Peugeot 208 2015 Owner's Manual

Driving119
208_en_Chap06_conduite_ed01-2016
Moving off - Gearbox
Electronic Automatic
Do not drive with your hand resting on
the gear lever as this risks damaging
the gearbox. F

R
elease the parking brake.
F
Sel
ect position D
.
F P rogressively release the brake pedal.
Manual
F Start the engine.
F

E
ngage first gear.
F

R
elease the parking brake.
F

P
rogressively release the clutch pedal and
accelerate away. F
T o start the engine, place the lever at
position N .
F

P
ress firmly on the brake pedal.
F

S
tart the engine.
F

Sel
ect position A.
F

R
elease the parking brake.
F

P
rogressively release the brake pedal, then
accelerate away. F
A pply the parking brake.
F Sel ect position P or N.
F

S
tart the engine.
There is an audible signal, accompanied by the
display of an alert message, if the gear lever is
not in the right position.
If you move off in position M , remember
to operate the lever or a paddle to
engage the gear. F

W
ith the engine running, press the
brake pedal.
The vehicle then moves off.
F

P
ress the clutch pedal fully down.
6

Driving
120
208_en_Chap06_conduite_ed01-2016
Switching off
Ignition
Key left in the "Ignition on" position
On opening the driver's door, an alert
message is displayed, accompanied
by an audible signal, to remind you that
the key is still in the ignition switch at
position 1 (Stop) .
If the key has been left in the ignition
switch at position 2 (Ignition on) ,
the ignition will be switched off
automatically after one hour.
To switch the ignition back on, turn the
key to position 1 (Stop) , then back to
position 2 (Ignition on) .
Coasting
As a safety measure, do not coast (free-wheeling
in neutral or with the clutch pedal depressed).
Switching off the engine leads to a loss
of braking assistance.
Gearbox
Manual
F Place the gear lever in neutral.
F
Imm obilise the vehicle.
F

A
pply the parking brake.
F

T
urn the key towards you to position 1
(Stop) .
F

R
emove the key from the ignition switch.
Electronic
F Place the gear lever at position N .
F Imm obilise the vehicle.
F

A
pply the parking brake.
F

T
urn the key towards you to position 1
(Stop) .
F

R
emove the key from the ignition switch.
Automatic
F Place the gear lever at position P or N .
F Imm obilise the vehicle.
F

A
pply the parking brake.
F

T
urn the key towards you to position 1
(Stop) .
F

R
emove the key from the ignition switch.
Steering wheel
To facilitate unlocking of the steering
wheel, it is recommended that you
place the wheels in the straight ahead
position before switching off the engine.

Driving121
208_en_Chap06_conduite_ed01-2016
Parking brake
Application
F Pull the lever up to immobilise your vehicle.
Release
F Pull the parking brake lever up gently, press the release button then lower the
lever fully. If excessive travel or a loss of
effectiveness of this system is noticed,
the parking brake must be checked,
even between two services.
Checks of this safety-related system
must be carried by a PEUGEOT dealer
or a qualified workshop.
When the vehicle is being driven,
if this warning lamp and the STOP

warning lamp come on, accompanied
by an audible signal and a message
in the screen, this indicates that the
parking brake is still on or has not
been fully released. Remember to
fully lower the parking brake lever. When parking on a steep slope, direct
your wheels against the kerb, apply the
parking brake, engage a gear opposite
to the direction the vehicle is facing and
switch off the ignition.
On return to the vehicle, remember
that a gear had been engaged before
starting the engine.
6

Driving
122
208_en_Chap06_conduite_ed01-2016
Only engage reverse gear when the vehicle
is stationary and the engine is at idle.
As a safety precaution and to facilitate
starting of the engine:
-
a
lways select neutral,
-

p
ress the clutch pedal.
6-speed
Engaging reverse gear
Manual gearbox
5-speed
F Move the lever fully to the right to engage 5th or 6th g e a r.
F
M
ove the gear lever fully to the right to
engage 5th g e a r.
Engaging reverse gear
F Move the gear lever fully to the right then back. F
R aise the collar below the gear lever knob,
then push the lever fully to the left and then
forward. The gear shift indicator is displayed in
the instrument panel.
Only engage reverse gear when the
vehicle is stationary and the engine is
at idle.

Driving123
208_en_Chap06_conduite_ed01-2016
Electronic gearbox
5-speed 6-speed
R. Reverse.
N. N
eutral.
A.
A

utomated mode.
M.
M

anual mode.
R. R
everse.
N. N
eutral.
A.
A

utomated mode.
M.
M

anual mode.
Automated mode
This mode allows gear changing without action
by the driver.
Moving off
Lever at position N .
F
P
ress the brake pedal firmly.
F

S
tart the engine.
F

P
lace the lever at A or R .
F

R
elease the brake pedal and press the
accelerator pedal progressively.
If the engine does not start:
-
If N is flashing in the instrument panel,
move the lever to position A then to
position N .
-

I
f the message "Foot on the brake" is
displayed, press firmly on the brake pedal.
The A , R or N position of the lever is indicated
in the display.
You can change from position A to M
and from M to A at any time.
6

Driving
124
208_en_Chap06_conduite_ed01-2016
Stopping - Moving off on a slope
Do not uses the accelerator to hold the vehicle,
but apply the parking brake.
Stopping - Parking
Place the lever at N and apply the parking
brake.
Manual mode
This mode allows manual sequential gear
changing. F

P
ush the lever for ward to change
up.
F

P
ull the lever back to change down.
F

M
ove the selector lever to M .
Steering mounted control paddles
This occasional manual gear changing can
be used for overtaking, for example, while
remaining in automated mode.
F

O
perate the + or - steering mounted control
paddle.
The gearbox engages the gear requested if
the engine speed permits. AUTO remains
displayed in the instrument panel.
After a few moments with no action on the
controls, the gearbox returns to automatic
management of the gears.
Manual gear changing
F Press the back of the "+" paddle to change
up.
F

P
ress the back of the "-" paddle to change
down.
The gear engaged is indicated in the display.

Driving125
208_en_Chap06_conduite_ed01-2016
Creep function
Depending on the engine, the vehicle moves without pressing the accelerator.
AUTO and - appear in the instrument
panel.
F

Sel

ect position N .
F

P
ress the brake pedal firmly.
F

W

ait around 30 seconds until N or a gear
appears in the instrument panel.
F

R

elease the brake pedal.
The gearbox is operational again. With the ignition on, the illumination
of this warning lamp and the flashing
of AUTO
, accompanied by an
audible signal and a message in the
screen, indicate a gearbox fault.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
Assistance with low-speed
manoeuvres
With the engine running at idle, parking brake
released and the lever placed at A , M or R, the
vehicle moves off when your release the brake
pedal.
It stops on opening the driver's door. Closing
the door, and putting your foot on the brake
or accelerator pedal allows movement of the
vehicle again. Following disconnection of the battery, you
have to reinitialise the gearbox.
F

S
witch the ignition on.
Advice
6

Driving
126
208_en_Chap06_conduite_ed01-2016
Automatic gearbox
P. Park.
R. R everse
N.
N

eutral.
D.
D

rive - AUTO driving mode.
S.
S

port - More dynamic driving.
T

S
now - Driving on snow covered roads.
Display in the instrument panel
Foot on the brake warning
When you select a position with the lever,
the corresponding symbol is displayed in the
instrument panel.
Press the brake pedal when this
comes on in the instrument panel.
Automated mode
This mode allows gear changes without action
by the driver.
Moving off
Parking brake applied.
F S tart the engine.
F

L
ever at position P or N .
F

P
ress firmly on the brake pedal.
F

R
elease the parking brake.
F

P
lace the selector at D or R .
F

R
elease the brake pedal and press
the


accelerator pedal progressively.
The vehicle then moves off.
Never leave children unsupervised in
the vehicles when the engine is running.

Driving127
208_en_Chap06_conduite_ed01-2016
Advice
F Select position D for automatic
changing of the gears.
The gearbox then operates in auto-adaptive
mode, without action by the driver. It
continuously selects the most suitable gear for
the driving style, the relief of the road and the
load in the vehicle.
For maximum acceleration, without touching
the gear lever, press the accelerator pedal fully
down (kick down). The gearbox changes down
automatically or holds the gear engaged up to
maximum engine speed.
When braking, the gearbox changes down
automatically to provide effective engine
braking.
When you take your foot off the accelerator
pedal quickly, the gearbox does not change up,
for your improved safety.Manual mode
This mode allows manual sequential gear
changing.
F
M
ove the gear lever to M .
F

P
ush the lever for ward to change
up.
F

P
ull the lever back to change down.
Invalid value
This symbol is displayed if a gear
is not properly engaged (selector
between two positions). When the engine is at idle, if position
R
,
D or M is selected with the brakes
released, the vehicle moves on its own
without pressing the accelerator.
Never leave children unsupervised
inside the vehicle when the engine is
running.
Apply the parking brake and select
position P if carrying out a maintenance
operation with the engine running.
Never select position N when the
vehicle is moving.
Never select positions P or R unless the
vehicle is at a complete stop.
You can change from D to M and M to D
at any time. If position N is engaged by mistake
when moving, take your foot off
the accelerator pedal, then engage
position


D to accelerate.
When the ambient temperature is below
-23°C, the engine should be left running
at idle for four minutes after starting,
to ensure the correct operation and
durability of the engine and gearbox.
6

Driving
128
208_en_Chap06_conduite_ed01-2016
Sport programme
This special programme completes the
automatic operation of the gearbox in certain
circumstances. F

P
ress the "S" button once the
engine is running.
The gearbox automatically operates in a way
best suited to dynamic driving.
S appears in the instrument panel.
Snow programme Return to normal automatic
operation
Switching off - Parking
You risk damaging the gearbox:
F
i f you press the brake and
accelerator pedals at the same
time,
F

i
f you force the movement of the
lever from position P to another
position with a flat battery.
To reduce fuel consumption during
prolonged stops with the engine running
(traffic jams...), position the gear lever
at N and apply the parking brake.
If the lever is not in position P
, a
message appears in the screen
on opening the driver's door or
approximately 45 seconds after
switching off the ignition.
F

P

lace the lever at position P ;
the


message disappears.
On flooded roads or when crossing a
ford, drive at walking pace. With the ignition on, illumination of
this warning lamp, accompanied
by an audible signal and an alert
message in the screen, indicates of
gearbox fault.
In this case, the gearbox goes into back-up
mode by staying in 3rd gear. You may then
notice a pronounced jerk when changing from
P to R and from N to R . This jerk does not
present any risk to the gearbox.
Do not exceed 62 mph (100 km/h) while
keeping to local speed limits.
Contact a PEUGEOT dealer or a qualified
workshop as soon as possible.
This special programme completes the
automatic operation and makes it easier to
move off and make progress in conditions of
poor grip. Before switching off the engine.
F

M

ove the lever to position P or N
.
F

A

pply the parking brake.
F

Imm

obilise the vehicle.
F

P

ress the T button, once the
engine has started.
The gearbox adapts its operation to driving on
slippery surfaces.
T appears in the instrument panel. F

P

ress the button again at any time
to quit the Sport programme and
return to auto-adaptive mode.