttons “G”and“H” resume the Òtrack selectionÓ function when the “MAN”button is pressed again.
Shuffle (RDM) When the CD is selected, keep the “K”button pressed for two seconds. The tracks will be played in random
sequence. Pressing the “K”button again for two seconds returns you to normal play.
Note : Do not use blank CDs as these could damage your player.
06-05-2002

YOUR 106 IN DETAIL43
EON system
This connects stations which are part of the same network. It enables broadcasting of traffic information or a PTY programme from a station which is part of the same network as the station to which you are listening.
This service is available when you have selected the TA traffic information programme or the PTY function.
COMPACT DISC Selecting the CD as source
After inserting a disc, with the printed surface upwards, the player starts automatically. If a disc is already inserted, press the"K"button.
Ejecting a disc Press button “A”to eject the disc from the player.
Selecting a trackPress button “G” to select the next track.
Press button “H”to return to the start of the current track or to select the previous track.
Accelerated playPress the “MAN”button.
Keep button “G” or “H” pressed for forwards or backwards accelerated play.
Accelerated play stops as soon as you release the button. Buttons “G”and“H” resume the Òtrack selectionÓ function when the “MAN”button is pressed again.
Shuffle (RDM) When the CD is selected, keep the “K”button pressed for two seconds. The tracks will be played in random
sequence. Pressing the “K”button again for two seconds returns you to normal play.
Note : Do not use blank CDs as these could damage your player.
06-05-2002

YOUR 106 IN DETAIL44
CD MULTI-CHANGER Selecting the CD changer Press the “L” button.
Selecting a discPress a button from “1”to“6” to select the corresponding disc.
Selecting a trackPress button “G”to select the next track.
Press button “H”to return to the start of the current track or to select the previous track.
Accelerated playPress the “MAN”button.
Keep button “G”or “H” pressed for forwards or backwards accelerated play.
Accelerated play stops as soon as you release the button. Buttons “G”and“H” resume the Òtrack selectionÓ function when the “MAN”button is pressed again.
Shuffle (RDM) When the CD multi-changer is selected, keep the “L” button pressed for two seconds. The tracks will be played
in random sequence. Pressing the “L” button again for two seconds returns you to normal play.
Note : Do not use blank CDs as these could damage your player.
06-05-2002

YOUR 106 IN DETAIL51
Rear seats
To tilt the seat:
Ð Pull the rear of the seat 1and tilt it against the front seats.
Ð Place the seat-belt in the hook 2(3-door) or on the top of the seat-back 4
(5-door).
Ð Unlock the seat-back by using the controls 3on the sides.
ÐT ilt the seat-back 4.
To remove the rear seat cushions , tilt the seat cushion to 45¡ and remove it.
To replace the seat cushion: position it on the front Þxing brackets and lower it to
the normal position. When folding the rear seats, always start with the seat cushion, never the seat back (risk of damage).
2134
Rear head restraints* These have one position (high) for when they are in use and anotherposition (low) for storing. They areremovable.
To lower, press the lug.
To remove, pull upwards as far as
the stop and press the lug. W arning: never drive with the head
restraints removed; they must be in place and correctly adjusted. * According to speciÞcation.
06-05-2002

YOUR 106 IN DETAIL55
Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, -
ABS* (lights for 3 seconds, the warning lamp should always goout when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lightsfor six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out: - low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering T
urn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
06-05-2002

YOUR 106 IN DETAIL55
Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, -
ABS* (lights for 3 seconds, the warning lamp should always goout when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lightsfor six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out: - low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering T
urn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
06-05-2002

YOUR 106 IN DETAIL56
Starting a petrol engine* Do not press the accelerator pedal. Operate the starter without relea- sing the key until the engine starts. * According to speciÞcationStarting a diesel engine Engine cold: Do not press the accelerator pedal. T
urn the key to position “M”, the
pre-heat warning lamp lights.W ait until the warning lamp goes
out, then operate the starter in posi- tion “D” until the engine runs
smoothly.
Engine hot: Do not press the accelerator pedal.
Operate the starter.If the engine stops or does not start
immediately, always wait a fewseconds before trying again using
the pre-heater.Never race a cold engi- ne.
Never run the engine inan enclosed space. If the engine cannot be
stopped using the ignition key, press the brake pedal, engage agear and release the clutch inorder to stall the engine. Do not modify the steering
lock in any way.
NOTE: according to speci fica-
tion, the pre-heat warning lamp does not light if the engi-ne is suf ficiently hot.
06-05-2002

Heated seats*
Press the switch to operate the seat heating. Pressing it again stops the opera- tion. * According to speciÞcation
Lighting rheostat Adjustment can only be done with the engine running and the side-lights on, by pressing button
12on
the instrument panel, to increase ordecrease the instrument panel ligh-ting level.
Adjusting the headlamps
Depending on the load in your vehicle, it is recommended that theheadlamp beam is adjusted. 0- 1 or 2 people in the front seats.
–- 3 people.
1- 5 people.
2- 5 people + maximum authori- sed load.
3- Driver + maximum authorised load.
This adjustment can only be carriedout when the lighting control is inthe dipped/main beam position. Initial setting is position 0.
Hazard warning lights
The switch and the direction indica- tors ßash. Controls the direction indicators
simultaneously and continuously.
Use only in cases of danger, for an emergency stop or for driving inunusual conditions. Can operate with the ignition swit-
ched off.
Rear screen demister
Control for demisting the rearscreen (and exterior mirrors)*. Goes out automatically after approximately twelve minutes inorder to avoid excessive currentconsumption. Pushing it again restarts the opera- tion for twelve minutes.
YOUR 106 IN DETAIL67
06-05-2002