change key battery Peugeot 406 C 2003 Owner's Manual

24-03-2003
YOUR 406 COUPE IN DETAIL85
Changing the battery of the remote control The information
"battery flat"is
given by an audible signal accompa- nied by a message on the multifunc-
tion display.
To replace the battery, unclip the
casing using a coin at the ring (CR2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOT
dealer on the system. This code ishidden by a film, which should be
removed only if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition A
buzzer sounds on opening the dri-
ver's door, if the key has been left in the ignition. Locating your car
To locate your car, if you have locked
it, in a car park:
☞ press button A.The courtesy
lights come on and the direction indicators flash for a few seconds.
Programming the remote control
☞ Switch off the ignition.
☞ Switch the ignition on again.
☞ Press button Aimmediately.
☞ Switch off the ignition and remove the remote control key from the
ignition lock. The remote controlis now working again.