ESP Peugeot 208 2012 Owner's Guide

172
Practical information
System which manages the duration of use of certain functions to retain a sufficient level of charge in the battery.

After the engine has stopped, you can still usefunctions such as the audio and telematics system, windscreen wipers, dipped beam headlamps, cour tesy lamps, etc. for amaximum combined duration of about thir tyminutes.








Electrical energy economy mode


Switching to economy mode
Once this time has elapsed, a message
appears in the screen indicating that the vehicle
has switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time, it
will
be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.


Exiting economy mode

These functions are reactivated automaticallynext time the vehicle is driven.
)To restore these functions immediately,start the engine and let it run for at least five minutes.

A flat battery prevents the engine from starting (refer to the corresponding section).

173
7
Practical information








Changing a wiper blade
Before removing a front
wi
per blade
) Within one minute after switching off
the ignition, operate the wiper stalk to
position the wiper blades vertically on the
windscreen.

Removing
)
Raise the corresponding wiper arm. )
Unclip the wiper blade and remove it.



Fitting
)
Put the corresponding new wiper blade inplace and clip it.
)
Fold down the wiper arm carefully.



After fitting a front wiper
blade
) Switch on the ignition.)
Operate the wiper stalk again to park the
wiper blades.

178
Practical information











Fitting roof bars


Maximum authorised weight on the roof rack, for a loading height not exceeding40 cm (with the exception of bicycle carriers): 65
kg.
If the height exceeds 40 cm, adapt thespeed of the vehicle to the profile of theroad to avoid damaging the roof bars and the fixings on the roof.
Be sure to refer to national legislation in order to comply with the regulations for transporting objects which are longer than the vehicle. When fittin
g transverse roof bars, take care toposition them correctly on the retaining pins
located in the door aper tures.
Use accessories recommended by PEUGEOT obser ving the
manufacturer's recommendations and fitting instructions so as to avoid the risk of damaging the body (deformation, scratches, ...).

190
Checks
On vehicle fitted with HDi engines, the fuelsystem must be primed if you run out of fuel; refer to the engine compar tment view on the
"Diesel engine" section.
If the tank on your vehicle is fitted with a misfuel prevention device, refer to the corresponding section.











Running out of fuel (Diesel)


If the engine does not star t first time, don't keep trying. Start the procedureagain from the beginning.

)
Fill the fuel tank with at least five litres of
diesel. )
Open the bonnet.)
Press and release the priming pump until
resistance is felt (there may be resistanceon the first press).
) Operate the star ter until the engine star ts. )
Close the bonnet.



1.4 litre HDi engine
)Fill the fuel tank with at least five litres of diesel.)Open the bonnet. )If necessary, unclip the styling cover for access to the priming pump. )Squeeze and release the priming pump
repeatedly until resistance is felt (there maybe resistance at the first press).)Operate the star ter until the engine star ts (if the engine does not star t at the first attempt, wait around 15 seconds before
trying again).)If the engine does not star t after a few attempts, operate the priming pump again
then start the engine. )Clip the styling cover back in place.)Close the bonnet.

1.6 litre HDi engine

191
8
Checks






Checking levels
Oil level
The check is carried out either when
the ignition is switched on using the
oil level indicator on the instrument panel, or
using the dipstick.
This manual check will only be correct if the
vehicle is on level ground and the engine has
been o
ff for more than 30 minutes.
Engine oil change
Refer to the servicing booklet for details of theinterval for this operation.
In order to maintain the reliability of the engine and emission control system, the use of additives in the engine oil is prohibited.
Oil specifi cation
The oil must be the correct grade for your
en
gine and conform to the manufacturer'srecommendations.
Th
e brake fluid level should be closeto the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level

Changing the fl uid

Refer to the servicing booklet for details of the
interval for this operation.


Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet theDOT4 standard.



Take care when working under the
bonnet, as certain areas of the enginemay be extremely hot (risk of burns).
If a level drops si
gnificantly, have the corresponding system checked by a PEUGEOT dealer or a qualified workshop.
Check all of these levels regularly and top them up if necessary, unless other wise indicated.
It is normal to top up the oil levelbetween two ser vices (or oil changes).PEUGEOT recommends that you check the level, and top up if necessary, every3 000 miles (5 000 kms).

After topping up the oil, the check when switching on the ignition with the oil levelindicator in the instrument panel is not validduring the 30 minutes after topping up.

05





PRESET A STATION

From the permanent display, press "Memory".

Select a radio station or frequency
(refer to the corresponding section).

Select a number in the list to preset thepreviously chosen radio station.
A long press on this number presets the station.

Recall
pre-set stations

Press MENUto display the " MAIN MENU " then select " Media".
Select "Radio".
RADIO
Select "Memory".
240

261

Access to the "Settings" menu (continued)
"Vehicle settings"
"VEHICLE DIAGNOSTICS"
- List of faults detected (depending on version) in the vehicle. B3
For more information on a setting, refer to the section on
the corresponding function.
"Speed memorised"
- Memorise speed settings for use by the cruise control or speedB4 limiter.- Choose from the categories: "Driving assistance", "Vehicle B1 access", "Lighting". If no family is chosen, the complete list of functions is displayed.
- Select the function, a descriptive text and image provides detailsB2 of the function. The settings of some can be adjusted.
Select/deselect to activate/deactivate the function.
- Choose a speed to see the details. Press again to select it. B41
- With the speed(s) selected, press "Activate speed" to memorise B42 the speeds.
To deactivate all speeds, press "Activate speed".
- Select or deselect all speeds.B43
- Programme the speeds with default values.B44
- Modify the speed selected.B45
"Audio"
- Distribution: set the dominant position for sound in the vehicleC2 making use of the Arkamys©
system.
Move the point between the left (L) / right (R) and front (F) / rear (R).
- Choose the sound level when you touch the screen with a fi nger C3 (keypad beep). Activate the sound level depending on vehicle
speed.
- Choose the audio ambience (Jazz, Classic, Pop Rock, Techno,C1 Vocal) or personalise the ambience with treble / bass andactivate loudness.
- Choose the volume for the voice giving the names of streets.
C5
"Ambience"


"Ringtones"


- Choose the melody and the volume for the ringtone used for an
C4 incoming call.

01
272
FIRST STEPS


Select the source:
- FM1, FM2, AM, CD, USB, AUX, Streaming.
- accept an incoming call.
Long press:- open the calls log for thetelephone connected. pgpg
- or end a call if in progress.

Adjust audio settings:
sound ambience, treble,
bass, loudness, distribution,
left/right balance, front/rear balance, automatic volume. On / Off and volume
adjustment.
A
bandon the current
operation.
Go up one level (menu or folder).
Eject CD.

Select a
preset radio station.
Radio: long press: preset a
radio station.
Other than radio: see the corresponding sections.
Automatic search for a lower / higher radio
frequency.
Select previous / next CD, USB track.
Navigation in a list.
Pr
ess and hold: fast forwards or backwards.
Open the main menu.

Display the list of stations received, theCD/USB tracks or folders.
Lon
g press: update the list of stationsreceived.

03
274
RADIO
Press SRC/TEL
repeatedly and select
the FM1, FM2 or AM waveband.
Press a button to listen to the corresponding preset station.
Select the desired radio station and confi rm by pressing "OK".







RADIO

Press LIST
to display the list of stations
received in alphabetical order.
The exterior environment
(hills, buildings, tunnel, car park, below ground...) may prevent reception, even in RDS station tracking (alternative frequencies) mode. This phenomenon is normal in the propagation of radio waves and is in no way indicative of a fault with the audio system.

A long press on LIST
builds or updates
the list of stations; audio reception is cut
momentarily.
Make a lon
g press on one of the buttons
to preset the station being listened to.
The name o
f the station is displayed andan audible signal confi rms the preset.

A press chan
ges to the next or previous
letter (e.g. A, B, D, F, G, J, K, ...). MANAGE THE LIST
PRESETTING AND SELECTING A STATION
When recalling a preset station, of the reception of the station is poor, the radio will try to fi nd a frequency transmitting the same programme and a message appears in the screen.

08
291
SCREEN MENU MAP
1
2
2
2
2
1
2
2
2
1
2
2
2
2
3
3
1
2
2
4
4
4
1
2
3
2
3
3
3
3
3
3
3
2
2
3
3
3
MENU
Radi
o
TA
RD
S
TXT
Write freq.
Media
Normal
Random
Random all
Telephone
Call
Repeat
TA
Phone status
Directory
Calls list
Bluetooth
BT mana
gement
Search
Missed calls
Dialed calls
An
swered calls
Confi g.
Displaying
Scrollin
g text
Language
D
eutsch
En
glish
Español
Français
It
aliano

Nederlands

Português
Version
System Portu
guês-Brasil
Р
усский
T
ürkçe
2Time