wheel size Peugeot 308 SW BL 2010.5 Owner's Manual - RHD (UK, Australia)

1
i
i
176
PRACTICAL INFORMATION

Tyre under-infl ation detection
The spare wheel is not fi tted with
a sensor. The punctured wheel
must be repaired by a PEUGEOT
dealer.
Putting the wheel back in place


)
Store tools 2
and 3
in the box and
close the cover.

)
Position the box on the ground.

)
Place the spare wheel on the box.

)
Fit the black plastic centring cone in
the centre of the wheel (on steel or
"space-saver" type wheels only).

)
Pass the hooking device through
the cone and the wheel to secure it
to the box cover.

)
Raise the wheel/box assembly
underneath the rear of the vehicle
by tightening the winch control nut
using the wheelbrace 1
.

)
Fully tighten the nut.

)
Close the fl ap with the eyelet and
cover to secure the winch.

)
Check that the wheel is located
squarely against the fl oor.
If not, repeat the operation.

If you purchase a wheel of standard
size to replace the "space-saver"
type spare wheel, the spacer, lo-
cated underneath the vehicle, must
be removed. Consult a PEUGEOT
dealer.

1
i
227
TECHNICAL DATA
IDENTIFICATION MARKINGS
Various visible markings for the identifi -
cation and tracking of your vehicle.
If the tyre pressures are too low,
this increases fuel consumption.
The tyre pressures must be
checked when the tyres are cold,
at least once a month.


A.
Vehicle Identifi cation Number
(VIN)

under the bonnet.


This number is engraved on the
bodywork near the damper support.
To gain access to it, raise the plastic
cover.
B.
VIN

on the windscreen lower
crossmember.


This number is indicated on a self-
adhesive label which is visible
through the windscreen.

C.
Manufacturer's plate.


This plate is riveted onto the engine
mounting.
or

D.
Manufacturer's label.


This number is indicated on a self-
destroying label affi xed to the right
hand centre pillar. This plate/label also indicates the
kerb weight, the gross vehicle
weight (GVW) and the gross train
weight (GTW).

E.
Tyre/paint label.


This label is affi xed to the front pillar,
on the driver's side.
It bears the following information:


- the tyre infl ation pressures with and
without load,

- the wheel rim and tyre sizes,

- the brands of tyre recommended by
the manufacturer,

- the infl ation pressure of the spare
wheel,

- the paint colour code.