warning Peugeot 106 Dag 2001.5 User Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2001.5, Model line: 106 Dag, Model: Peugeot 106 Dag 2001.5Pages: 107, PDF Size: 2.96 MB
Page 53 of 107
Seat belts (5-door):
To adjust the height of the front seat belts*:
Pull control 1towards you and slide it.
To fasten the seat belts: Pull the strap, then insert the end into the buckle. Rear seat beltsThe rear seats are Þtted with two three-point inertia reel belts and alap belt. Pre-tensioning and force-limiting front seat belts* Safety in the event of a front impact has been improved by theintroduction of pre-tensioning andforce-limiting front seat belts.Depending on the seriousness ofthe impact, the pre-tensioningsystem instantly tightens the seatbelts Þrmly against the body of theoccupant. The pre-tensioning seat belts are armed when the ignition is on. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L54
1To be effective, a seat belt must be tensionedas close to the body aspossible.
Depending on the nature andseriousness of the impact thepre-tensioning system may betriggered before and indepen-dently of the airbags. In all cases, the airbag warning light comes on. Following an impact, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for tenyears. Have it replaced at the endof this period.
06-05-2002
Page 54 of 107
Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:
- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, - ABS* (lights for 3 seconds, the
warning lamp should always go out when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lights for six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out:
- low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering
Turn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L55
06-05-2002
Page 55 of 107
Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:
- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, - ABS* (lights for 3 seconds, the
warning lamp should always go out when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lights for six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out:
- low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering
Turn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L55
06-05-2002
Page 56 of 107
Y O U R 1 0 6 I N D E TA I L56
Never race a cold engine.
Never run the engine in an enclosed space. If the engine cannot be stopped using the igni-
tion key, press the brake pedal,engage a gear and release theclutch in order to stall the engi-ne. Do not modify the steering
lock in any way.
Starting a petrol engine* Do not press the accelerator pedal. Operate the starter without relea- sing the key until the engine starts. * According to speciÞcation Starting a diesel engine Engine cold: Do not press the accelerator pedal.
Turn the key to position
ÒMÓ, the
pre-heat warning lamp lights.
Wait until the warning lamp goes out, then operate the starter in posi-tion ÒDÓ until the engine runs
smoothly. Engine hot: Do not press the accelerator pedal.
Operate the starter.If the engine stops or does not start
immediately, always wait a fewseconds before trying again using
the pre-heater.
NOTE: according to speciÞca-tion, the pre-heat warninglamp does not light if the engi-ne is sufÞciently hot.
06-05-2002
Page 65 of 107
Switching off the side lights
switches off the rear fog lamp orreturns to the front fog lamps onlyposition if the vehicle is Þtted withthem. Horn Press the end of the stalk.
Dipped/main beam. Light off. Rear fog lamp lit.
Lights off. Front fog lamps.
Front and rear fog lamps.
Lights off.
Side light on.
In both clear and rainy
weather, in daylight andat night, the rear foglamp dazzles and is the-refore prohibited.
Do not forget to switch it off assoon as it is no longer needed.
LIGHTS STALK Front lights Selection is by turning ring A.
Changing between dipped/main beam: Pull the stalk fully towards you.When your vehicle is equipped with long range light* these operatesimultaneously with the main beam. To ßash the headlamps: Flick the stalk towards you and release it. N.B.:
If the lights are left on when
you switch off the engine and open
a front door, a buzzer will sound. Direction indicators (ßashers) Left, downwards.
Right, upwards.
Fog lamps Operation is by turning ring B. The
position is shown by the warning lamps on the fascia. It operates with the dipped/main beam headlamps. These operate with the side lights, dipped and main beam headlamps.
These operate with the side lights, dipped and main beam headlamps.
Rear Front and rear
Y O U R 1 0 6 I N D E TA I L62
A
B
A
B
06-05-2002
Page 68 of 107
Interior mirror The interior mirror has two posi- tions:
- Day (normal)
- Night (anti-dazzle)
To change from one to the other:push or pull the lever on the bottom edge.Manually controlled mirrors
To adjust: move the adjustment lever in all four directions.
Electrically controlled mirrors*
To adjust:
- Select the mirror using the two way
switch 1.
- Adjust the mirror using control 2.
- Return the two-way switch 1to
its central position.
* According to speciÞcation
When the vehicle is parked, the mirrors can be folded back manually.
Warning: The mirror on the driverÕs side is aspherical to eliminate the Çblind spotÈ. Therefore, objects viewed in the mirror
are, in reality, closer than they appear. This must be taken into account in order to correctly judge the distance of vehicles approaching from behind.
Y O U R 1 0 6 I N D E TA I L65
1
2
06-05-2002
Page 69 of 107
Y O U R 1 0 6 I N D E TA I L66
4
1
2 5
3
6AUDIO
RD S TA
2
12
11
10
9
8
7
5
6
31
4
CENTRAL PANEL
1- Passenger airbag disarming switch.
2- Radio cassette player.
3- Central adjustable vents for heating, ventilation
and air ßow.
4- Heating and ventilation controls.
5- Interior air recirculation or right-hand heated seat control*.
6- Ashtray.
7- Demisting control for rear screen and mirrors*.
8- Hazard warning switch.
9- Lighter.
10 - Air conditioning* or left-hand heated seat*control.
11 - Headlamps height adjustment.
12 - Lighting rheostat.
* According to speciÞcation
06-05-2002
Page 70 of 107
Heated seats*
Press the switch to operate the seat heating. Pressing it again stops the opera- tion. * According to speciÞcation
Lighting rheostat Adjustment can only be done with the engine running and the side-lights on, by pressing button
12on
the instrument panel, to increase ordecrease the instrument panel ligh-ting level.
Adjusting the headlamps
Depending on the load in your vehicle, it is recommended that theheadlamp beam is adjusted. 0- 1 or 2 people in the front seats.
Ð- 3 people.
1- 5 people.
2- 5 people + maximum authori- sed load.
3- Driver + maximum authorised load.
This adjustment can only be carriedout when the lighting control is inthe dipped/main beam position. Initial setting is position 0.
Hazard warning lights
The switch and the direction indica- tors ßash. Controls the direction indicators
simultaneously and continuously.
Use only in cases of danger, for an emergency stop or for driving inunusual conditions. Can operate with the ignition swit-
ched off.
Rear screen demister
Control for demisting the rearscreen (and exterior mirrors)*. Goes out automatically after approximately twelve minutes inorder to avoid excessive currentconsumption. Pushing it again restarts the opera- tion for twelve minutes.
Y O U R 1 0 6 I N D E TA I L67
06-05-2002
Page 71 of 107
Front ashtray:
To empty: -
press tab 1, pulling on the housing
- detach the assembly upwards.
To reÞt:
- engage the lower part,
- press tab 1,
- push downwards and close the assembly. Rear ashtray*: On 5-door:
- To empty: pull the ashtray pres-
sing downwards.
- To reÞt: push the ashtray while pressing downwards.
On 3-door:
- to empty, pull the assembly upwards. Rear parcel shelf
To remove:
Ð Unhook the two cords
1.
Ð Lift the shelf and remove it. Fixing a warning triangle The two restraining straps* located inside the boot enable a warning tri-angle to be Þxed. * According to speciÞcation.
Y O U R 1 0 6 I N D E TA I L69
1
11
06-05-2002
Page 72 of 107
Handbrake Application: When you have completed your parking manoeuvre, pull up thehandbrake to apply it.
To make application and release of
the handbrake easier, press thebrake pedal and pull the handbrakewith the engine running. Release: Press the button before releasing the handbrake.Anti-lock brake system(ABS)* In conjunction with approved tyres in good condition, the anti-lockbrake system improves the stabilityand handling of your 106, particu-larly on poor or slippery surfaces. The anti-lock brake system ope- rates automatically if there is a riskof wheel locking. Lighting of the ABS warning lamp may be due to the turning of awheel during an operation on thevehicle (changing a wheel, forexample) with the ignition on (posi-tion
M).
Note: In certain conditions, normal
operation of the system can berecognised by a light vibration ofthe brake pedal. Should an emergency stop be
necessary, press the brake pedal
Þrmly and continuously. Power steering*
This is a driving aid which offers the best compromise when parking andwhen driving at high speeds. Manual gearbox The gear positions are indicated on the gear lever knob.
1 - Reverse gear can only be
engaged with the vehicle stationary and the engineidling.
* According to speciÞcation.
Y O U R 1 0 6 I N D E TA I L70
1
06-05-2002