Peugeot 406 Break Dag 2003 Service Manual
Manufacturer: PEUGEOT, Model Year: 2003, Model line: 406 Break Dag, Model: Peugeot 406 Break Dag 2003Pages: 177, PDF Size: 2.19 MB
Page 41 of 177
17-02-2003
GENERAL FUNCTIONS On/offWith the ignition key in the ACCESSORIES or IGNITION position, press button Ato switch the set on or off.
The set can operate for 30 minutes without the vehicle ignition being switched on.
Anti-theft system The set is coded in such a way that it can operate only on your vehicle. It would not function if fitted to another vehicle.The anti-theft system is automatic and requires no action on your part. VOLUME SETTING Adjusting the volume Turn button Ato increase or reduce the volume.
AUDIO SETTINGS Press the "AUDIO"button several times to access the bass (BASS), treble (TREB) , loudness (LOUD), fader
(FAD) and balance (BAL).
Exit from audio mode is automatic after a few seconds without pressing any button, or by pressing the "AUDIO" button after adjusting the balance.
Note: bass and treble settings are specific to each source. It is possible to set them differently for radio,
cassette or CD changer.
YOUR 406 IN DETAIL
62
Page 42 of 177
17-02-2003
YOUR 406 IN DETAIL63
Adjusting the bass When "BASS" is displayed, press button For Gto vary the setting.
Ð "BASS Ð9" for a minimum bass setting,
Ð "BASS 0" for a normal setting,
Ð "BASS +9" for a maximum bass setting.
Adjusting the treble When "TREB" is displayed, press button For Gto vary the setting.
Ð "TREB Ð9" for a minimum treble setting,
Ð "TREB 0" for a normal setting,
Ð "TREB +9" for a maximum treble setting.
Adjusting the loudness
This function automatically emphasises bass and treble tones when the volume is low.Press button For Gto switch the function on or off.
Setting the front/rear sound distribution (Fader)When "FAD" is displayed, press button For G.
Button Fincreases the volume at the front.
Button Gincreases the volume at the rear.
Setting the right/left sound distribution (Balance)When "BAL" is displayed, press button For G.
Button Fincreases the volume on the right-hand side.
Button Gincreases the volume on the left-hand side.
Page 43 of 177
17-02-2003
YOUR 406 IN DETAIL
64
RADIO Notes on radio reception
Car radio receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of th e
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings etc), or of being in an area which is not covered by a transmitter. Selecting radio mode
Press the "SRC"button until the radio is selected.
Selecting a waveband Briefly press the "BAND/AST"button to select the FM1, FM2, FMast and AM wavebands.
Automatic station search Briefly press button Jor Kto search for the station immediately above or below.
By continuing to press the button in the direction selected, you will obtain contin-
uous scrolling of the frequency. The scrolling stops at the first station found as soon as the button is released.
If the TAtraffic programme is selected, only stations broadcasting this type of programme are selected.
Searching for a station occurs first in "LO"sensitivity (selection of the most powerful transmitters) during scanning of the
waveband, then in "DX"sensitivity (selection of the weakest and most distant transmitters).
Page 44 of 177
17-02-2003
YOUR 406 IN DETAIL65
Manual station search Press the "MAN"button.
Briefly press button Jor Kto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain contin-
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released. Pressing the "MAN"button again returns you to automatic station search.
Manual storing of stations in the memory Select the station required.Press one of the buttons "1"to "6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory. Automatic storing of FM stations in the memory (autostore) Press button "BND/AST"for more than two seconds, to automatically store the 6 stations with the strongest
signal in FM. These stations are stored in the FMast waveband.
Ð If it is not possible to find 6 stations, the remaining memories are empty.
Recalling stations stored in the memory For each waveband, briefly press buttons "1"to "6" to recall the corresponding station.
Page 45 of 177
17-02-2003
YOUR 406 IN DETAIL
66
RDS Using the RDS (Radio Data System) function on FM Radio Data System allows you to continue listening to the same station, whatever frequency it is using for the region you are going through. Briefly press the "RDS"button to switch the function on or off.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best reception and which is transmitting the same programme.
Traffic information programme
Press the "TA"button to switch the function on or off.
Any traffic information flash will be given priority, whatever source you are listening to (radio, cassette or CD changer).
If you wish to interrupt a message, press the "TA"button; this switches the function off.
Note: the volume of traffic information announcements is independent of the volume of normal radio listening. Youcan adjust it using the volume button. The setting will be stored and will be used when the next messages are broad-cast. Regional following mode When they are part of a network, certain stations broadcast regional programmes in the various areas they serve. With regional following mode, you can keep listening to the same programme. Press the "RDS"button for more than two seconds to switch the function on or off.
Page 46 of 177
17-02-2003
YOUR 406 IN DETAIL67
CASSETTE Selecting cassette mode When a cassette is inserted, the cassette player will start automatically. If a cassette is already inserted, press the "SRC"button until cassette mode is selected.
Ejecting the cassette Fully press buttons Dand Eto eject the cassette from the player.
Direction of play The player will play sides 1 and 2 of the cassette alternately, by automatically reversing the direction of play at the end of a side.
To manually reverse the direction of play, press buttons Dand Ehalf-way.
Fast forward/rewindFully press button Dor Eto fast forward or rewind the cassette. At the end of the fast forward/rewind, the set plays the cur-
rent side. Recommendations regarding the use of cassettes
Ð Use good quality cassettes.
Ð Do not use cassettes which play for more than 90 minutes.
Ð Never expose the cassettes to heat or direct sunlight.
Ð Re-tension the tape if necessary before inserting the cassette in the player.
Ð Regularly clean the playing heads with a humid type cleaning cassette.
Page 47 of 177
17-02-2003
YOUR 406 IN DETAIL
68
CD CHANGER Selecting CD changer mode Press the "SRC"button until the CD changer is selected.
Selecting a disc Press buttons "1"to "6" to select the corresponding disc.
Selecting a track Press button Jto select the next track.
Press button Kto return to the start of the current track or to select the previous
track.
Accelerated playPress the "MAN"button.
Press and hold button Jor Kfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released. Buttons Jand Kresume the "track selection" function when the "MAN"button is pressed again.
Shuffle When the CD changer is selected, keep the "SRC"button pressed for two seconds. The tracks will be played
in random sequence. Pressing the "SRC"button again for two seconds returns you to normal play.
Page 48 of 177
YOUR 406 IN DETAIL
70
AUDIO RM2
1ÐPress (behind)
2Ð Press (behind) FunctionIncrease volume. Decrease volume.
1 + 2 Ð
Simultaneous press
3Ð PressCutting off of the sound (mute); restoring of the sound by pressing any button. Automatic search of upper frequencies (radio) - Selection of the following track (CD).
4ÐPressAutomatic search of lower frequencies (radio) - Selection of the previous track (CD).
5ÐPress the endChange of source (radio/cassette/CD changer).
6ÐRotation
(clockwise)Selection of next memorised station (radio) - Selection of following CD.
7Ð Rotation
(anti-clockwise)Selection of previous memorised station (radio) - Selection of previous CD.
Stalk movement
17-02-2003
Page 49 of 177
17-02-2003
ButtonFunction
A ON/VOL Radio On/Off. Volume adjustment.
B Radio selection. Selection of FM1, FM2, FMast and AM wavebands.
Press for more than 2 seconds: automatic storing of stations in the memory (autostore).
C Cassette selection. Reversal of the direction of play of the cassette.
Press for more than 2 seconds: noise reduction.
D CD changer selection.
Press for more than 2 seconds: shuffle.
E Ejection of the cassette.
FT ATraffic information priority on/off.
Press for more than 2 seconds: PTY function on/off.
G RDS RDS function on/off.
Press for more than 2 seconds: regional following mode on/off.
H Increase bass/treble setting.
I Decrease bass/treble setting.
J AUDIO Adjustment of bass, treble, loudness, sound distribution and
automatic volume correction.
K k
k k
k
Automatic search of higher frequency.
Selection of following track - cassette and CD.
L MAN Manual/automatic operation of buttons Kand Min radio mode.
M j
j j
j
Automatic search of lower frequency.
Selection of previous track - cassette and CD.
1 to 6 1 2 3 4 5 6 Selection of station stored in the memory.
Press for more than 2 seconds: storing of a station in the memory.
Selection of a disc in the CD changer.
YOUR 406 IN DETAIL 71
Page 50 of 177
17-02-2003
GENERAL FUNCTIONS On/offWith the ignition key in the ACCESSORIES or IGNITION position, press button Ato switch the set on or off.
The set can operate for 30 minutes without the vehicle ignition being switched on.
Anti-theft systemThe audio system is coded in such a way that it can operate only on your vehicle. It would not function if fitted to another vehicle. The anti-theft system is automatic and requires no action on your part. ADJUSTING THE VOLUME Turn button Ato increase or decrease the volume.
AUDIO SETTINGS Press the "AUDIO"button several times in succession to access the bass (BASS), treble (TREB) , loudness
(LOUD) , fader (FAD), balance (BAL)and the automatic volume correction.
Exit from audio mode is automatic after a few seconds without pressing any button, or by pressing the "AUDIO" button after configuration of the automatic volume correction.
Note: bass and treble settings are specific to each source. It is possible to set them differently
for radio, cassette and CD changer.
YOUR 406 IN DETAIL
72