bonnet Peugeot 407 C 2008 Owner's Manual

A. Unfolding/Folding of the key.

B. Normal locking or deadlocking.

C. Complete or selective unlocking.

D. Unlocking of the boot.

1. Bonnet opening control.

2. Opening of the bonnet.

 104
Low fuel level

 73

1. Fuel fi ller fl ap opening button.

2. Opening of the fuel fi ller fl ap.

3. Opening and hooking of the fuel
tank cap.
Capacity of the tank: approximately
67 litres.
When this warning light
comes on on the instru-
ment panel, you have
enough fuel left to drive
approximately 30 miles
(50 km).

 64
Fuel tank Bonnet Remote control key

1. Steering wheel height and depth
adjustment.

2. Cruise control/
speed limiter switches.

3. Lights and direction indicators
controls.

4. Speakers (tweeters).

5. Adjustable and closing central
vents.

6. Air diffuser vent grille.

7. Windscreen de-icing and demisting
vent.

8. Sunshine sensor.

9. Adjustable and closing side vent.

10. Bonnet release.

11. Passenger air bag.

12. Glove box/Video sockets.
Fascia fuse box.

13. Passenger footwell air outlet.

14. Passenger heated seat control.

15. Passenger seat electric controls.
* According to country.

4
68
THE ALARM
This provides two types of surveillance:
- exterior protection: it sounds if
a door, the boot or the bonnet is
opened.
- interior protection: it sounds if
the volume inside the passenger
compartment changes (breaking
of a window or a movement inside
the vehicle). When the alarm is triggered, the siren
sounds and the direction indicator lights
fl ash for approximately thirty seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
disarming then setting of the alarm.

Warning: if button A indicator light
fl ashes rapidly, the alarm has been
triggered while you were away from
your vehicle.
Incorrect operation
When the ignition is switched on, if
button A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
Remote control failure, alarm set

 Unlock the doors with the key and
open the door. The alarm is trig-
gered.

 Switch on the ignition. The alarm is
disarmed.
* According to country.
Setting the alarm

 Switch off the ignition and get out
of the vehicle.

 Set the alarm, by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once per second).
If you wish to lock or deadlock your ve-
hicle without setting the alarm, lock it
(one turn of the key) or deadlock it (a
second turn within fi ve seconds maxi-
mum) using the lock.
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
Before setting the alarm, en-
sure that all of the accesses
(doors, bonnet, boot) are
closed correctly.
Disarming
Unlock the vehicle with the remote
control key.
The alarm is disarmed, indicator light A
goes out when the ignition is switched on.
To set the alarm with exterior protection only
If, while you are away from the vehi-
cle, you wish to leave a window par-
tially open or a pet inside the vehicle,
you should choose exterior protection
only.

 Switch off the ignition,

 In the next ten seconds, press but-
ton A until the indicator light is on
continuously,

 Get out of the vehicle,

 Set the alarm by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once a second).

9
104
Bonnet strut
Secure the strut in its housing to hold
the bonnet open.
Before closing the bonnet, replace the
strut in its clip.
OPENING THE BONNET

From inside: pull the handle on the
left-hand side under the fascia to-
wards you.

From outside: lift the catch and raise
the bonnet. To avoid any risk of burns, only
handle the bonnet strut by the
protective foam.
To close
Lower the bonnet and release it at the
end of its travel. Check that the bonnet
is properly locked.

1010
120
Before disconnecting the battery,
you must wait for 2 minutes after
switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Open the windows and close the
sunroof before disconnecting the bat-
tery. If they do not operate normally
following reconnection of the battery,
they must be reinitialised (see para-
graphs "Reinitialisation of the electric
windows" and "Sunroof").
After every reconnection of the battery,
switch on the ignition and wait 1 minute
before starting to allow the electronic
systems to be initialised. However,
if slight diffi culties are experienced
after this, please contact a PEUGEOT
dealer.

On the 2.7 litre 24V HDI engine, if
there is no battery in the boot, do
not connect a slave battery to the
positive (+) and negative (-) termi-
nals under the bonnet as a short
circuit may occur.
The batteries contain harmful
substances such as sulphuric
acid and lead.
They must be disposed of in accordance
with regulations and must never be dis-
carded with household waste.
Take used batteries to an approved
collection point.

 open the bonnet,

 use the two additional positive (+)
and negative (-) terminals located
under the bonnet,

 open the red cover of the positive
(+) terminal,

 connect the red cable between the
positive (+) terminal and the positive
(+) terminal of the slave battery,

 connect the green or black cable
between the negative (-) terminal
and the negative (-) terminal of the
slave battery,

 operate the starter, let the engine
run,

 wait for the engine to return to idle,
then disconnect the cables,

 close the red cover of the positive
(+) terminal,

 refi t the left side cover,

 close the bonnet. BATTERY (LOCATED IN THE BOOT) *
* Vehicles fi tted with the 2.7 litre HDI
24V engine.
The battery is in the left boot trim.

To charge the battery using a bat-
tery charger (boot open):

 fold down the panel to gain access
to the battery,

 disconnect the battery,

 follow the instructions for use given
by the battery charger manufacturer,

 reconnect starting with the nega-
tive (-) terminal,

 raise the panel and close it.
To start the vehicle from another
battery: