ignition PEUGEOT 2008 2013 Owner's Guide

106
Driving
In bad weather and in winter, ensurethat the sensors are not covered by road dir t, ice or snow.
In the event of a fault, have the systemchecked by a PEUGEOT dealer or aqualified workshop.



If the system is deactivated during a manoeuvre, the drive should reactivate it manually to repeat the measurement.


If the lateral distance between your vehicleand the space is too great, the system may not be able to measure the space.
Anything projecting beyond the envelope of the vehicle (long or wide load) is nottaken into account by the Park Assist system during a manoeuvre.
Deactivation
A message is displayed in the screen.
Th
e driver then takes back control of thevehicle's steering.
The system is deactivated automatically:
- on switching off the ignition,
- if the en
gine stalls,
- if no manoeuvre is star ted within 5 minutes
of selection of the type of manoeuvre,
- after a prolonged stop of the vehicle during a manoeuvre,
- if the road wheel anti-spin regulation (ASR) is triggered,
- if the speed of the vehicle exceeds the
stated limit,
- when the driver interrupts movement of the
steerin
g wheel,
- if the driver presses the Park Assist control.
- if correct positionin
g of the vehicle is not possible (too many manoeuvres needed toinser t or extract the vehicle),
- if the driver's door is open,
- if one of the front wheels encounters anobstacle.


Switching off

The system is switched off automatically:


- when towing a trailer,

- if the driver's door is opened,

- if the speed of the vehicle is above 42 mph(70 km/h).
To switch the system of for a prolonged period,contact a PEUGEOT dealer or a qualified
workshop.


Operating faults

In the event of a fault with the system,
this warning lamp is displayed in the
instrument panel and/or a message appears in the screen, accompanied by an audible signal (short beep). The indicator lamp in the control flashes for a
few seconds. If the problem occurs while using
the system, the indicator lamp goes off.
In th
e event of a fault with
the power steering, these
warning lamps come on in
the instrument panel.
Contact a PEUGEOT dealer or a qualified
workshop.

110
Visibility
In good or rainy weather, both day and night, the front foglamps and the rear foglamp are prohibited. In thesesituations, the power of their beams may dazzle other drivers. They shouldonly be used in fog or snow. In these weather conditions, it is your responsibility to switch on the foglamps and dipped beam headlamps manuallyas the sunshine sensor may detect sufficient light.
Do not forget to switch off the frontfoglamps and the rear foglamp when they are no longer necessary.


Switching on the lampsafter the ignition isswitched off

To reactivate the lighting control, rotate the ring to the "0"position - lamps off, then to the desired position. On opening the driver's door atemporary audible signal warns thedriver that the lighting is on.
The lamps, with the exception of thesidelamps, switch off automatically after a maximum duration of thir ty minutes to prevent discharging of the battery.

Switching off the lampswhen the ignition is switched off
On switching off the ignition, all of thelamps turn off immediately, except for dipped beam if guide-me-home lighting is activated.

112
Visibility
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has been switched off makes the driver's exit easier
when the light is poor.
Manual guide-me-home
lighting
Switching on
)With the ignition off, "flash" the headlampsusing the lighting stalk.
)A fur ther "headlamp flash" switches the
function off.


Switching off

The manual guide-me-home lighting switches
off automatically after a set time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.)Within one minute of switching off the
ignition, operate the lighting control stalk up
or down depending on the traffic side (for example: when parking on the left; lighting
control stalk upwards; the right handsidelamps are on).
Manual
guide-me-home lighting isalso available from the remote controllighting button (see the "Remotecontrol" section). This is con
firmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the middle position or switch on the ignition.

118
Visibility
Automatic rain sensitive
windscreen wi
pers
The windscreen wipers operate automatically,
without an
y action on the par t of the driver, if rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Switching on
Briefly push the control stalkdownwards.
This warning lamp comes on in the
instrument panel and a message is
displayed. Brie
fly push the control stalk
downwards again, or place
the control stalk in another position (Int, 1 or 2).
This warning lamp goes off in the instrument
pane
l and a message is displayed.


Switching off


The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if the ignition has been off for more thanone minute.

119
5
Visibility
Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror. Switch off the automatic rain sensitivewipers when using an automatic car wash.
In winter, it is advisable to wait until the windscreen is completely clear of ice before activating the automatic rainsensitive wipers.



Operating fault

If a fault occurs with the automatic rain
sensitive wipers, the wipers will operate in intermittent mode.
Have it checked by PEUGEOT dealer or a qualified workshop.
Special position of the
w
indscreen wipers
This position permits release of the windscreenwiper blades.
It is used for cleaning or replacement of the
blades. It can also be useful, in winter, to detach the blades from the windscreen.

To maintain the effectiveness of the"flat-blade" type of wiper blades, it isadvisable to:


- handle them with care,

- clean them regularly using soapywater,

- avoid using them to retain cardboard on the windscreen,

- replace them at the first signs of wear.


)
Any action on the wiper stalk in the minute
after switching off the ignition places the blades vertically on the screen.) To park the blades again, switch on theignition and operate the wiper stalk.

120
Visibility











Courtesy lamps
In this position, the cour tesylamp comes on gradually:


Take care to avoid leaving anything incontact with the courtesy lamp.

- when the vehicle is unlocked,

- when the ke
y is removed from the ignition,

- when opening a door,

- when the remote control locking button is
pressed, in order to locate your vehicle.
It switches o
ff gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is closed.
Permanentl
y off.
Permanent lighting.
) With the ignition on, press
the corresponding switch.
1.Front / rear cour tesy lamps2.
Map reading lampsWith the "permanent lighting" mode, the lighting time varies according to the circumstances:- with the ignition off, approximately
ten minutes, - in energy economy mode, approximately thirty seconds,- with the engine running, unlimited.




Map reading lamps

122
Safety














Direction indicators
)Lower the lighting control stalk fully when moving to the left.)Raise the lighting control stalk fully when moving to the right.
"Motorway" function
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash 3 times.


If you forget to cancel the directionindicators for more than twenty seconds, the volume of the audible signal will increase if the speed is above40 mph (60 km/h).







Hazard warning lamps
A visual warning by means of the direction indicators to aler t other road users to a vehiclebreakdown, towing or accident.
Automatic operation of
hazard warnin
g lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lamps come on automatically.
They switch off automatically the first time you accelerate.)You can also switch them off by pressingthe button.

)
Press this button, the direction indicatorsflash.
They can operate with the ignition off.

126
Safety
Dynamic stability control(DSC)
Activation
This system is activated automatically each
time the vehicle is started.
It comes into operation in the event of a grip or
trajectory problem.
This is indicated b
y flashing of this
warning lamp in the instrument panel.

Deactivation
In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on softground...), it may be advisable to deactivate
the DSC system, so that the wheels can move
freely and regain grip.

The DSC system offers exceptional safety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed.
The correct operation of the system depends on obser vation of the manufacturer's recommendationsregarding the wheels (tyres and rims),the braking components, the electronic components and the PEUGEOTassembly and operation procedures.
After an impact, have the system
checked by a PEUGEOT dealer or aqualified workshop.



Operating fault

If this warning lamp comes on,
accompanied by an audible signal
and a messa
ge in the screen, this
indicates a fault with the system.
Contact a PEUGEOT dealer or a qualified
workshop to have the system checked.
Reactivation

But it is recommended that the system bereactivated as soon as possible.
)Press the button or, depending
on version, turn the knob to this position.
The s
ystem is reactivated automatically each
time the ignition is switched back on or from
30 mph (50 km/h). The indicator lamp in the button or the knob
comes on: the DSC system no longer acts on
the operation of the engine.
)Press the button again toreactivate it manually.

127
6
i
Safety











Grip control

Special patented traction control system which
improves traction on snow, mud and sand.
This s
ystem is combined with all-season M+S (Mud and Snow: 215/60 R16) tyres which offer
an excellent compromise between safety, gripand traction.
This system, the operation of which has been
optimised for each situation, allows you to manoeuvre in most conditions of poor grip(encountered during touring use).
The accelerator pedal should be pressed
sufficiently to allow the system to use thepower of the engine. The electronics will ensure optimum management of the variousparameters. Operation at high engine speeds iscompletely normal.
Each time the ignition is switched off, the system returns to standard mode (DSC).
Normal mode
Standard mode which is calibrated for a lowlevel of wheel spin, based on the differentlevels of grip normally encountered on the road.
)
Place the dial in this position.
A message appears in the multifunctionscreen or in the instrument panelscreen confirming the mode selected


Snow mode
Mode which adapts its strategy to theconditions of grip encountered for each of the
two front wheels on moving off.
When moving, the system optimises wheel spin
to provide the best acceleration possible for the
grip available.
)Place the dial in this position.

130
Safety
Rear seat belts
The rear seats are each fitted with a three-point
seat belt, with force limiter and, for the outer
seats
, an effort limiter.
When the ignition is switched on, this warning lamp comes on in the instrument panel.
Seat belt not fastened / unfastened warning lamp in the instrument panel

Fastenin
g
)
Pull the strap, then inser t the tongue in the buckle. )
Check that the seat belt is fastened correctly by pulling the strap.


Unfastening
)Press the red button on the buckle.)Guide the seat belt as it reels in.)On the outer seat belts, raise the bar to the
top of the backrest to prevent the tongue from knocking against the side trim.


It r
emains on for a certain time if the frontpassenger has not fastened their seat belt. After this time, the warning lamp goes off if thedriver's seat belt is fastened.
From approximately 12 mph (20 km/h) this
warning lamp flashes for two minutes if the
driver and/or front passenger has not fastened
their seat belt, accompanied by an audiblesignal of increasing volume. Once these two minutes have elapsed, this warning lamp remains on until the driver and/or the frontpassenger fastens their seat belt.