Oil Peugeot 206 Dag 2002.5 User Guide

24-02-2003
INSTRUMENTS AND CONTROLS
32
Engine oil temperature indicator With the engine running, this indi- cates the oil temperature:
Ð needle in zone (C), the tempera-
ture is correct,
Ð needle in zone (D), the tempera-
ture is too high. To lower the oil temperature, reduce your speed.
Coolant temperature indicator
Ð needle in zone (A), the temperature
is correct,
Ð needle in zone (B), the temperature
is too high. The central STOPwarn-
ing light flashes.
You must stop.
Consult a PEUGEOT dealer.

INSTRUMENTS AND CONTROLS33
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see corresponding section),
Ð engine oil level indicator,
Ð total distance recorder/total and trip distances.Note: the total and trip distances are displayed for 30 seconds when the ignition is switched off, on opening the driver's door,
as well as on locking and unlocking the vehicle. Engine oil level When the ignition is switched on, the engine oil level is indicated for approximately 10 seconds, after the servicing informati on.
Maximum Check the level using the dipstick to confirm whether the level indicated is correct; a surplus of oil can cause damage to the engine.
Consult a PEUGEOT dealer without delay. Minimum.
Check the level with the dipstick and top it up. The level indicated is only correct if the vehicle has been on stable, level ground, with the engine stopped, for 10 minutes. Oil level gauge fault The 6 segments flash to indicate a fault in the oil level gauge.There is a risk the engine will be damaged.
Consult a PEUGEOT dealer.
24-02-2003

24-02-2003
PRACTICAL INFORMATION111
1.
Power steering reservoir
2. Windscreen and headlamp wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil filler cap
1.1 litre, 1.4 litre ENGINE

24-02-2003
PRACTICAL INFORMATION
112
1.
Power steering reservoir
2. Windscreen and headlamp wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil filler cap
1.6 litre 16V ENGINE

24-02-2003
PRACTICAL INFORMATION113
1.
Power steering reservoir
2. Windscreen and headlamp wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil filler cap
2 litre 16V ENGINE

24-02-2003
PRACTICAL INFORMATION
114
1-
Power steering reservoir
2- Windscreen and headlamp wash reservoir
3- Coolant reservoir 4-
Brake fluid reservoir
5- Battery
6- Air filter 7-
Dipstick
8- Engine oil filler cap
9- Priming pump
1.4 litre turbo diesel HDI ENGINE

24-02-2003
PRACTICAL INFORMATION115
1.
Power steering reservoir
2. Windscreen and headlamp wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil filler cap
1.9 litre diesel ENGINE

24-02-2003
PRACTICAL INFORMATION
116
1.
Power steering reservoir
2. Windscreen and headlamp wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil filler cap
2 litre turbo diesel HDI ENGINE

24-02-2003
PRACTICAL INFORMATION117
CHECKING LEVELS Engine Oil level check Carry out this check regularly and top up between oil changes (the
maximum consumption is 0.5 litreper 1,000 km). The check must be carried out with the vehicle level and the enginecold.
There are two levelmarks on the dipstick: A= maximum.
B = minimum. Viscosity grade selectionThe oil selected must always meet the manufacturer's requirements. Oil filter Change the cartridge regularly in accordance with the recommenda-tions of the servicing schedule. Used oil
Avoid any prolonged contact of used oil with the skin. Do not discard used oil down drains or onto the ground.
To maintain the reliability of the engines and emission control sys-tems, the use of additives in the oil isprohibited. Brake fluid reservoir
Ð The level must always be above
the DANGER mark on the tank.
Ð In the event of a significant drop in the level, contact a PEUGEOT dealer immediately Fluid change
Ð Always to be carried out at the
intervals given in the manufactur- er's servicing schedule.
Ð Use fluids approved by the manu- facturer which comply with DOT4standard.
Coolant reservoir Use a coolant approved by the man-
ufacturer. When the engine is warm, the coolant temperature is controlled by
the engine fan. As this fan can oper-ate with the ignition key removedand because the cooling circuit ispressurised, wait at least an hour
after switching off the engine beforecarrying out any work. In the event of a breakdown and to avoid any risk of burns, unscrew thecap two turns to let the pressuredrop. When the pressure hasdropped, remove the cap and top upthe level.
Oil change: in accordance with the
manufacturer's servicing schedule.
Ð Dipstick: never exceed the maxi- mum mark A.
Ð Instrument panel gauge.

24-02-2003
PRACTICAL INFORMATION
118
Power steering reservoir
Open the reservoir, with the engine
cold. The level should always beabove the MINI mark, close to theMAXI mark. Manual gearbox
This does not need an oil change.
Check the level according to themanufacturer's servicing schedule.
Windscreen and headlamp washreservoir
For best quality cleaning and for your
safety, we recommend that you useproducts approved by PEUGEOT(capacity 2.8 litres or 6.6 litres withheadlamp wash).
Air filter Regular replacement of the filter ele- ment is essential. If you drive in verydusty conditions, change it twice asoften.
Battery
At the start of winter, have your battery
checked by a PEUGEOT dealer Brake pads Brake pad wear depends on the style of driving, in particular for vehi-cles used in town, for short journeys.It may be necessary to check thethickness of the pads even betweenservices. Autoadaptive automatic gearbox
This does not need an oil change:have the level checked by a PEU-
GEOT dealer according to the manu-facturer's servicing schedule.
Only use products
approved by PEUGEOT.
To ensure best perform- ance from components
as important as the power steer-ing and the braking system, PEUGEOT selects and offersquite specific products.
RUNNING OUT OF FUEL (DIESEL) If you should run out of fuel, it is necessary to re-prime the circuit: 1.4 litre HDI engine
Ð fill the fuel tank with at least five litres of diesel,
Ð operate the manual re-priming pump, until fuel appears in the transparent pipe under the bonnet,
Ð operate the starter until the engine starts.