instrument panel Peugeot 208 2013 - RHD (UK, Australia) Owner's Guide

96
Driving





Hill start assist
System which keeps your vehicle immobilised
temporarily (approximately 2 seconds) whenstarting on a gradient, the time it takes to
move your foot from the brake pedal to the accelerator pedal.
This function is only active when:
- the vehicle is completely stationary, withyour foot on the brake pedal,
- when cer tain conditions of gradient are met,
- with the driver’s door closed.
The hill start assist function cannot bedeactivated.
On an ascendin
g slope, the vehicle is held
for a brief moment when you release the
brake pedal:


- if you are in first gear or neutral with a
manual gearbox * ,

- if you are in position Aor Mwith an electronic gearbox,

- if you are in position Dor Mwith an
automatic gearbox.



Operation
On a descending slope, with the vehicle
stationary and reverse gear engaged, thevehicle is held for a brief moment when you release the brake pedal.

Do not leave the vehicle while it is beingheld in the hill star t assist phase.
If you need to leave the vehicle whilethe engine is running, apply the parking brake manually then ensure that theparking brake warning lamp is on (not flashing) in the instrument panel.


Operating fault

If a fault occurs with the system, these warninglamps come on. Contact a PEUGEOT dealer
or a qualified workshop to have the systemchecked.

* Depending on version.

97
4
Driving





Speed limiter


System which prevents the vehicle fromexceeding the speed programmed by the driver.
When the programmed speed limit is reached,
pressing the accelerator pedal in the normalmanner no longer has any effect.

The speed limiter is switched onmanually: the programmed speed must be at least 20 mph(30 km/h).

The speed limiter is switched offby manual foperation of the control.

The programmed speed can be exceeded
temporarily by pressing the accelerator firmly.
To return to the programmed speed, simply slow down to a speed below the programmed speed.


The speed limiter cannot, in any circumstances, replace the need to respect speed limits, nor can it replace the need for vigilance andresponsibility on the par t of the driver.

1.Selection of speed limiter mode.
2. Speed limiter on/off.
Steering mounted controls

The programmed information is grouped
together in the instrument panel screen.
5.Speed limiter on/off indication.
6. Speed limiter mode selection indication. 7.Programmed speed value.8.
Selection of a memorised speed setting.


Displays in the instrument panel
The programmed speed remains in the memory
when the ignition is switched off.
3. Increase the programmed value.
4. Decrease the programmed value.

99
4
Driving




Cruise control
speed of the vehicle at the value programmed
by the driver, without any action on the
accelerator pedal.

Th
e cruise control is switched off
manually for by pressing the brake or clutch pedal or on
triggering of the electronic stability system for safety reasons.
It is possible to exceed the programmed speed
temporarily by pressing the accelerator pedal.
To return to the programmed speed, simply
release the accelerator pedal.
Switching off the ignition cancels any programmed speed value.
1
.Selection of cruise control mode.
2. Cruise control stop/resume.
Steering mounted controls

The cruise control cannot, in any circumstances,replace the need to respect speed limits, nor canit replace the need for vigilance and responsibilityon the par t of the driver.


The programmed information is grouped
together in the instrument panel screen.
5.Cruise control stopped/resumed indication.
6. Cruise control mode selection indication.
7. Programmed speed value.8. Selecting a memorised speed setting.


Displays in the instrument panel
3.
Increase the programmed value. 4.
Decrease the programmed value. Th
e cruise control is switched on
manually: it
requires a minimum vehicle speed of 25 mph (40 km/h), as well as the engagement of:


- fourth gear on a manual gearbox,

- second gear on an electronic or automatic
gearbox, in manual sequential mode,

- position A
on an electronic gearbox or position D
on an automatic gearbox.

101
4
Driving








Memorising speeds
This memorisation of speeds applies to both the speed limiter and the cruise control.
You can memorise up to 5 speed settings in the system. By default, a few speeds are already memorised.


Memorisation

To select a memorised speed: )
press and hold button " + " or "- "; the systemstops at the closest memorised speed,)
press and hold button " +
" or "-
" again toselect another memorised speed.

A reminder of the speed and the state of thesystem (on / off) is displayed in the instrument
panel.
) Go to the main menu bypressing MENU.
For safety reasons, the driver mustcarry out these operations when stationary.


Selection
)Select the "Preferences" menu then "Vehicle".)Select the "Vehicle configuration" menu
then "Speeds memorised". )Choose the speed setting you want tomodify then select "Modify speed".)Enter the desired speed and press confirm
to save the modifications.

104
Driving
The assisted parking manoeuvre is in progress.
Without exceeding 5 mph (8 km/h), continue the manoeuvres following the information given by
the "parking assistance" system, until the end
of manoeuvre message is displayed.
The indicator lamp in the control goes off, accompanied by a audible signal.
Th
e driver takes back control of the vehicle's
steering.



Exit from a parking space
)
With the vehicle stationary, press this control to activate the Park Assist system.
A message is displayed in the screen. The
indicator lamp in the control remains o
ff. ) Select the exit parking space manoeuvre.
The indicator lamp in the control comes on.
) Operate the direction indicator on the exit from parking side.
The direction indicator warning lamp flashes in the instrument panel throughout
the manoeuvre, whatever the position of
the stalk.
) Select a forward or reverse gear then
release the steering wheel.

)
When you want to exit from a parallel
parking space, star t the engine.

The assisted exit from parking manoeuvre is inprogress.
Without exceeding 5 mph (8 km/h), continue the
manoeuvres following the information given by
the "parking assistance" system, until the end of
manoeuvre message is displayed.
The manoeuvre is complete once the front wheels
of the vehicle are out of the parking space.
The indicator lamp in the control goes off,accompanied by a audible signal.


The driver takes back control of the vehicle'ssteering.

105
4
Driving
In bad weather and in winter, ensure that the sensors are not covered by road dir t, ice or snow.
In the event of a fault, have the systemchecked by a PEUGEOT dealer or a qualified workshop.



If the system is deactivated during a manoeuvre, the drive should reactivateit manually to repeat the measurement.



If the lateral distance between your vehicle and the space is too great, the system maynot be able to measure the space.
Anything projecting beyond the envelope of the vehicle (long or wide load) is not taken into account by the Park Assist systemduring a manoeuvre.


Deactivation

A message is displayed in the screen.
Th
e driver then takes back control of thevehicle's steering. The system is deactivated automatically:


- on switchin
g off the ignition,

- if the engine stalls,

- if no manoeuvre is star ted within 5 minutes
of selection of the type of manoeuvre,

- after a prolonged stop of the vehicle during a manoeuvre,

- if the road wheel anti-spin regulation (ASR) is triggered,

- if the speed of the vehicle exceeds thestated limit,

- when the driver interrupts movement of the
steering wheel,

- if the driver presses the Park Assist control,

- if correct positionin
g of the vehicle is not possible (too many manoeuvres needed to
inser t or extract the vehicle),

- if the driver's door is open,

- if one of the front wheels encounters anobstacle.
Switching off
The system is switched off automatically:
- when towing a trailer,
- if the driver's door is opened,
- if the speed of the vehicle is above 42 mph(70 km/h).
To switch the system of for a prolonged period, contact a PEUGEOT dealer or a qualified
workshop.


Operating faults
In the event of a fault with thesystem, this warning lamp is
displayed in the instrument panel and/or a
message appears in the screen, accompanied
by an audible signal (short beep).
The indicator lamp in the control flashes for a
few seconds. If the problem occurs while using
the system, the indicator lamp goes off.
In th
e event of a fault with
the power steering, these
warning lamps come on in
the instrument panel.
Contact a PEUGEOT dealer or a qualified
workshop.

107
4
Driving
that the sensors are not covered with mud, ice or snow. When reverse gear isengaged, an audible signal (long beep)indicates that the sensors may be dirty. Cer tain sound sources (motorcycle, lorry, pneumatic drill, etc.) may trigger the audible signals of the parking
sensor system. In th
e event of a malfunction of
t
he system, when reverse gear
is engaged this warning lamp is
displa
yed in the instrument panel and/or a
message appears in the screen, accompanied
by an audible signal (short beep).
Contact a PEUGEOT dealer or a qualified
workshop.

Operating fault
The function will be deactivated automatically if a trailer is being towedor a bicycle carrier is fitted (vehicle fitted with a towbar or bicycle carrier recommended by PEUGEOT).




Deactivation / Activation of the
rear parking sensors
The function is deactivated by pressing this switch. The indicator lamp in the switch comes on.
Pressing this switch again reactivates the
function. The indicator lamp in the switch
goes off.

111
5
Visibility


Model without AUTO lighting



Model with AUTO lighting



Selection ring for main lighting mode

Turn the ring to position the symbol required
facing the mark.

Li
ghting off.
Automatic illumination of headlamps.


Sidelamps onl
y.

Di
pped or main beam headlamps.

Dipping the headlamps

Pull the stalk to switch the lighting between
dipped / main beam headlamps.

In the li
ghting off and sidelamps modes, the driver can switch on the main beam headlamps
temporaril
y ("headlamp flash") by maintaining apull on the stalk.


Displays

Illumination of the corresponding indicator lamp
in the instrument panel confirms the lighting switched on.

114
Visibility
Daytime running lamps
Daytime lighting, compulsory in cer tain
countries, which comes on automatically when
the engine is star ted making the vehicle more
visible to other users.
LED lamps
They come on when the engine is star ted.
Depending on the country of sale, they are used for:
- daytime running lamps * in day mode and
sidelamps in night mode (they are brighter
when daytime running lamps), or
- sidelamps in day and night mode.

*

Function that can be set in the vehicleconfiguration menu.
Thi
s function is assured:


- in countries where it is imposed by
re
gulations,
by illumination of the dipped beam
headlamps with the sidelamps and number
plate lamps; this function cannot be
deactivated.

- for other countries where it is provided,
by the use of dedicated lamps (bulbs or
LEDs); this function can be activated or
deactivated via the vehicle configurationmenu.
The lighting control stalk must be placed in
th
e "0"
or "AUTO"
(day mode) position.
Deactivation of the daytime running lamps iseffective after operation of the lighting control
stalk or after the next engine start; activation iseffective immediately.

The instruments and controls
(instrument
panel, multifunction screen, air conditioning control panel, ...) are not illuminated, except
in night mode with manual or automatic
illumination of headlamps.

115
5
Visibility
headlamps on after the vehicle's ignition hasbeen switched off makes the driver's exit easier
when the light is poor.
Manual guide-me-home
lighting

Switching on
)With the ignition off, "flash" the headlamps
using the lighting stalk.
)A fur ther "headlamp flash" switches the
function off.
Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down depending on the traffic side (for example: when parking on the left; lighting
control stalk upwards; the right hand sidelamps are on).
Manual
guide-me-home lighting is also available from the remote control lighting button (see the "Remotecontrol" section). This is con
firmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the middle position or switch on the ignition.