lock Peugeot 206 P Dag 2009 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: 206 P Dag, Model: Peugeot 206 P Dag 2009Pages: 113, PDF Size: 4.32 MB
Page 2 of 113
FAMILIARISATION
OPEN
Remote control key
A. Locking of the vehicle.
B. Unlocking of the vehicle.
40
Fuel tank
1. Opening of the cap.
Capacity of the tank: approximately
50 litres.
46 Bonnet
A. Interior control.
B. Exterior control.
C. Bonnet strut.
68 Boot
- Unlock the vehicle using the remote
control.
- Operate the handle A to open.
45
Page 4 of 113
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1. Speed limiter/cruise control switch.
2. Steering wheel height adjustment
control.
3. Lights and direction indicators
control.
4. Instrument panel
Instrument panel lighting rheostat.
5. Driver's air bag.
Horn.
6. Handbrake.
7. Front electric window controls.
8. Central locking control.
9. Bonnet opening control.
10. Fuse box.
11. Headlamp height adjustment.
12. Passenger air bag disarming.
13. Heated seats control.
14. Deactivation of the ESP/ASR.
Page 5 of 113
FAMILIARISATION
1. Steering lock.
2. Audio equipment steering wheel
control.
3. Wipers/screen wash/trip computer
control.
4. Hazard warning lights control.
5. Multifunction display.
6. Air conditioning and rear screen
and mirrors de-icing control.
7. Audio equipment.
8. Front ashtray.
9. Gear lever.
10. 12 V accessories socket.
11. Glove box.
INSTRUMENTS AND CONTROLS
Page 6 of 113
FAMILIARISATION
SIT COMFORTABLY
Front seat adjustments
1. Forwards-backwards adjustment.
2. Head restraint height adjustment.
3. Seat back angle adjustment.
32
4. Access to the rear seats (3-door).
5. Height adjustment. Steering wheel adjustment
1. Unlocking of the control.
2. Adjustment of the height.
3. Locking of the control.
38
Page 10 of 113
FAMILIARISATION
MONITOR THOROUGHLY
1. When the ignition is on, the orange
and red warning lights come on.
2. When the engine is running, these
warning lights should switch off.
If warning lights remain on, refer to the
page concerned.
Warning lights
16
Instrument panel
A. When the ignition is on, the fuel
gauge needle should rise.
B. When the engine is running, the
associated low level warning light
should switch off.
If the levels are not correct, top up as
required.
15 Controls
A. Passenger air bag disarming.
58
B. Heated seats control.
33
C. Deactivation of the ESP/ASR.
54
D. Central locking/unlocking.
44
Page 14 of 113
!
17
When the engine is running or the
vehicle is moving, the lighting of one of
the following warning lights indicates
the occurrence of a fault which requires
action on the part of the driver. Centralised alert.
Lighting of the centralised alert
is associated with the lighting
of another warning light:
- braking,
- engine oil pressure,
- coolant temperature.
It is imperative that the vehicle is stopped as soon as it is safe to do so.
Anti-lock braking system (ABS).
The lighting of this warning light
indicates the occurrence of a
fault in the anti-lock braking
system.
However, this does not prevent the oper-
ation of the vehicle's assisted braking.
Air bags.
The lighting of this warning light
indicates the occurrence of a
fault in the air bags system or
the pre-tensioning seat belts.
Any fault resulting in the lighting of
a warning light must be the subject
of further diagnostics by reading
the associated message on the
multifunction display.
If a problem arises, do not hesitate
to contact a PEUGEOT dealer.
Warning lights
Passenger air bag disarmed.
The lighting of this warning light
indicates that the passenger
air bag is disarmed. It remains
on until the passenger air bag is reac-
tivated.
Flashing of this warning light indicates
the occurrence of a fault in the air bags
system. Consult a PEUGEOT dealer.
Page 16 of 113
!
17
When the engine is running or the
vehicle is moving, the lighting of one of
the following warning lights indicates
the occurrence of a fault which requires
action on the part of the driver. Centralised alert.
Lighting of the centralised alert
is associated with the lighting
of another warning light:
- braking,
- engine oil pressure,
- coolant temperature.
It is imperative that the vehicle is stopped as soon as it is safe to do so.
Anti-lock braking system (ABS).
The lighting of this warning light
indicates the occurrence of a
fault in the anti-lock braking
system.
However, this does not prevent the oper-
ation of the vehicle's assisted braking.
Air bags.
The lighting of this warning light
indicates the occurrence of a
fault in the air bags system or
the pre-tensioning seat belts.
Any fault resulting in the lighting of
a warning light must be the subject
of further diagnostics by reading
the associated message on the
multifunction display.
If a problem arises, do not hesitate
to contact a PEUGEOT dealer.
Warning lights
Passenger air bag disarmed.
The lighting of this warning light
indicates that the passenger
air bag is disarmed. It remains
on until the passenger air bag is reac-
tivated.
Flashing of this warning light indicates
the occurrence of a fault in the air bags
system. Consult a PEUGEOT dealer.
Page 19 of 113
ii
ii
21
Following this operation, if you wish
to disconnect the battery, lock the
v e h i c l e a n d w a i t a t l e a s t fi v e m i n u t e s
for the zero reset to be taken into
account.
Maintenance indicator zero reset
After each service, the maintenance
indicator must be reset to zero.
The procedure for resetting to zero is as
follows:
switch off the ignition,
press and hold the trip distance
recorder zero reset button,
switch on the ignition; the distance
recorder display begins a count-
down,
when the display indicates "=0" ,
release the button; the spanner dis-
appears.
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Service overdue
For 5 seconds after the ignition is
switched on,
t h e s p a n n e r fl a s h e s to
indicate that the service must be carried
out as soon as possible.
Example: the service is overdue by
300 miles/km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the distance recorder resumes
its normal operation. The spanner
remains lit .
Page 20 of 113
22
Total distance recorder
System which measures the total dis-
tance travelled by the vehicle during its
life. Lighting rheostat
System for manual adjustment of the
brightness of the instrument panel in
relation to the exterior brightness.
The total and trip distances are displayed for thirty seconds when the ignition is
switched off, when the driver's door is
opened and when the vehicle is locked
or unlocked.
Trip distance recorder
System which measures a distance
travelled during a day or other period
since it was reset to zero by the driver.
With the ignition on, press the button
until zeros appear. Activation
When the lights are on:
press the button to change the
brightness of the instrument panel,
when the lighting reaches the mini-
mum setting, release the button,
then press again to increase it,
or
when the lighting reaches the maxi-
mum setting, release the button,
then press again to reduce it,
when the lighting reaches the level
of brightness required, release the
button.
Deactivation
When the lights are off, pressing the
button does not have any effect.
Page 21 of 113
23
MONOCHROME DISPLAY A Adjusting the parameters
Press and hold button 1 for two seconds
t o a c c e s s t h e s e t t i n g s ; t h e d a t a fl a s h e s ,
i n d i c a t i n g i t i s r e a d y t o b e m o d i fi e d .
Then, each press of button 1 scrolls
through the various data in the follow-
ing order:
- language of information displayed,
- hours (12 then 24 hour mode),
- minutes,
- year,
- month,
- day,
- unit of temperature (degrees Cel- sius or Fahrenheit).
Pressing button 2 a l l o w s m o d i fi c a t i o n
of the data selected. Press and hold for
rapid advance (return to start after the
last possible value).
After 7 seconds with no action, the main
d i s p l a y r e t u r n s ; t h e m o d i fi e d d a t a a r e
now recorded.
Note: Pressing button 2 b r i e fl y d i s p l a y s
the outside temperature for a few seconds.
When the outside temperature is be-
tween -3° and 3°C, the outside tempera-
ture display on the screen takes priority
over the clock display.
This displays the following information:
- the time,
- the date,
- t h e o u t s i d e t e m p e r a t u r e * ( t h i s fl a s h e s
when it is between -3 and 3°C),
- the audio system displays,
- a door check (e.g.: ''left front door open''),
- warning messages (e.g. ''remote c o n t r o l b a t t e r y fl a t ' ' ) o r i n f o r m a t i o n
messages (e.g. ''economy mode
active''), displayed temporarily.
* With automatic air conditioning only.