fog light Peugeot 406 2002.5 Owner's Manual

Front/rear fog lamps (ring B)
Turn the ring towards the front to
switch on and towards the rear to
switch off. On/off status is dis
played by the indicator light on
the instrument panel.Front fog lamps (1st
rotation of the ring for
wards).Front fog lamps
and rear fog lamp
(2nd rotation of the
ring forwards).
STEERING WHEEL STALKS
LIGHTING
Front lights (ring A)
Lights off.
Side lights.
Dipped/ main beam
headlamps.
Automatic
illumination of
headlamps. WINDSCREEN WIPERS
Front
2 Rapid wipe (heavy rain)
1 Normal wipe (moderate rain)
AUTO Automatic wipe
0 Off
Single wipe
Windscreen wash: pull the stalk
towards you.
Rear Intermittent Wash/
Off wipe wipe
YOUR 406 AT A GLANCE
5
Automatic wipe
In the AUTO position, the
windscreen wiper operates
automatically and adapts
its speed to the intensity
of the rainfall.
29-07-2002
122124

29-07-2002
INSTRUMENT PANEL DIALS: PETROL / DIESEL1 Fuel filler cap warning light.
2 Door open warning light.
3 Dipped beam headlamps
indicator light.
4 Main beam headlamps indicator
light.
5 Rev counter.
6 Lefthand direction indicator.
7 Central (STOP) warning light.
8 Service indicator, oil level and
total distance recorder. 9
Righthand direction indicator.
10 Speedometer.
11 Clogging of the particulate
emission filter warning light
(Diesel).
12 Front fog lamps indicator light.
13 Rear fog lamp indicator light.
14 Dynamic stability control
(ASR/ESP) indicator light
(petrol versions only).
15 Low coolant level warning light.
YOUR 406 IN DETAIL 125
16 Coolant temperature indicator.
17 Trip recorder zero reset.
18 Handbrake and low brake fluid
level warning light.
19 Seat belt not fastened warning
light.
20 Air bags warning light.
21 ABS system warning light.
22 Engine diagnostics warning
light.
23 Battery charge warning light.
24 Diesel engine preheating
indicator light.
25 Passenger air bag disarming
warning light.
26 Water in diesel filter warning
light.
27 Front brake pad wear warning
light.
28 Engine oil pressure warning
light.
29 Electronic immobiliser warning
light.
30 Lighting rheostat.
31 Fuel gauge.
32 Low fuel level warning light.

29-07-2002
1 Fuel filler cap
warning light.
2 Door open warning light.
3 Dipped beam headlamps
indicator light.
4 Main beam headlamps
indicator light.
5 Rev. counter.
6 Lefthand direction indicator.
7 Central (STOP)
warning light.
8 Low fuel level warning
light.
9 Fuel gauge. 10
Service indicator, oil level
indicator and total distance
recorder.
11 Righthand direction indicator.
12 Speedometer.
13 Clogging of the particulate
emission filter warning light
(Diesel).
14 Front fog lamps indicator light.
15 Rear fog lamp indicator light.
16 Dynamic stability control
(ASR/ESP) warning light (petrol
versions only). 17
Low coolant level warning light.
18 Coolant temperature indicator.
19 Trip recorder zero reset button.
20 Handbrake and low brake fluid
level warning light.
21 Seat belt not fastened warning
light.
22 Air bags warning light.
23 ABS system warning light.
24 Engine diagnostics warning
light.
25 Battery charge warning light.
26 Diesel engine preheating
indicator light.
27 Passenger air bag disarming
warning light.
28 Water in diesel filter warning
light.
29 Front brake pad wear warning
light.
30 Engine oil pressure warning
light.
31 Electronic immobiliser warning
light.
32 Lighting rheostat.
33 Engine oil temperature
indicator.
YOUR 406 IN DETAIL
126
INSTRUMENT PANEL DIALS: PETROL / DIESEL

29-07-2002
YOUR 406 IN DETAIL127
1
Fuel filler cap warning light.
2 Door open warning light.
3 Dipped beam headlamps
indicator light.
4 Main beam headlamps indicator
light.
5 Rev. counter.
6 Lefthand direction indicator.
7 Central (STOP) warning light.
8 Low fuel level warning light.
9 Fuel gauge. 10
Service indicator, oil level
and total distance recorder.
11 Righthand direction indicator.
12 Speedometer.
13 Clogging of the particulate
emission filter warning light
(Diesel).
14 Front fog lamp indicator light.
15 Rear fog lamp indicator light.
16 Dynamic stability control
(ASR/ESP) indicator light
(petrol versions only). 17
Low coolant level warning light.
18 Coolant temperature indicator.
19 Trip recorder zero reset.
20 Handbrake and low brake fluid
level warning light.
21 Seat belt not fastened warning
light.
22 Air bags warning light.
23 ABS system warning light.
24 Engine diagnostics warning
light.
25 Battery charge warning light.
26 Diesel engine preheating
indicator light.
27 Passenger air bag disarming
warning light.
28 Water in diesel filter warning
light.
29 Front brake pad wear warning
light.
30 Engine oil pressure warning
light.
31 Operating programmes.
32 Gear lever position indicator.
33 Electronic immobiliser warning
light.
34 Lighting rheostat.
35 Engine oil temperature.
INSTRUMENT PANEL DIALS: AUTOMATIC GEARBOX

29-07-2002
In good or rainy weather,
both day and night, the
rear fog lamp is dazzling
and is prohibited.
Do not forget to switch the fog
lamp off when it is no longer need
ed. Front and rear fog
lamps (2nd rotation of
the ring forwards)
These operate with the side lights
and the dipped/main beam head
lamps.
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ring
backwards twice in succession.
Direction indicators
(flashers)
Left:downwards.
Right: upwards.
THE LIGHTS STALK
Front and rear lights
Selection is by turning ring A.
Lights off
Side lights Dipped / main beam
headlamps
Automatic switching
on of lights Dipped/main beam change
Pull the stalk fully towards you.
Note:
with the ignition off, if the dri
ver's door is left open, a buzzer
sounds if you have left your lights on.
Front fog lamps and rear fog
lamp (ring B)
Rotate the ring forwards to switch on
and backwards to switch off. The sta
tus is confirmed by the indicator light
on the instrument panel.
Front fog lamps (first rota
tion of the ring forwards)
These operate with the side lights
and the dipped/main beam head
lamps.
YOUR 406 IN DETAIL
122

29-07-2002
AUTOMATIC SWITCHING ON
OF THE LIGHTS
Side lights and dipped beam head
lamps switch on automatically if the
light is poor, or during continuous
operation of the windscreen wipers.
They switch off as soon as the light
becomes bright enough or the wind
screen wipers stop.
This function is active when the vehi
cle is supplied to the customer.
To disarm or activate the function: Place the key in the accessories
position (1st notch),
 Press the end of the lights stalk
for more than two seconds.
Note: In foggy weather, the bright
ness sensor can detect sufficient
light. Because of this, the lights do
not come on automatically.
Do not cover the brightness sen
sor connected to the rain sensor,
located in the windscreen behind
the mirror. It is used for automatic
switching on of the lights. Operating check
Activation
Activation of this function is accom
panied by an audible signal and the
message
"Automatic lighting of
the headlamps activated" on the
multifunction display.
Note: Always operate the lighting
controls manually where this is pos
sible.
Disarming
Disarming of the function is accom
panied by an audible signal.
When driving, if this function is
switched off when the headlamps
would switch on in automatic mode,
the lights remain on.
It is however possible to disarm this
function and switch off the lights by:
manually switching off the lights using the lights stalk,
switching off the engine.
YOUR 406 IN DETAIL 123
If the brightness sensor does not
function correctly, the system acti
vates the function (the lights come
on).The driver is alerted by the flash
ing of the ''dipped beam'' warning
light on the instrument panel.
Contact a PEUGEOT dealer to have
the system checked.
Follow me Home
When there is a low level of bright
ness or at night, if you leave your
vehicle, the side lights and the
dipped beam lights may remain on
for approximately one minute.
To do this: place the lights stalk in the AUTO
position,
 place the key in the accessories
position (first notch),
 press the end of the lights stalk for
more than two seconds,
 place the lights stalk in the 0posi
tion,
 flash the headlamps,
 get out of the car and lock it.

29072002
Third brake light saloon
(5 W5W bulbs)
Lower the two metal clips on either
side of the light and slide the cover
towards the rear.
Remove the bulbholder.
Change the faulty bulb. Rear lights, saloon
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W).
3 Brake lights/Side lights (P 21/5 W).
4 Side lights (P 21/5 W).
5 Fog lamp (P 21 W).
These 5 bulbs are changed from inside the boot:
remove the retaining clips then release the carpet,
remove the connector by pressing the tab
A,
remove the bulb holder by squeezing the tabs,
change the faulty bulb.
MAINTENANCE OF YOUR 406
38

29072002
Tailgate lights
Open the flap using the cutout pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40

29072002
Tailgate lights
Open the flap using the cutout pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40

29072002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery),
unclip the cover.
Carefully close the cover when
you have finished.The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
Some electrical accessories or
the way in which they are fitted
can have damaging effects on the
operation of your vehicle; the
electronic control circuits, the
audio circuit and the battery
charging circuit.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes. *The maxifuses provide addition
al protection for the electrical sys
tems. All work must be carried out
by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 10 A Reversing lights– Double injection relay Oil
temperature Oil level Air conditioning compressor.
2* 15 AFuel pump, canister solenoid valve.
3* 10 AControl unit.
4* 10 AEngine control unit and automatic gearbox.
5 10 A Particulate Emission Filter control unit Rear
windscreen relay.
6 15 AFront fog lamps.
7 20 AHeadlamp wash.
8* 20 A Direct petrol injection engine control unit Clutch pedal.
9* 15 ALefthand dipped beam lights.
10* 15 A Righthand dipped beam lights
MAINTENANCE OF YOUR 406
44