ESP Peugeot 607 Dag 2002 Owner's Guide

YOUR 607 IN DETAIL97
''Isofix'' mountings*
Available on the one third side of the
rear seat, the Isofix mountings allow
fitting of a
special child seat ,
approved for PEUGEOT vehicles
and sold within its network.
The locks incorporated in the child
seat fit onto the Isofix mountings and
ensure safe, reliable and fast assem
bly.
The seat is fitted in the rearwards or
forwards facing position. In this case,
for optimium safety, it is imperative
to adjust the corresponding front
seat to the intermediate longitudinal
position, with the seat back upright. Ski flap
 Lower the armrest to access the
ski flap. Open by pulling the han
dle. The special child seat approved by
PEUGEOT is the KIDDY Isofix seat.
It can be used in the rearwards fac
ing position from birth to 13 kg and in
the forwards facing position from 9 to
18 kg.
This seat may also be used where
there are no Isofix mountings: in this
case it is compulsory to wear a
threepoint seat belt.
 Follow the instructions in the
brochure for fitting the child
seat.
* According to current legislation

YOUR 607 IN DETAIL
116
EXTERIOR MIRRORS
Adjustment from the inside Turn knob Bto the right or to the
left to select the corresponding
mirror.
 Move knob Bin all four directions
to adjust.
Folding back the mirrors electri
cally *  With the ignition on, turn knob Bto
position A.
or,
 Lock the vehicle using the remote
control.
Note: this function can be neu
tralised. Contact your PEUGEOT
dealer.
When the vehicle is parked, the
exterior mirrors can be folded
back manually. Automatically adjustable
mirrors for parking
These allow you to see the ground
(kerb, wall...) when carrying out
parking manoeuvres in reverse gear.
Tilting the mirror to the parking posi
tion:
 switch on the direction indicator
on the parking side,
 engage reverse gear.
The exterior mirror corresponding
to the side on which you are park
ing tilts downwards.
Returning the mirror to the previous
position:  change out of reverse gear.
Note: to be active, this function must
be initialised by adjusting the mirror,
with reverse gear engaged and the
direction indicator on the side of the
mirror to be adjusted switched on.
Each remote control can memorise a
specific setting.
The driver's mirror is con
vex in order to eliminate
the 'blind spot' (area at
edge defined by a dotted
line).
As a result, objects observed in
the driver's and passenger's mir
rors are in reality closer than they
appear.
This must be taken into account to
judge correctly the distance of
vehicles approaching from
behind.

YOUR 607 IN DETAIL
122
The
four speed automatic gearbox offers a choice between the comfort of inte
gral automatic operation , enhanced by a sportand a snow programme, or the
pleasure of manual gear changing .
Gear selection gate  Move the lever in the gate to select a function.
Once the function is selected, the corresponding indicator lig ht appears on the
instrument panel screen.
S: sport programme.
: snow programme.
P ark: to immobilise the vehicle and to start the
engine , with the handbrake on or off.
R everse: to reverse(select this function with the vehi
cle stationary, engine at idle).
N eutral: to start the engine and to park, with the hand
brake on.
Note: if position Nis inadvertently engaged while dri
ving, allow the engine to return to idle before engagin g
function Dto accelerate.
D rive: for driving in automatic mode.
M anual: for drivingin manual mode.
PORSCHE TIPTRONIC system' AUTOMATIC GEARBOX Moving Off
With the engine running, to move off
from position
P:
 it is essential to press the brake
pedal to exit position P,
 select function R, D or M, then
gradually release the pressure on
the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
 release the handbrake, with your
foot on the brake,
 select function R, D or M, then
gradually release the pressure on
the brake pedal; the vehicle
moves off immediately.
WARNING
When the engine is at idle, brakes not
applied, if function R, D or Mis select
ed, the vehicle moves even without
the accelerator being pressed. For
this reason, do not leave children
unsupervised inside the vehicle,
with the engine running.
When maintenance operations need
to be carried out with the engine run
ning, apply the handbrake and select
position P.

Operating check
When a malfunction of the sys
tems occurs, the switch light
flashes and the warning light
comes on, accompanied by an
audible signal and the mes
sage 'ESP/ASR system faulty' on the
multifunction display.
Contact a PEUGEOTdealer to have the
system checked.
YOUR 607 IN DETAIL
125
The ESP system offers
exceptional safety in normal
driving, but this should not
encourage the driver to take
extra risks or drive at high
speed.
The correct functioning of this sys
tem depends on observation of the
manufacturer's recommendations
regarding wheels (tyres and rims),
the braking components and the
electronic components, as well as
the PEUGEOT assembly and opera
tion procedures.
After an impact, have the system
checked by a PEUGEOT dealer.
Disarming the ASR/ESP
systems
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground...), it may be
advisable to disarm the ASR system,
so that the wheels can move freely
and regain grip.
Press the 'ESP OFF'
switch, located under the
steering wheel to the left.
The switch lights up and the
warning light comes on,
accompanied by an audible
signal and the message
'ASR/ESP system deacti
vated' on the multi–function
display : the ASR and ESP systems
no longer have any effect on the
engine operation.
These are triggered again :
 automatically if the ignition is
switched off,
 manually by pressing the switch
again.DYNAMIC STABILITY
CONTROL (ESP) AND
TRACTION CONTROL (ASR)
These systems are linked and com
plementary to the ABS system.
In the event of a significant variation
between the trajectory of the vehicle
and the path required by the driver,
the ESP system acts automatically
on the engine and on the brake of
one or more wheels, to put the vehi
cle back on course. The traction con
trol (ASR) system optimises drive, in
order to avoid the wheels slipping, by
acting on the brakes of the drive
wheels and on the engine. It also
enables the directional stability of the
vehicle to be improved during accel
eration.
Operation of the ESP
and ASR systems
When one of the two sys
tems is in operation, this
indicator light flashes.

139
TYRE UNDERINFLATION
DETECTION
Sensors check the tyre pressure
during driving, and trigger a warning
in the event of malfunction (speed
greater than 15mph [25 km/h]).
Flat tyreWhen this warning light
comes on, accompanied by
an audible signal and the
message 'Tyre pressure
low' on the multifunction
display, have the tyre pressure
checked as soon as possible.
Puncture
This warning light, accom
panied by an audible signal
and the message 'Punc
tured tyre(s) detected' on
the multifunction display, is
followed by illumination of the
'STOP' warning light.
Stop immediately, avoiding any sud
den movement of the steering wheel
and the brakes.
Change the damaged (punctured or
very deflated) tyre, and have the tyre
presure checked as soon as possible.
Note: if the damaged tyre is tem
porarily stored in the boot, it will
again emit this message to remind
you of the necessity of having it
repaired. This will prevent another
warning of the same type being dis
played. Sensor(s) not detected
This warning light, accom
panied by an audible signal
and the message ' X tyre
pressure sensor(s) miss
ing ' on the multifunction
display, indicates that underinflation
detection is absent from one (or sev
eral) tyre(s).
Contact a PEUGEOT dealer to
replace the faulty sensor(s).
Note: this message is also displayed
when one of the tyres is away from
the vehicle (being repaired) or when
a wheel without a sensor is fitted.
LES INFORMATIONS PRATIQUES
All repairs and changing
of tyres on a wheel fitted
with this system must be
carried out by a
PEUGEOT dealer.
The tyre underinflation detec
tion system is an aid to driving
which does not replace the
need for the driver to be vigilant
or to drive responsibly.
This system does not remove the
necessity for having the tyre pres
sure (including that of the spare
wheel) checked regularly, to
ensure optimum dynamic perfor
mance of the vehicle and to pre
vent premature wear of the tyres,
particularly in the case of arduous
driving conditions (heavy load,
high speed).
The system may temporarily be
disturbed by radio broadcasts on
a frequency close to it.

PRACTICAL INFORMATION
148
Engine compartment fuses
Fuse box
To access the fuses located in the
engine compartment (next to the bat
tery) :
remove the style cover and unclip
the cover.
After carrying out the work, close
the cover very carefully and
replace the style cover.
The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for rectify
ing the malfunctions resulting from
the installation of accessories not
supplied and not recommended by
PEUGEOT and not installed in
accordance with its instructions, in
particular where the equipment
in question consumes more than
10 milliamperes.
*Maxi fuses provide additional
protection for electrical systems.
All work must be carried out by
your PEUGEOT dealer.
Fuse N° Rating Functions
1* 70 A Builtin systems interface ( heated rear screen
heated exterior mirrors windscreen wiper
screenwash headlamp wash).
2* 50 A Fan.
3* 50/60 A ESP pump motor / ABS hydraulic unit.
4* 40 A Air conditioning blower.
5 20 A Horn Horn control relay.
6 20 A Left front and rear heated seats.
7 20 A Right front and rear heated seats.
8* 70 A Builtin systems interface.
9* 30 A Passenger electric seat.

Fuse N° RatingFunctions
10* 20 AAutomatic headlamp lighting control unit.
11* 70 A Builtin systems interface.
12* 70 A Ignition supply (+ve accessories / ignition controlled +ve).
13* 20 A Automatic headlamp lighting control unit.
14 15 A Double injection relay supply.
15* Not used.
16* Not used.
17* 30 A ESP hydraulic unit.
18 30 A Ignition supply (+ starter).
19 20 A Variable suspension control unit.
20 10 A Fan unit relay Cruise control safety switch Manual gearbox clut ch switch
Manual gearbox reversing lights switch or automatic gearbox multifu nction switch
Automatic headlamp lighting control unit Vehicle speed senso r Coolant level sensor
Water in diesel sensor Power switch control unit relay.
21 5 A Automatic gearbox control unit Automatic gearbox multifunction sw itch.
22 25 A ESP control unit.
23 15 A Diesel heating.
24 5 A Engine management control unit – Dual control control unit.
25 10 A Fuel pump.
26 30 A Driver's seat memory control unit.
27 25 A Double injection relay supply.
28 10 A Throttle housing deicing resistor, Intake pilot solenoid val ve Flow meter Piston deactivator
injectionpump Oil heating.
29 30 A Air pump, diesel additive control unit Diesel additive inje ctor.
30 Cannot be used.
31 5 A Automatic gearbox shift lock.
32 10 A ESP or ABS control unit.
33 15 A Automatic gearbox control unit Automatic gearbox multifunction sw itch (except reversing lights) Automatic
gearbox sequential control.
34 5 A Oxygen sensors Exhaust gas recirculation solenoid valve, Exhaust gas reci rculation throttle solenoid valve
Turbo pressure regulation solenoid valve..
PRACTICAL INFORMATION 149

Aflat battery prevents
the engine from starting.
PRACTICAL INFORMATION
150
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position
 Less than one minute after switch
ing off the ignition, activate the
windscreen wiper stalk to position
the blades in the centre of the
windscreen (maintenance posi
tion).
Replacing a blade  Lift the arm, then unclip the blade
and remove it.
 Fit the new blade and fold down
the arm.
To park the blades, switch on the
ignition and operate the wind
screen wiper stalk.
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, rear electric blind,
electric seats, audio equipment, tele
phone etc) can only be used for thir
ty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the
message "Economy mode active"
appears on the multi–function dis
play and the active functions are put
on standby.
REMOVING A MAT
When removing a mat on the driver's
or passenger's side, push back the
seat as far as possible and remove
the clips.
To remove a rear mat, push the cor
responding front seat forward and
remove the clip.
On refitting, position the mat and
press firmly to refit the securing clips.
LOAD REDUCTION
When driving, certain functions
(heated rear screen, heating system
for passenger compartment of diesel
vehicles, etc.) may be switched off
temporarily, depending on the level
of battery charge.
Reactivation of the functions on
standby is automatic, as soon as the
battery permits.
These functions are automatically
reactivated next time the vehicle is
driven.
Note:
if the telephone is being used
when economy mode starts, it will
still be possible to finish the call.