ESP Peugeot 208 2013 Owner's Guide

173
7
Practical information
Fuse N°RatingFunctions
F1
615 A Front foglamps.
F18 10 A
Right hand main beam headlamp.
F1
910 A
Left hand main beam headlamp.
F25
30 A Headlamp wash relay (accessory).
F2
940 A Front wiper motor.
F3
080 A
Pre-heater plugs (Diesel).


Engine compartment fuses

The fusebox is placed in the engine compartment near the battery (left-hand side).


Access to the fuses
)Unclip the cover. )Change the fuse (see corresponding paragraph).)When you have finished, close the cover carefully to ensure correct sealing of the
fusebox.

Fuse table

176
Practical information








Load reduction mode

System which manages the use of cer tain
functions according to the level of charge
remaining in the battery.
When the vehicle is bein
g driven, the load
reduction function temporarily deactivates certain functions, such as the air conditioning,
the heated rear screen...
The deactivated functions are reactivated
automatically as soon as conditions permit.

It is advisable to disconnect the battery if the vehicle is to be left unused for more than one month.
The batteries contain harmful substances such as sulphuric acid and lead. Theymust be disposed of in accordance with regulations and must not, in anycircumstances, be discarded with household waste.
Take used remote control batteries andvehicle batteries to a special collection point.

Do not reverse the polarity and use only a 12 V charger. Do not disconnect the terminals whilethe engine is running.
Do not charge the batteries without disconnecting the terminals first.
Do not push the vehicle to star t the engine if you have an electronicgearbox or automatic gearbox.







Before disconnecting the battery

Wait 2 minutes after switching off the ignitionbefore disconnecting the battery.

Close the windows and the doors beforedisconnecting the battery.

Following reconnection of thebattery

Following reconnection of the battery, switch on
the ignition and wait 1 minute before star ting to
permit initialisation of the electronic systems.However, if problems remain following this
operation, contact a PEUGEOT dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:


- the remote control key,

- the on-board satellite navi
gation system.

177
7
Practical information
System which manages the duration of use of certain functions to retain a sufficient level of charge in the battery.

After the engine has stopped, you can still use functions such as the audio andtelematics system, windscreen wipers, dipped
beam headlamps, cour tesy lamps, etc. for a maximum combined duration of about
thirty minutes.








Electrical energy economy mode
Switching to economy
mode
Once this time has elapsed, a message appears in the screen indicating that the vehiclehas switched to economy mode and the activefunctions are put on standby.
I
f a telephone call is being made at this time, it will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.


Exiting economy mode

These functions are reactivated automatically
next time the vehicle is driven.
) To restore these functions immediately,start the engine and let it run for at least five minutes.

A flat battery prevents the engine from starting (refer to the correspondingsection).

178
Practical information








Changing a wiper blade
wiper blade
)
Within one minute after switching off
the ignition, operate the wiper stalk to
position the wiper blades vertically on the
windscreen.


Removing
)
Raise the corresponding wiper arm. )
Unclip the wiper blade and remove it.



Fitting
)Put the corresponding new wiper blade inplace and clip it.
)Fold down the wiper arm carefully.



After fitting a front wiper
blade
)Switch on the ignition.)Operate the wiper stalk again to park the
wiper blades.

183
7
Practical information











Fitting roof bars


Maximum authorised weight on the roof rack, for a loading height not exceeding 40 cm (with the exception of bicycle carriers): 65
kg
If the height exceeds 40 cm, adapt thespeed of the vehicle to the profile of the road to avoid damaging the roof barsand the fixings on the roof.
Be sure to refer to national legislation in order to comply with the regulations for transporting objects which are longer than the vehicle.
When fittin
g transverse roof bars, take care to position them correctly on the retaining pins
located in the door aper tures.
Use accessories recommended by PEUGEOT obser ving the
manufacturer's recommendations and fitting instructions so as to avoid the risk of damaging the body (deformation, scratches, ...).

186
Practical information
The fitting of electrical equipment or accessories which are not
recommended by PEUGEOT may resultin a failure of your vehicle's electronicsystem and excessive electricalconsumption.
Please note this precaution. You are advised to contact a PEUGEOTrepresentative to be shown the range of recommended equipment and accessories.


Installation of radio communication transmitters

Before installing any after-market radiocommunication transmitter, you can contact a PEUGEOT dealer for thespecification of transmitters which can be fitted (frequency, maximum power, aerial position, specific installation requirements), in line with the Vehicle Electromagnetic Compatibility Directive (2004/104/EC).


Depending on the legislation in forcein the country, it may be compulsory to have a high visibility safety vest, warning triangle and spare bulbs andfuses available in the vehicle.
B
y visiting a PEUGEOT dealer, you can also
obtain products for cleaning and maintenance(exterior and interior) - including ecological
products in the "TECHNATURE" range, topping up products (screenwash...), touch-up pens
and paint aerosols for the exact colour of your
vehicle, refills (cartridge for the temporary
puncture repair kit...), ...
"Multimedia":
audio systems, por table satellite navigation systems, semi-integral suppor t for por tablesatellite navigation system, hands-free kit, CDchanger, speakers, DVD player, connection kit for MP3 or CD player, USB Box, Wi-Fi on-board...

195
8
Checks
On vehicle fitted with HDi engines, the fuel system must be primed if you run out of fuel;
refer to the engine compar tment view on the
"Diesel engine" section.
If the tank on your vehicle is fitted with
a misfuel prevention device, refer to the corresponding section.












Running out of fuel (Diesel)


If the engine does not star t first time, don't keep trying. Star t the procedure again from the beginning.

)
Fill the fuel tank with at least five litres of
diesel.)
Open the bonnet.)
Press and release the priming pump until resistance is felt (there may be resistance
on the first press).
) Operate the star ter until the engine star ts. )
Close the bonnet.
1.4 litre HDi engine
)
Fill the fuel tank with at least five litres of diesel. )
Open the bonnet. )
If necessary, unclip the styling cover for
access to the priming pump. ) Squeeze and release the priming pump
repeatedl
y until resistance is felt (there may
be resistance at the first press). ) Operate the star ter until the engine star ts (if the engine does not star t at the first
attempt, wait around 15 seconds before
trying again).) If the engine does not star t after a few
attempts, operate the priming pump again
then star t the engine. ) Clip the styling cover back in place.)
Close the bonnet.



1.6 litre HDi engine

196
Checks






Checking levels
Oil level


The check is carried out either when
the ignition is switched on using theoil level indicator in the instrument
panel, or using the dipstick.

Engine oil change

Refer to the ser vicing and warranty booklet for
details of the inter val for this operation.
In order to maintain the reliability of the engine
and emission control system, the use of
additives in the engine oil is prohibited.

Oil specifi cation

The oil must be the correct grade for your engine and conform to the manufacturer'srecommendations.
Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level

Changing the fl uid

Refer to the servicing and warranty booklet for
details of the interval for this operation.

Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet the
DOT3 or DOT4 standard.



Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could star t at
any time (even with the ignition off).
If a level drops si
gnificantly, have the corresponding system checked by a PEUGEOT dealer or a qualified workshop. Check all of these levels regularly, in line with the ser vicing booklet and the requirements of the warranties. Top them up if necessary, unless other wise indicated.
It is normal to top up the oil levelbetween two ser vices (or oil changes). PEUGEOT recommends that you check the level, and top up if necessary, every3 000 miles (5 000 kms).

After topping up the oil, the check whenswitching on the ignition with the oil level
indicator in the instrument panel is not valid
durin
g the 30 minutes after topping up. It will onl
y be correct if the vehicle is on level ground and the engine has been off for more
than 30 minutes.

9
201
Technical data
.../S: model fitted with Stop & Star t.















Petrol engines and gearboxes
Engines1 litre VTi68 hp1.2 litre VTi 82 hp1.4 litre VTi 95 hp
Gearboxes

Manual(5-speed)
Manual (5-speed)

Electronic (5-speed)

Manual (5-speed)

Model codes: CC... CA...

ZMZ0


HMZ0 - HMX0
HMZ0/PS

8FP0 - 8FN0


Cubic capacity (cc) 999

1 1991 397
Bore x stroke
(mm)
71 x 84.1
75 x 90.577 x 75

Max power: EU standard (kW)
* 50
60

70

Max power engine speed
(rpm)
6 000 5 750 6 000
Max torque: EU standard
(Nm)95

118

136

Max torque en
gine speed (rpm) 3 000
2 750
4 000

Fuel Unleaded Unleaded Unleaded

Catalytic converter yes yes
yes

OIL CAPACITIES
(in litres)
Engine (with filter replacement) 3.13
3.13

4.25

*
The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation (directive 1999/99/EC).

202
Technical data
Engines1.6 litre VTi120 hp1.6 litre THP 155 hp1.6 litre THP 200 hp
GearboxesManual (5-speed)
Automatic(4-speed)


Manual (6-speed)


Manual(6-speed)
Model codes: CC... CA...
5FS0

5FS9
5FV8

5FU8
Cubic capacity (cc) 1 598
1 598

1 598

1 598

Bore x stroke (mm)77 x 85.8

77 x 85.8

77 x 85.8

77 x 85.8

Max power: EU standard
(kW)
* 88
105 115147
Max power engine speed
(rpm)
6 000 6 000 6 000 5 250
Max torque: EU standard
(Nm) 160
152 240275

Max torque engine speed (rpm)
4 250
3 560

1 400

1 770

F
uel Unleaded UnleadedUnleadedUnleaded

Catalytic conver ter yes yes
yes
yes
OIL CAPACITIES (in litres)

Engine (with filter replacement) 4.25
4.25
4.25

4.25
* The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation (directive 1999/99/EC).

Petrol engines and gearboxes