ignition Peugeot 208 2013 Owner's Guide

109
5
!
Visibility
If the mirrors are folded using control A , they will not unfold when the vehicle is unlocked. Pull again on control A.


The folding and unfolding of the door mirrors using the remote control can bedeactivated by a PEUGEOT dealer or a qualified workshop.
Fold the mirrors when putting your vehicle through an automatic car wash.




Folding



- Automatic: lock the vehicle using the remote control or the key.

- Manual: with the ignition on, pull control Arearwards.


Unfolding



- Automatic: unlock the vehicle using the remote control or the key.

- Manual: with the ignition on, pull control Arearwards.

Automatic day/night model

By means of a sensor, which measures the
light from the rear of the vehicle, this system
automatically and progressively changes
between the day and night uses. Adjustable mirror providing a central rear ward
vi
ew.
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the nuisance to the driver caused by the sun,headlamps from other vehicles...
Rear view mirror
Manual day/night model
Adjustment
)
Adjust the mirror so that the glass is
directed correctl
y in the "day" position.
Day / night position
) Pull the lever to change to the "night" anti-
dazzle position.
) Push the lever to change to the normal "day" position.



In order to ensure optimum visibilityduring your manoeuvres, the mirror lightens automatically when reversegear is engaged.


As a safety measure, the mirrors shouldbe adjusted to reduce the "blind spot".

113
5
Visibility
In good or rainy weather, both dayand night, the front foglamps and the rear foglamp are prohibited. In thesesituations, the power of their beamsmay dazzle other drivers. They shouldonly be used in fog or snow. In these weather conditions, it is your responsibility to switch on the foglamps and dipped beam headlamps manuallyas the sunshine sensor may detect sufficient light.
Do not forget to switch off the front foglamps and the rear foglamp whenthey are no longer necessary.


Switching on the lamps after the ignition isswitched off

To reactivate the lighting control, rotatethe ring to the "0"position - lamps off,then to the desired position. On opening the driver's door a temporary audible signal warns thedriver that the lighting is on.
The lamps, with the exception of thesidelamps, switch off automatically after a maximum duration of thir ty minutes to prevent discharging of the battery.

Switching off the lampswhen the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately, except for dipped beam if guide-me-home lighting is activated.

115
5
Visibility
headlamps on after the vehicle's ignition hasbeen switched off makes the driver's exit easier
when the light is poor.
Manual guide-me-home
lighting

Switching on
)With the ignition off, "flash" the headlamps
using the lighting stalk.
)A fur ther "headlamp flash" switches the
function off.
Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.) Within one minute of switching off the
ignition, operate the lighting control stalk up
or down depending on the traffic side (for example: when parking on the left; lighting
control stalk upwards; the right hand sidelamps are on).
Manual
guide-me-home lighting is also available from the remote control lighting button (see the "Remotecontrol" section). This is con
firmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch o
ff the parking lamps, return the
lighting control stalk to the middle position or switch on the ignition.

121
5
Visibility
Automatic rain sensitive
windscreen wi
pers
The windscreen wipers operate automatically,
without an
y action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.

Switching on

Briefly push the control stalkdownwards.
This warning lamp comes on in the
instrument panel and a message is
displayed.Brie
fly push the control stalk
downwards again, or place thecontrol stalk in another position(Int, 1 or 2).
Switching off

The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if theignition has been off for more than oneminute. This warning lamp goes off in the instrumentpanel and a message is displayed.

122
Visibility
Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror. Switch off the automatic rain sensitivewipers when using an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of ice before activating the automatic rain sensitive wipers.

Operating fault
If a fault occurs with the automatic rain
sensitive wipers, the wipers will operate in intermittent mode.
Have it checked by PEUGEOT dealer or a qualified workshop.
Special position of the
w
indscreen wipers
This position permits release of the windscreen
wiper blades.
It is used for cleaning or replacement of the blades. It can also be useful, in winter, todetach the blades from the windscreen.


To maintain the effectiveness of the "flat-blade" type of wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- avoid using them to retain cardboard on the windscreen,

- replace them at the first signs of wear.


)
Any action on the wiper stalk in the minute
after switching off the ignition places the blades vertically on the screen.) To park the blades again, switch on theignition and operate the wiper stalk.

123
5
Visibility











Courtesy lamp
In this position, the cour tesy lamp comes on gradually:


Take care to avoid leaving anything in contact with the courtesy lamp. - when the vehicle is unlocked,
- when the ke
y is removed from the ignition,
- when opening a door,
- when the remote control locking button is
pressed, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- 30 seconds after the last door is closed.
Permanentl
y off.
Permanent lighting.
) With the ignition on, press
the corresponding switch.



1. Front cour tes
y lamp

2. Map reading lamp s
With the "permanent lighting" mode,the lighting time varies according to the circumstances:



- with the ignition off, approximately ten minutes,

- in energy economy mode, approximatelythirty seconds,-with the engine running, unlimited.



Front map reading lamps

125
6
Safety














Direction indicators
)Lower the lighting control stalk fully when moving to the left. )Raise the lighting control stalk fully when moving to the right.


"Motorway" function

Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash 3 times.
If you forget to cancel the direction indicators for more than twenty seconds, the volume of the audible signal will increase if the speed is above40 mph (60 km/h).







Hazard warning lamps
A visual warning by means of the direction indicators to aler t other road users to a vehicle
breakdown, towing or accident.
Automatic operation of
hazard warnin
g lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lamps come on automatically.
They switch off automatically the first time you accelerate.)
You can also switch them off by pressingthe button.
)
Press this button, the direction indicators
flash.
They can operate with the ignition off.

129
6
Safety
Dynamic stability control (DSC)

Activation
This system is activated automatically eachtime the vehicle is started.
It comes into operation in the event of a grip or
trajectory problem.
This is indicated b
y flashing of thiswarning lamp in the instrument panel.




Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground...), it may be advisable to deactivate
the DSC system, so that the wheels can move
freely and regain grip.

The DSC system offers exceptional safety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed.
The correct operation of the system depends on obser vation of the manufacturer's recommendationsregarding the wheels (tyres and rims),the braking components, the electronic components and the PEUGEOT assembly and operation procedures.
After an impact, have the system
checked by a PEUGEOT dealer or a qualified workshop.



Operating fault
If this warning lamp comes on,accompanied by an audible signaland a message in the screen, this
indicates a fault with the system.
Contact a PEUGEOT dealer or a qualified
workshop to have the system checked.
Reactivation
The system is reactivated automatically eachtime the ignition is switched back on or from 30 mph (50 km/h).)
Press the switch again to reactivate it
manually. But it is recommended that the s
ystem bereactivated as soon as possible.) Press the switch.
The indicator lamp in the switch comes on: the DSC system no longer acts on the operation of the engine.

131
6
Safety
Rear seat belts
The rear seats are each fitted with a three-point
seat belt, with force limiter and, for the outer
seats
, an effort limiter.
When the ignition is switched on, this warning lamp comes on in the instrument panel.

Seat belt not fastened /
unfastened warning lamp in the instrument panel
Fastenin
g
) Pull the strap, then inser t the tongue in thebuckle. )
Check that the seat belt is fastened correctly by pulling the strap.



Unfastening
)
Press the red button on the buckle.)
Guide the seat belt as it reels in.)
On the outer seat belts, raise the bar to the
top of the backrest to prevent the tongue from knocking against the side trim.



Seat belt unfastened warning lamp in the instrument panel
From approximately 12 mph (20 km/h) and for two minutes, this warning lamp
flashes, accompanied by an audible
signal of increasing volume, when one
or more rear passengers unfasten
their seat belt.
Once these two minutes have elapsed, this
warning lamp remains on until the one or more
rear passengers fasten their seat belt.
It r
emains on for a certain time if the frontpassenger has not fastened their seat belt. Once this period has elapsed, the warning lamp goes off if the driver's seat belt is fastened.
From approximately 12 mph (20 km/h)this warning lamp flashes for two minutes
accompanied by an audible signal of increasingvolume. Once these two minutes have elapsed,
this warning lamp remains on until the driver
and/or the front passenger fastens their seatbelt.

133
6
Safety
Airbags


System designed to maximise the safety of the
occupants (with the exception of the rear centrepassenger) in the event of violent collisions.
The airbags supplement the action of the force-
limiting seat belts (with the exception of the centre rear passenger).
If a collision occurs, the electronic detectors
record and analyse the front and side impacts sustained in the impact detection zones:


- in the case of a serious impact, the airbagsare deployed instantly and contribute
towards better protection of the occupants
of the vehicle
(with the exception of the rear centre passenger); immediately after the
impact, the airbags deflate rapidly so that
they do not hinder visibility or the exit of the
occupants,

- in the case of a minor or rear impact
or in cer tain roll-over conditions, the
airbags will not be deployed; the seat belt
alone contributes towards ensuring your protection in these situations.
The airbags do not operate when the ignition is switched off.
This equipment will only deploy once.
If a second impact occurs (during thesame or a subsequent accident), the airbag will not be deployed again.
Deployment of the airbag(s) is accompanied by a slight emission of smoke and a noise, due to theactivation of the pyrotechnic cartridgeincorporated in the system.This smoke is not harmful, but sensitiveindividuals may experience slight irritation.
The noise of the detonation may resultin a slight loss of hearing for a shorttime.
Impact detection zones
A.
Front impact zone.B.
Side impact zone.
Front airbags


Deployment

The airbags are deployed, except the passenger's front airbag if it has been deactivated, in the eventof a serious front impact to all or part of the front impact zone A
, in the longitudinal centreline of the
vehicle on a horizontal plane and directed from thefront to the rear of the vehicle.
The front airbag inflates between the thorax and
head of the front occupant of the vehicle and the
steering wheel, driver's side, and the dashboard,
passenger's side to cushion their forward
movement.
System which protects the driver and front
passenger in the event of a serious front impact
in order to limit the risk of injury to the head and
thorax.
The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag isfitted in the dashboard above the glove box.