light Peugeot 307 SW Dag 2003 Service Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2003, Model line: 307 SW Dag, Model: Peugeot 307 SW Dag 2003Pages: 183, PDF Size: 2.31 MB
Page 135 of 183
14-04-2003
INTERIOR LAYOUT
1. Glove boxThis is fitted with a lock.
To open the glove box, lift the handle.The glove box lights when the lid is opened.It contains a ventilation nozzle that can be closed, distributing the same conditioned air as the vents of the passenger compartment, and three sockets for connecting video equipment. The layout allows storage of a water bottle, a pen, the vehicle handbook, a pair of spectacles, tokens etc.
2. Front ashtray Pull the lid to open the ashtray.
To empty it after opening, press the tab and extract the ashtray.
3. Storage
4. 12 volt accessories socket This is a lighter type socket, fitted with a cap. It is supplied with current from the accessories position (1st notch).
5. Door tray
6. Storage/Can holder
7. Waste container To empty, open it fully (past the point of resistance) then pull on the receptacle to remove it.
To refit, lock it in place on the cover.
YOUR 307 SW IN DETAIL 123
Page 137 of 183
14-04-2003
YOUR 307 SW IN DETAIL125
BOOT LAYOUT
1. Grab handles and coat hooks
2. High load retaining net fastenings The high load retaining net can be fitted in the 2nd or
3rd row. Open the covers of the corresponding upper faste- nings. Fit the ends of the metal bar in these fastenings.Secure the two opaque material strap hooks in the sto-
wing rings on the floor. The rings are located directly below the corresponding upper fastenings. Pull the two straps taut.Secure the two hooks on the elastic parts of the opaque material in these rings. Note: the net must be positioned so that the label can
be seen from the boot. This ensures that the central
seat belt is routed correctly.
3. 12V Socket for accessories This is a 12 volt socket (lighter type), installed on theload space cover left support.
It is supplied with the ignition off.
4. Rear armrests with grab handle
5. Storage nets One of them contains the luggage retaining net.
6. Load space cover To install it:
Ð position one end of the cover roller in the 2nd row, Ð compress the opposite end of the roller and position
it,
Ð release it to allow it to engage,
Ð unroll the cover as far as the boot pillars,
Ð insert the cover guides in the rails in the pillars, To remove it:
Ð remove the cover guides from the pillar rails,
Ð return the cover into its roller,
Ð compress it and remove it from its support at the 2nd row,
To store it, pull it back and place it with the two storage nets, already lowered. Note: the roller has two hooks for securing the lugga-
ge retaining net depending on where it is installed.
7. Luggage retaining net Secure the net's seven hooks in the stowing rings and
the fastenings on the floor.
8. Luggage retaining net fastenings ("hammock" version) in the tailgate Fold the net in two. Secure the two centre hooks in the stowing rings on the
floor. Secure the net's remaining four hooks on the boot pillars.
See configuration of the nets (next page)