ECO mode Peugeot 208 2015 Owner's Manual

Over view
10
208_en_Chap00b_vue-ensemble_ed01-2016
Underbonnet view
Identification markings 2 20
Dimensions 218 -219
Changing bulbs
1

95-201
-

front
-

rear Running out of fuel, Diesel

2

14
Opening the bonnet
1
67
Under the bonnet, petrol

1

68
Under the bonnet, Diesel

1

69
Petrol engines

2

15 -216
Diesel engines

2

15, 217 12V battery

2
08 -211
Load reduction, economy mode
1
61
Engine compartment fuses
20
2-203, 207
Dashboard fuses
2
02-206
Petrol weights
2
15 -216
Diesel weights
2
15, 217
AdBlue
® additive 1
74-180
Checking l eve l s
8

9, 16 8 -172 , 178 -179
-

oil
-

b

rake fluid
-


coolant
-

s

creenwash fluid
-

a

dditive (HDi Diesel AdBlue
®)
Checks and maintenance 1
68-169, 173
-

a

ir filter
-

o

il, oil filter
-

p

article filter (Diesel)
-

b

rake fluid
-

b

rake pads / discs

14
208_en_Chap01_instruments-bord_ed01-2016
Library of indicator and warning lamps
When the ignition is switched on
Certain warning lamps come on for a few
seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information in the table on the warning lamp
concerned.
Associated warnings
The illumination of certain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously
(fixed) or flash.
Certain warning lamps may come on in one of
two modes. Only by relating the type of lighting
to the operating status of the vehicle can it be
ascertained whether the situation is normal or
whether a fault has occurred.
Indicator and warning
lamps
● indicator lamp informing that a system is switched on,
●

w
arning lamp for preventive purposes or for
a fault.
Instruments

16
208_en_Chap01_instruments-bord_ed01-2016
Warning / indicator lamp State Cause Action / Observations
Foot on the
clutch fixed.
In the STOP mode of Stop & Start,
changing to START mode is refused
because the clutch pedal is not fully
down. You must declutch fully to allow the change to engine
S TA R T m o d e .
Stop & Star t fixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Start system
has put the engine into STOP mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
Or
START mode is invoked
automatically. For more information on Stop & Start, refer to the
corresponding section.
Automatic
wiping fixed.
The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
Passenger's
airbag system fixed.
The control, located in the glove box,
is set to the OFF position.
The passenger's front airbag is
deactivated.
You can install a rear ward facing
child seat, unless there is a fault with
the operation of the airbags (Airbag
warning lamp on). Set the control to the ON
position to activate the
passenger's front airbag.
In this case, do not fit a child seat in the rear ward
facing position.
Instruments

1
31
208_en_Chap01_instruments-bord_ed01-2016
F Select the "Driving" menu.
F

S

elect the desired tab using your finger.
Touch screen
F Press the MENU button to
display the main menu. Successively:
Current information
Range
(miles or km)
The distance that can be
travelled using the remaining
fuel in the tank (based on the
average fuel consumption over
the last few miles).
Once the remaining range is below 20 miles

(30 km), dashes are displayed. After topping-up
with at least 5 litres of fuel, the range is recalculated
and displayed if it exceeds 60 miles (100 km).
Current fuel consumption
(l/100 km or km/l or mpg)
Calculated over the last few seconds.
Stop & Star t time counter
(if function present)
(In minutes
/ seconds -
hours
/ minutes)
This function is only displayed above
20

mph (30 km/h).
This value can vary following a change
in driving conditions or the relief of the
road, giving rise to a big difference in
current fuel consumption.
If dashes instead of figures continue
to be displayed when driving, contact
a PEUGEOT dealer or a qualified
workshop. If your vehicle has Stop & Start, a time counter
records the periods in STOP mode during a
j o u r n ey.
It is reset to zero every time the ignition is
switched on using the key.
Instruments

34
208_en_Chap01_instruments-bord_ed01-2016
Lighting dimmer
Tw o b u t t o n s
With the exterior lighting on:
One button
F Press this button to increase the brightness. F
P ress this button to
adjust the brightness,
F

P
ress this button to
reduce the brightness. F

r
elease the button when the desired level is
reached.
As soon as the lighting reaches the required
level of brightness, release the button. System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
With the vehicle lighting off or in day
mode (daytime running lamps on),
pressing the button has no effect.
Touch screen
F Select " Screen settings" .
F Press
MENU

to display the "MAIN
MENU" .
F Select
"Settings" .
F Select
"Secondary page" .
Adjustment
F

A

djust the brightness by moving the cursor.
Instruments

Access
36
208_en_Chap02_ouvertures_ed01-2016
F A press switches on the vehicle's lighting and flashes the direction
indicators for a few seconds to
help you locate your vehicle in a
car park.
Locating your vehicle
Guide-me-home lighting
Make a long press on this button to
operate the guide-me-home lighting
(switching on the sidelamps, dipped
beams and number plate lamps).
A second press before the end of the timed
period cancels the guide-me-home lighting.
Access to the rear seats
Folding the front seat forward
Ensure that no object or person might
prevent the seat runners returning to
their original position; the return to this
position is necessary to secure the
seat.
Ensure that the seat belt has reeled
in correctly so as to not impede
passengers' access to the rear seats.
Sport model
3-door
Standard model
F
Pull only


this control upwards to fold the
backrest and slide the whole seat for ward.
The front seat returns to its original position
when straightening the backrest. F
Pull only this control for ward to fold the
seat backrest and move the whole seat
forward.
The front seat returns to its original position
when straightening the backrest.

Access
46
208_en_Chap02_ouvertures_ed01-2016
Window controls
Manual mode
Open
Close
Inhibit the rear controls.
Automatic mode
(depending on version)
Open
The electric window controls remain
operational for approximately 1 minute
after the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Anti-pinch
(depending on version)
Close
Press the control without going past
the point of resistance. The window
stops as soon as the control is
released.
Pull the control without going past the
point of resistance. The window stops
as soon as the control is released. Press the control, going past the
point of resistance. The window
opens completely after releasing the
control. Pressing again stops the
movement of the window.
Pull the control, going past the
point of resistance. The window
closes completely after releasing
the control. Pulling again stops the
movement of the window.
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening
of the window when closing
automatically, press the control
until the window opens completely,
then pull the control immediately until the
window closes. Continue to hold the control for
approximately 1 second after the window has
closed.
The safety anti-pinch function is not active
during this operation.

Ease of use and comfort63
208_en_Chap03_ergonomie-confort_ed01-2016
A setting around 21 enables you to obtain an
optimum level of comfort. Depending on your
requirements, a setting between 18 and 24 is
usual.
In addition, it is recommended that you avoid a
left /right setting difference of more than 3.
Temperature
The driver and front passenger can each set
the temperature to suit their requirements.
The value indicated in the screen corresponds
to a level of comfort and not to a temperature in
degrees Celsius or Fahrenheit.F

P
ush the button down (blue) to
reduce the value or up (red) to
increase it.
Dual-zone digital air conditioning
AUTO mode
When the engine is cold, the air flow will
only reach its optimum level gradually
to prevent too great a distribution of
c o l d a i r.
In cold weather, it favours the
distribution of warm air to the
windscreen, the side windows and the
footwells only.
Offers the best compromise between
a comfortable temperature and quiet
operation. Provides soft and quiet operation by
limiting air flow.
Provides strong and effective air flow.
F

P

ress the "AUTO" button
repeatedly. The indicator lamp
comes on at the first press; the
mode activated appears in the
digital air conditioning screen:
Automatic programme
Switching on
Switching offF

P
ress the "empty fan" air flow
button until the fan symbol
disappears. Adjustment
3

Ease of use and comfort
68
208_en_Chap03_ergonomie-confort_ed01-2016
Courtesy lamp
In this position, the lighting
comes on gradually:
-

w

hen the vehicle is unlocked,
-

w

hen the key is removed from the ignition,
-
w

hen opening a door,
-

w

hen unlocking with the remote control.
It goes off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0 seconds after the last door is closed. Permanently off.
Permanent lighting. F
W ith the ignition on, press
the corresponding switch.
1.
C

ourtesy lamp
2.
M

ap reading lamp s
With the "permanent lighting" mode, the lighting
time varies according to the circumstances:
- with the ignition off, approximately
10
minutes,
- in energy economy mode, approximately
30 seconds,
- with the engine running, unlimited.
Map reading lamps
Take care to avoid leaving anything in
contact with the courtesy lamp.

79
The sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver, when a low level of
ambient light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
AUTO mode
On
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied
by a message in the screen.
Off
F Turn the ring to another position. Deactivation of the function is
accompanied by a message in the screen.
Automatic guide-me-home
lighting
Association with the automatic lighting provides
the guide-me-home lighting with the following
additional options:
-

s
election of the lighting duration of 15, 30
or 60 seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation. In the event of a fault with the
sunshine sensor, the lighting comes
In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.
Configuration
Press "MENU" to display the "MAIN
MENU" .
Select "Driving" .
Select "Secondary page" .
Select the "Driving assistance" tab.
Activate the "Guide me home"
function. Select "Vehicle settings" .Switching off
Switching on Deactivate the "Guide me home"

function.
on, this warning lamp is displayed in the
instrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualified
workshop.
4
Lighting and visibility