ESP Peugeot 308 2016 Repair Manual

250
308_en_Chap08_en-cas-de-panne_ed02-2015
Changing a wheel
the tools are installed in the boot under the
f l o o r.
Access to the tooling
List of tools
these tools are specific to your vehicle and can
v ary according to the level of equipment. Do
not use them for other purposes.
1.
W

heelbrace.
Fo

r removing the wheel trim and removing
the wheel bolts.
2.
Ja

ck with integral handle.
Fo

r raising the vehicle. 3.
"B

olt cover" tool.
Fo

r removing the bolt protectors (covers)
on alloy wheels.
4.
So
cket for the security bolts (located in the
glove box).
Fo
r adapting the wheelbrace to the special
"security" bolts.
5.
tow
ing eye.
Procedure for changing a wheel with a damaged or punctured tyre for the spare wheel using the tools provided with the vehicle.
For more information on towing, refer to
the corresponding section.
Wheel with trim
When refitting the wheel, refit the trim
starting by placing its notch facing the
valve and press around its edge with
the palm of your hand.
In the event of a breakdown

255
308_en_Chap08_en-cas-de-panne_ed02-2015
F tighten the security bolt using the
w heelbrace 1 fitted with the security
socket
4

(according to equipment).
F


t
ig
hten the other bolts using the
wheelbrace 1 o n l y.
F
Re

fit the bolt covers on each of the bolts
(according to equipment).
F
St

ore the tools in the box.
the t
yre inflation pressures are given on
this
lab

el.
After changing a wheel
to store the punctured wheel in the boot
c orrectly, first remove the central cover.
When using the "space-saver" type
spare wheel, do not exceed 50 mph
(80
k

m/h).
Have the tightening of the bolts and the
pressure of the spare wheel checked
by a P
eu

ge
Ot d
ealer or a qualified
workshop without delay.
Have the punctured wheel repaired
and refitted to the vehicle as soon as
possible.
If your vehicle has tyre under-inflation
detection, check the tyre pressures then
refer to the corresponding section.
8
In the event of a breakdown

267
308_en_Chap08_en-cas-de-panne_ed02-2015
PeugeOt w ill not accept responsibility
for the cost incurred in repairing your
vehicle or for rectifying malfunctions
resulting from the installation of
accessories not supplied and not
recommended by P
eu

ge
Ot a
nd
not installed in accordance with its
instructions, in particular when the
combined consumption of all of the
additional equipment connected
exceeds 10 milliamperes.Installing electrical
accessories
Your vehicle's electrical system is
designed to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a P
eu

ge
Ot d
ealer or
a qualified workshop.
8
In the event of a breakdown

273
308_en_Chap08_en-cas-de-panne_ed02-2015
Starting using another battery
First check that the slave battery has a
nominal voltage of 12 V and a capacity
at least equal to that of the discharged
battery.
Do not try to start the engine by
connecting a battery charger.
Do not disconnect the (+) terminal when
the engine is running.
F
Re

move the plastic cover from
the
(

+)
t
erminal, if your vehicle has one.
F
Co

nnect the red cable to the positive
terminal (+) of the flat battery A , then to the
positive terminal (+) of the slave battery B.
F
Co

nnect one end of the green or black
cable to the negative terminal (-) of the
slave battery B (or earth point on the other
vehicle).
F
Co

nnect the other end of the green or black
cable to the earth point C on the broken
down vehicle (or on the engine mounting).
F
St

art the engine of the vehicle with the
good battery and leave it running for a
few
m

inutes. F
Op

erate the starter on the broken down
vehicle and let the engine run
If t

he engine does not start straight
away, switch off the ignition and wait a
few
m

oments before trying again.
F
Wa

it until the engine returns to idle then
disconnect the jump lead cables in the
reverse order.
F
Re

fit the plastic cover to the (+) terminal, if
your vehicle has one.
When your vehicle's battery is discharged, the
engine can be started using a slave battery
(external or on another vehicle) and jump lead
cables.Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before
disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the battery, switch on
the ignition and wait 1 minute before starting to
permit initialisation of the electronic systems.
However, if problems remain following this
operation, contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise (depending on
version):
-
th

e remote control key,
-
th

e electric blind(s),
-
... S

ome functions are not available if the
battery is not sufficiently charged.
8
In the event of a breakdown

276
308_en_Chap08_en-cas-de-panne_ed02-2015
General recommendations
Observe the legislation in force in your country.ens
ure that the weight of the towing vehicle is higher than that of the towed vehicle.
the d

river must remain at the wheel of the towed vehicle and must have a valid driving licence.
When towing a vehicle with all four wheels on the ground, always use an approved towing
arm; rope and straps are prohibited.
the t

owing vehicle must move off gently.
When towing a vehicle with the engine off, there is no longer any power assistance for
braking or steering.
In the following cases, you must always call on a professional recovery service:
-
ve

hicle broken down on a motor way or fast road,
-
fou

r-wheel drive vehicle,
-
wh

en it is not possible to put the gearbox into neutral, unlock the steering, or release
the parking brake,
-
to

wing with only two wheels on the ground,
-
wh

ere there is no approved towing arm available...
F
On t

he rear bumper, press the cover
(as
s

hown above) to unclip it.
F
Sc

rew the towing eye in fully.
F
In

stall the towing arm.
F
Sw

itch on the hazard warning lamps on the
towed vehicle.
F
Mov

e off gently and drive slowly over a
short distance only.
Towing another vehicle
For more information on the electric parking brake (brake released), refer to the
corresponding section.
In the event of a breakdown

277
308_en_Chap08_en-cas-de-panne_ed02-2015
On vehicles fitted with Diesel engines, the fuel
system must be primed if you run out of fuel.
For all versions other than BlueHDi, refer to the
corresponding engine compartment view.
Running out of fuel (Diesel)
For more information on the Diesel
misfuel prevention device, refer to the
corresponding section. (except BlueHDi)
F Ad
d at least five litres of Diesel fuel to the
tank.
F
Op

en the bonnet.
F
If n

ecessary, unclip the styling cover for
access to the priming pump.
F
Sq

ueeze and release the priming pump
repeatedly until resistance is felt (there
may be resistance at the first press).
F
Op

erate the starter to start the engine
(if the engine does not start at the first
attempt, wait around 15 seconds before
trying again).
F
If t

he engine does not start after a
few
a

ttempts, operate the priming pump
again then start the engine.
F
Re

fit the styling cover and clip it in place.
F
Clos

e the bonnet.
1.6 HDi engine
If the engine does not start first time,
don't keep trying but start the procedure
again from the beginning.
BlueHDi engine
F Fill the fuel tank with at least five litres of
Diesel.
F
Sw

itch on the ignition (without starting the
engine).
F
Wa

it around 6 seconds and switch off the
ignition.
F
Re

peat the operation 10 times.
F
Op

erate the starter to run the engine.
8
In the event of a breakdown

278
308_en_Chap09_caracteristiques-techniques_ed02-2015
Petrol engines and gearboxes
* the maximum power corresponds to the type approved value on a test bed, under conditions defined by european legislation
(directive 1999/99/eC) .
Engine
1.2 litre
PureTech 82 1.2 litre PureTech 110
1.2 litre PureTech 130 S&S
Gearbox Manual
(5-speed) Manual
(5-speed) Manual
(6-speed)
eAt6 au
tomatic
(6-speed)
Model code LPHMZLPHNZ - LRHNZ LPHNY - LRHNY LPHNY - LRHNY
Body style Hatchback HatchbackSWHatchback SWHatchback SW
Cubic capacity (cc) 1 19 91 19 9 1 19 9
Bore x stroke (mm) 75 x 90.575 x 90.5 75 x 90.5
Max power:
e
u
s
tandard (kW)*
6081 96
Max power engine speed (rpm) 5 7505 500 5 500
Max torque:
e
u
s
tandard (Nm)
118205 230
Max torque engine speed (rpm) 2 7501 500 1 750
Fuel
un
leaded
un
leaded
un
leaded
Catalytic converter yesyes yes
Oil capaciy (in litres)
eng
ine (with replacement of the filter cartridge)
3.253.5 3.5
technical data

279
308_en_Chap09_caracteristiques-techniques_ed02-2015
* the maximum power corresponds to the type approved value on a test bed, under conditions defined by european legislation
(directive 1999/99/eC) .
** For Russia.
*** Outside
eur

ope.
Engine
1.6 litre VTi 1151.6 litre THP 135** / 150*** / 165***
Gearbox Manual (5-speed)
eAt6 au
tomatic (6-speed)
Model code LWNFP - LXNFP
L35gL / L35gX / L35gY - L4 5gL / L4 5gX / L4 5gY
Body style HatchbackSWHatchback SW
Cubic capacity (cc) 1 5871 598
Bore x stroke (mm) 78.5 x 8277 x 85.8
Max power:
e

u
s
tandard (kW)* 85 / 11599.3 / 110 / 121.4
Max power engine speed (rpm) 6 0506 000
Max torque:
e

u
s
tandard (Nm) 150221 / 240 / 240
Max torque engine speed (rpm) 4 0001 400
Fuel
un

leaded
un
leaded
Catalytic converter yesyes
Oil capacity (in litres)
eng

ine (with replacement of the filter cartridge) 3.54.25
9
technical data

280
308_en_Chap09_caracteristiques-techniques_ed02-2015
gt and gti petrol engines and gearboxes
* the maximum power corresponds to the type approved value on a test bed, under conditions defined by eur opean legislation
(directive 1999/99/eC)
En
gine
1.6 litre THP 205 S&S
GT 1.6 litre THP 250 /
270 S&SGTi
Gearbox Manual (6-speed)Manual
(6-speed)
Model code L35
gt - L
45
gtL3
5
gP / L3
5
gN
Bo
dy style
HatchbackSWHatchback
Cubic capacity (cc) 1 5981 598
Bore x stroke (mm) 77 x 85.877 x 85.8
Max power:
e
u
s
tandard (kW)*
151184 / 200
Max power engine speed (rpm) 6 0006 000
Max torque:
e
u
s
tandard (Nm)
285330
Max torque engine speed (rpm) 1 7501 900
Fuel
un
leaded
un
leaded
Catalytic converter yesyes
Oil capacity (in litres)
eng
ine (with replacement of the filter cartridge)
4.254.25
technical data

284
308_en_Chap09_caracteristiques-techniques_ed02-2015
Diesel engines and gearboxes
* the maximum power corresponds to the value type approved on a test bed, under conditions defined by european legislation
(Directive 1999/99/eC) .
Engine
1.6 litre HDi 921.6 litre e- HDi 115 1.6 litre BlueHDi 100
Gearbox Manual (5-speed)Manual (6-speed) Manual (5-speed)
Model code LB9HP - LC9HPLB9HC - LC9HC LBBHY - LCBHY
Body style HatchbackSWHatchback SWHatchback SW
Cubic capacity (cc) 1 560
Bore x stroke (mm) 75 x 88.3
Max power:
e
u
s
tandard (kW)*
6885 73
Max power engine speed (rpm) 4 0003 600 3 750
Max torque:
e
u
s
tandard (Nm)
230270254
Max torque engine speed (rpm) 1 750
Fuel Diesel
Catalytic converter yes
Particle filter yes
Oil capacity (in litres)
eng
ine (with replacement of the filter cartridge)
3.75
technical data