light Peugeot 307 Break 2002.5 Owner's Guide

09-09-2002
YOUR 307 IN DETAIL
72
SATELLITE NAVIGATION SYS
TEM
Introduction
The satellite navigation system
guides you, by means of vocal and
visual instructions (graphics), to
your chosen destination.
The heart of the system lies in the
use of a map data base and GPS
(Global Positioning System). With
this system you can fix the position of
your vehicle by means of a satellite
network.
The system uses the following ele
ments:
– the CDROM drive,
– the configuration CDROM
– the navigation CDROM,
– the last voice message recall control,
– the control keypad
– the CT monochrome screen or the DT colour screen. The CDROM drive
This is part of the RT3 radio/telephone.
1.
Ejection button on CDROM.
2. CDROM housing.
The navigation CD ROM
This contains all the map data.
It must be inserted in the drive, printed face upwards.
Use only CDRoms approved by PEUGEOT.
The last voice message recall control.
Pressing for more than two seconds on the button at the end o f the lights stalk
repeats the last voice information.
Certain functions or services
described may vary depending on
the version of CDROM or the coun try where the vehicle is sold.
For safety reasons, the
inputting of navigation
information by the driver
must be carried out when
the vehicle is stationary.

09-09-2002
YOUR 307 IN DETAIL
84
HEATING / VENTILATION
1. Temperature adjustment
To be adjusted to your requirements. 2. Air distribution adjustment
Windscreen and side win
dows (deicing/demisting).
To quickly deice or demist the wind
screen and side windows: – Place air intake control button
4in
the ''Outside Air'' position, (button
4 released, indicator light off),
– Place the temperature and air flow controls to maximum,
– Close the centre vents.

09-09-2002
YOUR 307 IN DETAIL85
Windscreen, side windows
and footwells.
Footwells.
Centre and side vents.
3. Air flow adjustment Turn the control from posi
tion 1to position 4to obtain
an air flow sufficient to
ensure your comfort. 4. Air intake
Pressing button 4 permits
recirculation of the interior
air. Recirculation, indicated
by illumination of the indica
tor light, prevents exterior
odours and smoke from entering the
passenger compartment
.
As soon as possible, switch button 4
to the outside air position to prevent
misting of the windows and deterio
ration of the air quality. The indicator
light switches off. 5. Demisting the rear screen and
exterior mirrors
With the engine running,
pressing the button once
demists the rear screen
and the mirrors.
This switches off automatically after
approximately twelve minutes.
Pressing again activates demisting
for a further twelve minutes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes.

09-09-2002
YOUR 307 IN DETAIL
86
AIR CONDITIONING
1. Air conditioning control
The air conditioning is designed to
operate in all seasons. In summer, it
enables the temperature to be low
ered and in winter, above 0 °C, it
increases the effectiveness of the
demisting. Press the switch, the indica
tor light comes on. The air conditioning does not
operate while the air flow adjust
ment control is in the "OFF" posi
tion
.
Note:
It is quite normal that the condensa
tion created by the air conditioning
results in a flow of water under the
vehicle when it is stationary. 2. Temperature adjustment
To be adjusted to your requirements.

09-09-2002
YOUR 307 IN DETAIL87
4. Air flow adjustment Turn the control from posi
tion 1to position 4to obtain
an air flow sufficient to
ensure your comfort.
5. Air intake Pressing button 5permits
recirculation of the interior
air. Recirculation, indicated
by illumination of the indica
tor light, prevents exterior odours
and smoke from entering the pas
senger compartment.
Used simultaneously with the air
conditioning, recirculation enables
heating and cooling performance to
be improved.
Used in a humid climate, recircula
tion may result in misting of the win
dows.
As soon as possible, switch button 5
to the outside air position, to prevent
deterioration of the air quality. The
indicator light switches off.
3. Air distribution adjustment
Windscreen and side win
dows (deicing/demisting).
To quickly deice or demist the wind
screen and side windows:
– Place the temperature and air flow controls to maximum,
– Close the centre vents,
– Switch air intake button 5to the
"Outside Air" position (button 5
released, indicator light off),
– Start the air conditioning by press ing the AC button.
Windscreen, side windows
and footwells.
Footwells.
Centre and side vents. 6. Demisting the rear screen and
the mirrors
With the engine running,
pressing the button once
demists the rear screen
and the mirrors.
This switches off automati
cally after approximately twelve min
utes. Pressing again activates
demisting for a further twelve min
utes.
It is possible to stop demisting by
pressing the button again before the
end of the twelve minutes.
Important precaution
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
If the system does not produce cold
air, do not use it and contact a
PEUGEOT dealer.
Note: to optimise the operation of
the air conditioning, leave the vents
open.

09-09-2002
PENYALAAN LAMPU
OTOMATIS Lampu samping dan lampu dekat akan menyala secara otomatis jikaintensitas cahaya rendah dan wiperberoperasi. Lampu-lampu tersebutakan mati jika intensitas cahayamencukupi atau wiper dihentikan. Catatan :Pada kondisi berkabut
atau bersalju, sensor intensitas cahaya dapat mendeteksi apakahcahaya masih mencukupi. Olehkarena itu, lampu tidak akan menya-la secara otomatis. Fungsi tersebut aktif pada saat ken- daraan dikirimkan ke pelanggan. Untuk menonaktifkan atau mengak- tifkan fungsi tersebut : putar kunci ke posisi aksesori (di posisi 1),
tekan ujung switch lampu selamalebih dari dua detik.
Catatan : setelah kunci kontak dipu-
tar ke OFF dan tergantung pada
intensitas cahaya sekitar, lampuakan tetap menyala selama sekitar45 detik atau sampai kendaraandikunci. Jangan menutupi sensor sinar matahari/intensitas cahaya yangterletak di tengah dashboard.Sensor ini berfungsi untuk menya-lakan lampu secara otomatis. Monitoring fungsi Pengaktifan Pengaktifan fungsi ini disertai sinyal akustik dan pesan
"Automatic swit-
ching on headlight active" di dis-
play multifungsi. Penonaktifan Penonaktifan fungsi akan disertai sinyal akustik. Catatan : fungsi dapat dinonaktifkan
untuk sementara waktu saat penge- mudi menyalakan lampu secaramanual. Jika ada kesalahan fungsi pada sensor intensitas cahaya, sistem
akan mengaktifkan fungsi (lampuakan menyala). Pengemudi diperin-gatkan melalui sinyal akustik yangdisertai pesan "Automatic swit-
ching on headlight fault" di display
multifungsi. Hubungi segera Dealer servis resmi
PEUGEOT untuk memeriksa sistem.
SELENGKAPNYA 307 ANDA 107

09-09-2002
CHANGING A BULB
Front lights
Note:on the right–hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the
bulbs with a dry cloth.
1 Dipped beam headlamps (H755W).
2 Main beam headlamps (H155W).
3 Front fog lamps (H155 W). Turn the protective cover corresponding to the faulty
bulb a quarter of a turn and remove it.
Disconnect the connector.
Press the end of the securing clip to free it. Change the
bulb.
When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing clip
is fixed properly.
Reconnect the connector.
Refit the protective cover, positioning it with the arrow
upwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with a
protective coating.
Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product. Use
a sponge and soapy water.
4 Side lights W 5 W. Pull the socket rearwards, remove the bulb and change
it.
5 Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
Change the bulb.
Note : In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
PRACTICAL INFORMATION
148

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
PRACTICAL INFORMATION
150
Number plate lights
(W 5 W) Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.

Remove the bulb holder pressing
on the tabs A,
Change the faulty bulb.
Note: f necessary, use the wheel
brace to remove the nuts.
When refitting, take care to position
the bulb holder and the light correct
ly. Third brake light (saloon)
4 W 5 W bulbs
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direc
tion of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
When refitting, ensure that the
light unit tabs are engaged cor
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1 Brake lights (P 21 W).
2 Side lights (R 5 W).
3 Direction indicators (P 21 W).
4 Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by
removing the light: Remove the light fixing nut inside
the boot,
Remove the light fixing nut out
side the boot,
Remove the light,
Unclip the harness,