display Peugeot 307 2007.5 Workshop Manual

DRIVING
103
This cruise control, of the new
generation, is linked with the speed
limiter. It has a display on the
instrument panel to indicate the
memorised reference speed.
It enables the vehicle to maintain a
steady speed programmed by the
driver.
In order for it to be memorised or
activated, the vehicle speed must be
greater than 25 mph (40 km/h) with at
least fourth gear engaged for vehicles
i tted with a manual gearbox.
On vehicles i tted with an automatic
gearbox, the lever must be in
position D , or in at least second gear
in sequential mode. When the cruise control function
is activated, pressing this button
enables you to display the distance
recorders.
After a few seconds or when this
button is pressed again, the display
returns to the cruise control function. First activation/memorising a
reference speed
As soon as you reach the chosen
speed, press button
2 or 3 . This
memorises the speed and the display
indicates (e.g. at 70 mph (110 km/h)):
Selecting the function

 Place switch 1 in the CRUISE
position. The cruise control is
not yet active and no speed has
been memorised. The display
indicates:
Note: It is possible to accelerate
and drive momentarily at a speed
greater than the memorised speed.
The value memorised l ashes. When
the accelerator pedal is released, the
vehicle will return to the memorised
speed.
Cancelling the cruise control
If you wish to cancel the cruise
control:

 Press button 4 or the brake or
clutch pedal.
The display indicates (e.g. at 70 mph
(110 km/h)):
CRUISE CONTROL * Instrument panel display
* According to country.

DRIVING
104
Cancelling the memorised
reference speed

 When the vehicle becomes
stationary, after switching off the
ignition, the system no longer
memorises a speed.
Contact a PEUGEOT dealer to have
the system checked. When changing the memo-
rised reference speed by
means of a maintained press,
pay attention as the speed
can increase or decrease rapidly.
Do not use the cruise control on
slippery roads or in heavy trafi c.
In the event of a steep slope,
the cruise control cannot prevent
the vehicle from exceeding the
programmed speed.
In any event, the cruise control cannot
replace the need to comply with
speed limits, nor can it replace the
need for vigilance and responsibility
on the part of the driver.
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat is positioned correctly.
- never i t one mat on top of another.
Reactivating the cruise control
After cancellation of the cruise
control,
press button 4 . Your vehicle
will return to the last memorised
speed. The display indicates (e.g. at
70 mph (110 km/h)):
Changing the memorised
reference speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:

 press button 3 ;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by
5 mph (5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
Using the accelerator:

 exceed the memorised speed until
the required speed is reached,

 press button 2 or 3 . Switching the function off

 Place dial 1 in position 0 to switch
the system off.
Operating fault
In the event of a cruise control
malfunction, the memorised speed
is erased, the dashes l ash for a few
seconds:
To memorise a speed lower than the
previous one:


press button 2 ; A brief press decreases by 1 mph (1 km/h). An extended press decreases by 5 mph
(5 km/h).
A maintained press decreases in steps
of 5 mph (5 km/h).

DRIVING
105
This cruise control has a display on
the instrument panel to indicate the
memorised reference speed.
It enables the vehicle to maintain a
steady speed programmed by the
driver.
In order for it to be memorised or
activated, the vehicle speed must be
greater than 25 mph (40 km/h) with at
least fourth gear engaged for vehicles
i tted with a manual gearbox.
On vehicles i tted with an automatic
gearbox, the lever must be in position

D or at least second gear must be
engaged in sequential driving mode. When the cruise control function
is activated, pressing this button
enables you to display the distance
recorder.
After a few seconds or when this
button is pressed again, the display
returns to the cruise control function. First activation/memorising a
reference speed
As soon as you reach the chosen
speed, press button
2 or 3 . This
memorises the speed and the display
indicates (e.g. at 70 mph (110 km/h)):
Selecting the function

 Place switch 1 in the ON
position. The cruise control is
not yet active and no speed has
been memorised. The display
indicates:
Note: It is possible to accelerate
and drive momentarily at a speed
greater than the memorised speed.
The value memorised l ashes. When
the accelerator pedal is released, the
vehicle will return to the memorised
speed.
Cancelling the cruise control
If you wish to cancel the cruise
control:

 Press button 4 or the brake or
clutch pedal.
The display indicates (e.g. at 70 mph
(110 km/h)):
* According to country.
Instrument panel display CRUISE CONTROL *

DRIVING
106
Reactivating the cruise control
After cancellation of the cruise
control, press button 4 . Your vehicle
will return to the last memorised
speed. The display indicates (e.g. at
70 mph (110 km/h)):
Cancelling the memorised
reference speed

 When the vehicle is stationary,
after the ignition has been
switched off, the system no longer
stores any speed.
Changing the memorised
reference speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:

 press button 3 ;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by
5 mph (5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
Using the accelerator:

 exceed the memorised speed until
the required speed is reached,

 press button 2 or 3 . Switching the function off

 Place dial 1 in the OFF position to
switch the system off.
Operating fault
In the event of a cruise control
malfunction, the memorised speed
is erased, the dashes l ash for a few
seconds:
Contact a PEUGEOT dealer to have
the system checked. When changing the memo-
rised reference speed by
means of a maintained press,
pay attention as the speed
can increase or decrease rapidly.
Do not use the cruise control on
slippery roads or in heavy trafi c.
In the event of a steep slope,
the cruise control cannot prevent
the vehicle from exceeding the
programmed speed.
In any event, the cruise control
cannot replace the need to observe
the speed limits, nor can it replace the
need for vigilance and responsibility
on the part of the driver.
To avoid any risk of jamming of the
pedals:
- ensure that the mat is positioned correctly.
- never i t one mat on top of another. To memorise a speed lower than the
previous one:

 press button 2 ;
A brief press decreases by 1 mph (1 km/h).
An extended press decreases by 5 mph
(5 km/h).
A maintained press decreases in steps
of 5 mph (5 km/h).

DRIVING
107
VISUAL AND AUDIBLE REAR
PARKING ASSISTANCE
This system consists of four proximity
sensors, located in the rear bumper.
This detects any obstacle (person,
vehicle, tree, gate, etc.) behind the
vehicle. Nevertheless, it cannot
detect obstacles located just below
the bumper.
An object, such as a stake, a
roadworks cone or any other similar
object may be detected at the
beginning of the manoeuvre, but
may no longer be detected when the
vehicle comes close to it.

Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle
carrier is i tted (vehicle i tted with
towing attachment or bicycle carrier
recommended by PEUGEOT).
In bad or wintry weather, ensure that
the sensors are not covered with
mud, frost or snow. When reverse
gear is engaged, an audible signal
(long bleep) indicates that the
sensors may be dirty. The proximity information is given
by:
- an audible signal, which becomes
more rapid as the vehicle
approaches the obstacle,
- a graphic on the multifunction display, with blocks which become
progressively closer to the vehicle.
Depending on the multifunction
display, the audible signal is
transmitted by a buzzer or by the rear
speakers which transmit:
- on the right if an obstacle is detected on the right,
- on the left if an obstacle is detected on the left,
- on the right and on the left if an obstacle is detected in the centre.
When the distance between the
rear of the vehicle and the obstacle
is less than approximately thirty
centimetres, the audible signal
becomes continuous and the
"Danger" symbol appears depending
on the multifunction display.
 Change to neutral, the system is
again inactive.
If there is an operating
fault, when reverse gear is
engaged, the service warning
light comes on, accompanied
by an audible signal (short bleep)
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Activation/Deactivation
Activation
The system is activated as soon as
reverse gear is engaged.
This is accompanied by an audible
signal and displaying of the vehicle,
depending on the multifunction
display. The system can be activated
or deactivated from the
multifunction display
coni guration menu.
The activation and deacti-
vation of the system are memorised
when the engine is switched off.
Switching the system off

10PRACTICAL INFORMATION
129

Fuse N° Rating
Functions

F6 30 A Rear electric windows.

F7 5 A Front and rear courtesy lights, map reading lights, glove bo x lighting.

F8 20 A Audio equipment, audio/telephone, multifunction display
, alarm siren, alarm unit, trailer fuse
box, driving school module, steering wheel controls supply.

F9 30 A 12 V front socket, 12 V rear socket.

F10 15 A Automatic gearbox control unit, tyre under-inl ation control un it, STOP switch.

F11 15 A Diagnostic socket, particle emission i lter unit, low current ig nition switch.

F12 15 A Driving school module, rear parking assistance.

F13 5 A Engine fuse box, rain and brightness sensor.

F14 15 A Trailer fuse box, instrument panel, air bags and pre-tensioners
unit, automatic air conditioning,
hands-free kit.

F15 30 A Locking and deadlocking.

F16 - PARC shunt.

F17 40 A Heated rear screen.

10PRACTICAL INFORMATION
134
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, courtesy lights,
audio equipment, telephone, dipped
headlamps, etc.) can only be used for
a combined duration of approximately
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, a
switching to economy mode message
appears on the multi-function display
and the active functions are put on
standby.
These functions are reactivated
automatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then
be double the duration for which the
engine is left running. However, this
period will always be between i ve
and thirty minutes. A l at battery prevents the
engine from starting.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger
compartment of diesel vehicles, etc.)
may be switched off temporarily,
depending on the level of battery
charge.
Reactivation of these functions is
automatic, once the battery charge is
sufi cient.

Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.

Note: if the telephone is
being used when economy
mode starts, it will still be
possible to i nish the call.

156
S
O S
SOURCE
MODE BAND ESC
2
abc
5
jkl
8
tuv 3
def
6
mno
9
wxyz
1 4
ghi
7
pqrs
0 # MENU LIST
TA
PTY
DARK
2
1
5
3 4
89 10 15
11 17 18
12 16
14
7
6
13
01
1. Ejection of the CD.
2. Selection of the source: radio, Jukebox, CD, CD ch anger
and auxiliary (AUX, if activated on the Coniguratio n menu).
Long press: CD copy to hard disc.
3. Long press on the SOS button: emergency call.
4. Selection of the display on the screen from the mo des:
TRIP, TEL, NAV and AUDIO.
5. Modiication of the screen display.
Long press: reinitialisation of the RT4 GPS audio/ telephone.
6. On/Off and Volume adjustment.
7. Selection of the wavebands FM1, FM2, FMast, AM. 8.
TA (Trafic Announcement) function on/off.
Long press: access to the PTY (radio Programme TYpe s)
mode.
9. Access to the "PEUGEOT" services menu.
10. Cancellation of the current operation.
Long press: return to the current application.
11. Automatic search for a lower/higher frequency.
Selection of the previous/next CD, MP3 or Jukebox t rack.
12. Displaying of the general menu.
13. Keypad for entering descriptions by successive pre sses.14.
Selection of the previous/next CD.
Selection of the previous/next MP3/Jukebox director y.
15. Audio option adjustments: front/rear, left/right b alance,
loudness, sound ambiences.
16. Selection and conirmation.
17. SIM card slot.
18. Displaying of the list of local radio stations, of the tracks on
the CD or of the MP3/Jukebox directories.
Long press: updating of the local radio stations.
FIRST STEPS

157
02
GENERAL MENU
MAP: orientation, details,
display. AUDIO FUNCTIONS: radio,
CD, Jukebox, options.For maintenance of the
display, the use of a
soft, non-abrasive cloth
(spectacles cloth) is
recommended without any
additional product.
TELEMATIC: telephone,
directory, SMS.
CONFIGURATION: vehicle,
display, time, languages, voice,
auxiliary socket (AUX) parameters.
VIDEO: activation, parameters.
VEHICLE DIAGNOSTICS:
warnings log, status of the
functions.
NAVIGATION GUIDANCE:
GPS, stages, options. TRAFFIC INFORMATION: TMC
information, messages.

164
ESC
MENU LIST
MENU
ESC
MENU LIST
ESC
LIST
MENU
1
2
3
4 5
6
7
ESC
MENU LIST
03
ESC
MENU LIST
ESC
MENU LIST
ESC
MENU LIST
Press the MENU button.
Press the dial to conirm the selection.
Turn the dial and select the MAP
function.
Turn the dial and select the
MAP IN WINDOW or
FULL SCREEN MAP tab.
Select OK and press the dial to
conirm.
Press the dial to conirm the selection.
Turn the dial and select the
DISPLAY MAP function.
DISPLAYING THE MAP IN A WINDOW OR
IN FULL SCREEN MODE
GPS
DISPLAY MAP
FULL SCREEN MAP
OK
MAP IN WINDOW