driver seat adjustment Peugeot 206 P Dag 2009 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: 206 P Dag, Model: Peugeot 206 P Dag 2009Pages: 113, PDF Size: 4.32 MB
Page 4 of 113
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1. Speed limiter/cruise control switch.
2. Steering wheel height adjustment
control.
3. Lights and direction indicators
control.
4. Instrument panel
Instrument panel lighting rheostat.
5. Driver's air bag.
Horn.
6. Handbrake.
7. Front electric window controls.
8. Central locking control.
9. Bonnet opening control.
10. Fuse box.
11. Headlamp height adjustment.
12. Passenger air bag disarming.
13. Heated seats control.
14. Deactivation of the ESP/ASR.
Page 51 of 113
49
AUTOMATIC SWITCHING ON OF
LIGHTS
The side lights and dipped beam head-
lamps switch on automatically if the light
is poor and when the windscreen wip-
ers operate continuously and switch off
when the light becomes bright enough
or the windscreen wipers are switched
off.
I n f o g g y w e a t h e r o r i n s n o w , t h e
b r i g h t n e s s s e n s o r c a n d e t e c t s u f fi -
c i e n t l i g h t , t h e l i g h t s w i l l n o t c o m e
o n a u t o m a t i c a l l y . I f n e c e s s a r y , t h e
d i p p e d h e a d l a m p s m u s t b e s w i t c h e d
on manually.
This function is active when the vehicle
is supplied to the customer.
To disarm or activate the function:
- Place the key in the accessories po- sition (1st notch),
- Place the lights stalk in the 0 posi-
tion,
- Press the end of the lights stalk for more than four seconds.
D o n o t c o v e r t h e b r i g h t n e s s s e n s o r ,
c o u p l e d w i t h t h e r a i n s e n s o r , l o c a t e d
i n t h e c e n t r e o f t h e w i n d s c r e e n , b e -
hind the interior mirror. It is used for
a u t o m a t i c s w i t c h i n g o n o f t h e l i g h t s . Operating check
Activation
The activated function is accompanied
by an audible signal and a message on
the multifunction display.
Disarming
The disarmed function is accompanied
by an audible signal.
When the driver uses the manual light-
ing controls, the function is temporarily
disarmed.
If the brightness sensor does not
function correctly , the lights come on
accompanied by an audible signal and
a message on the multifunction display.
Consult a PEUGEOT dealer.
HEADLAMP ADJUSTMENT
Depending on the load in your vehicle,
it is recommended that the headlamp
beam is adjusted.
0. 1 or 2 people in the front seats.
- . 3 people.
1. 5 people.
2. 5 people + maximum authorised load.
3. Driver + maximum authorised load.
Initial setting is position 0.
Page 58 of 113
55
SEAT BELTS
Driver's seat belt not
fastened/unfastened warning
light *
Front seat belt height adjustment
To lower the attachment point, pull the
control towards you and slide it down-
wards.
To raise the attachment point, slide the
control upwards. Fastening the seat belts
Pull the strap, then insert the tongue
into the buckle.
Check that the seat belt is fastened
correctly by pulling the strap.
Unfastening the seat belts
Press the red button on the buckle.
Front seat belts with pre-tensioner
and force limiter *
Safety in the event of front impacts has
been improved by the introduction of
seat belts with pre-tensioner and force
limiter for the front seats. Depending on
the seriousness of the impact, the pre-
tensioning system instantly tightens the
seat belts and pulls them against the
bodies of the occupants. Rear seat belts
T h e r e a r s e a t s a r e fi t t e d w i t h t h r e e - p o i n t
inertia reel seat belts.
The pre-tensioning seat belts are active
when the ignition is on.
The force limiter eases the pressure of
the seat belt against the chest of the oc-
cupant so increasing his protection.
* According to model.
The warning light comes on each time
the ignition is switched on.
The warning light remains on until the
driver fastens his seat belt.
From 12 mph (20 km/h) and for two
m i n u t e s , t h e w a r n i n g l i g h t fl a s h e s a c -
companied by an audible signal which
increases in volume and a message on
the multifunction display.
Once these two minutes have elapsed,
the warning light remains on until the
driver fastens his seat belt.