check engine Peugeot 607 Dag 2002 Owner's Manual

YOUR AT A GLANCE5
STARTING
STOP position:
The ignition is switched off.
1st notch, Accessories position:The ignition is switched off but
the accessories still function.
2nd notch, Running position:
The ignition is on.
Starting position:
Operates the starter.
Starting a diesel engineIf the temperature is highenough, the preheat
indicator light does not
come on and you can
start immediately.
If the indicator light comes on,
wait for it to go out before operat
ing the starter.
If the engine stalls, it is neces
sary to return the key to the
'Stop' position before restarting. CHECK
(vehicle autotest)
Automatic check
With the ignition on (2nd notch)
If no malfunction has been
detected: In the absence of
vehicle function status indi
cator lights, the OK light is
displayed after two seconds
on the instrument panel screen.
Otherwise, it will be displayed after
these indicator lights come on.
If a 'minor' malfunction has been
detected: the warning light for the
faulty function is displayed on the
instrument panel screen. Certain
indicator lights showing the status of
vehicle functions may also come on,
followed by the OKindicator light.
If a 'major' malfunction has been
detected: the corresponding warn
ing light is displayed on the instru
ment panel screen. Certain indicator
lights showing the status of vehicle
functions may also come on. The
OK indicator light does not come
on. Do not start your vehicle.
Contact a PEUGEOT dealer.
Afterwards, if the passenger air
bag is disarmed, the correspond
ing warning light will come on.
With the engine running or if the
vehicle is moving, the instrument
panel screen temporarily displays:
– lights indicating warnings, when
these occur,
– vehicle function sta tus indicator lights,
when a change
occurs.
The display of certain indicator
lights is accompanied by an audi
ble signal and a message on the
multifunction display.
MANUAL CHECK  Press the "CHECK" button on the
instrument panel.
With the ignition key in the accessories
position, with the ignition switched on,
with the engine running or the vehicle
moving, this function informs you at all
times of the following:
– any current warnings,
– the status of functions which it is possible to switch on or switch off
(windscreen wipers, automatic
switching on of lights, cruise con
trol, disarming of passenger air
bag, etc.).
The corresponding warning lights are
displayed in succession on the instru
ment panel screen.
If a warning or a change of status
occurs during the CHECKmode, the
corresponding indicator light(s) will be
displayed at the end of this mode.
Never run the engine in
a confined space.
Do not make any modi fications to the steering
lock.
31

CRUISE CONTROL
Cruise control enables the vehi
cle to maintain a steady speed
programmed by the driver, with
out the accelerator being
pressed.
In order for it to be memorised,
the speed of the vehicle must be
greater than 25mph (40km/h) or
40mph (60km/h) depending on
engine.
OperationPlace the ring of stalk
A in the ONposition. The
indicator light comes on,
accompanied by an audi
ble signal. FRONT AIR BAGS
Disarming the passenger air
bag*
with the ignition off, insert the
key into slot
1and turn it:
–to the 'ON'position, the pas
senger air bag is armed,
–to the 'OFF'position, the pas
senger air bag is disarmed.
Operating check When the passenger air
bag is disarmed, the
warning light comes on
when the ignition is
switched on (2nd notch),
accompanied by an audible sig
nal and the message 'Passenger
air bag disarmed' . Front air bag faulty
If this warning light
comes on, accompanied
by an audible signal and
the message 'Air bag
faulty' , contact a PEUGEOT
dealer to have the system
checked.
Passenger air bag
precautions
 Disarm the
air bag if you
install a rear
facing child
seat.  Arm the air
bag for an
adult passen
ger.
Never place your feet or any
object on the fascia.
* According to country
YOUR AT A GLANCE11
127129

YOUR AT A GLANCE9
REAR PARKING
ASSISTANCE
This system, installed in the rear
bumper, detects any obstacle (per
son, vehicle, tree, gate, kerb...)
located behind the vehicle.
To activate
With the engine running, the sys
tem is activated as soon as
reverse gear is engaged; a bleep
sounds to inform you that it is
active.
The proximity information is
given by an audible signal, con
sisting of bleeps which become
more and more rapid as the vehi
cle approaches the obstacle.
When the distance between the
rear of the vehicle and the obsta
cle is less than approximately
twentyfive centimetres, the
signal becomes con
tinuous.The system ceas
es to be active
when you change
to neutral. TYRE UNDERINFLATION
DETECTION
Sensors check the tyre pressure
during driving, and trigger a warn
ing if there is a malfunction (speed
greater than 15 mph (25 km/h).
Tyre underinflation
When this warning light
comes on, accompanied
by a bleep and the mes
sage 'Tyre(s) pressure
low', have the tyre pressure
checked as soon as possible.
Puncture
Display of this warning
light, accompanied by an
audible signal and the
message 'Punctured
tyre(s) detected', is followed by
illumination of the STOPwarning
light.
Stop immediately, avoiding all
abrupt manoeuvres with the
steering wheel and the brakes.
Change the damaged (punctured
or very underinflated) wheel and
have the tyre pressure checked
as soon as possible.
Note: if the damaged wheel is
stored temporarily in the boot, it
will again send this message as a
reminder of the necessity of hav
ing it repaired. This will prevent a
similar warning being displayed. Sensor(s) not detected
Display of this warning
light, accompanied by an
audible signal and the
message 'X tyre pres
sure sensor(s) missing', indi
cates that one or more wheels
are not being detected.
Contact a PEUGEOT dealer to
replace the faulty sensor(s).
Warning: this message is dis
played when one of the wheels is
at a distance from the vehicle
(being repaired) or when a wheel
without a sensor is fitted (winter
fitting).
This system does not eliminate
the need to check the tyre
pressure regularly.
128139

PEUGEOT SERVICING
The maintenance cycle of your 607 is based on level A(including the replacement of the engine oil, the oil fi lter and a
set of checks) and level Cservices [service level A+ workshop operations carried out every 40,000 miles (60 000 km)] in
accordance with the tables on the following pages.
So that the driving conditions and your style of driving may be taken into account, your 607 is fitted with a service indica
tor which programmes the intervals for the level A servic e:
• every 20,000 miles (30 000 km) maximum or 2 years for petrol engines,
• every 12,000 miles (20 000 km) maximum or 2 years for direct injection diesel engines,
The frequency of level Aservices specific to your vehicle will be determined by three elemen ts:
• the number of engine revolutions,
• the engine oil temperature,
• prolonged periods of the vehicle not being used.
Depending on these elements, the service indicator will suggest a time which is more or less the same as the initia l plan.
Depending on the conditions of use, one or more level Aservices can be carried out between two level C services.
Depending on the mileage recorded, your dealer may offer to ca rry out the level Cservice to avoid the visits being too close
together.
PEUGEOT SERVICING
18

The extension of the service intervals means that the engine oil level must be checked regularly: topping up of the
oil between two oil changes is normal.
It is for this reason that your Peugeot dealer will invite you to an intermediate visit between services. The date o f
this visit is not shown by the service indicator.
It is to be carried out between two services.
A Peugeot professional will carry out a quick check and will top up the levels if necessary (oil, coolant, screen wash up to
2 litres).
If the oil level is too low, there is a risk of significa nt damage to the engine: check the engine oil level at le ast every
3,000 miles (5 000 km).
This maintenance frequency is the result of developments to our vehicles and to the lubricants:
THUS IT IS ESSENTIAL THAT YOU ONLY USE ENGINE LUBRICANTS THAT ARE APPROVED AND RECOMMENDED
BY THE MANUFACTURER (see pages on 'Lubricants').
PEUGEOT SERVICING 19

PEUGEOT SERVICING 21
Zero reset
Your Peugeot dealer carries out this
operation after each service. Howev
er, if you carry out the service your
self, the reset procedure is as fol
lows: 
Switch off the ignition,
 Press and hold the trip recorder
reset button,
 Switch on the ignition.
The display begins a countdown.
When the display shows 0, release
the button; the service symbol disap
pears.
Important: after this operation, if
you wish to disconnect the battery,
lock the vehicle and wait for at least
five minutes, otherwise the zero re
set will not be registered.MAINTENANCE OF PARTS SUBJECT TO WEAR AND A CHECK OF CON
SUMABLES
Certain essential components on your vehicle are subject to checks a t specific
frequencies.
•The brake fluid is to be replaced at a maximum of every 36,000/40,000 miles
(60 000km) or every two years;
•The pollen filter must be checked at each serviceby a PEUGEOT dealer
(services and intermediate visits) or more often, depending on the environ
ment (dust, pollution, etc.);
•For HDI turbo diesel engines with particulate emission filter , maintenance
of the filterand topping up of the additive reservoirmust be carried out
every 48,000 miles (80 000 km) by a PEUGEOT dealer;
• Replacement of the timing belt: contact a PEUGEOT dealer.
• Air bags and pretensioning parts on seat belts must be replaced every
10 years.
• Tyre pressure sensors are to be replaced every 10 years.
• The check on tyre inflation presure must be carried out cold at least once a
month.

PEUGEOT SERVICING 25
Level
Operations Description of operation 1st service
A C Intermediate
DRAIN/REFILL Engine oil Bleed fuel filter (diesel) Oil filter Fuel filter
*(petrol)REPLACE Fuel filter element (diesel) Air filter element Spark plugs (petrol) Engine oil (check + topup) Manual gearbox oil (check + topup) Battery (check + topup) if cap is removableLEVEL Screen wash (check + topup) Coolant (check + topup) Brake fluid (check + topup) Power steering fluid (check + top up according to specification ) Operation of lights and indicators Condition of glass, headlamp and light lenses and mirrors Horn Windscreen washer jets Condition of wiper blades Condition and tension of the ancillary drive belts Handbrake Condition of hydraulic circuits (hoses and covers)CHECK Condition of rubber boots and gaiters Brake pads o Play in hubs, link rods, ball joints, flexible mountings Shock absorbers Rear drum brake lining wear Condition and pressure of tyres (including spare wheel) Emission control check as per current legislation (petrol) Smoke opacity (diesel) Pollen filter (according to specification)o
Visual check of the whole vehicle


: All driving conditions o: Arduous conditions * According to destination
SERVICE
ROAD TEST
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Courtesy vehicle

INSTRUMENTS AND CONTROLS
28
1 Handbrake indicator light.
2 Main beam headlamps indicator
light.
3 Dipped beam headlamps
indicator light.
4 Rev counter.
5 Lefthand direction indicator.
6 Fuel gauge.
7 Righthand direction indicator.
8 Speedometer. 9
Front fog lamps indicator light.
10 ABS antilock braking system
warning light.
11 Rear fog lamps indicator light.
12 Engine diagnostics warning
light.
13 Coolant temperature indicator.
14 CHECK button.
15 Trip recorder zero reset.
16 Service indicator and total
distance recorder. 17
Warning/status screen.
18 Illumination button +.
19 Illumination button .
20 Engine oil level indicator.
Engine oil temperature
indicator.
INSTRUMENT PANEL DIALS: PETROL

INSTRUMENTS AND CONTROLS29
1
Handbrake indicator light.
2 Main beam headlamps
indicator light.
3 Dipped beam headlamps
indicator light.
4 Rev counter.
5 Lefthand direction indicator.
6 Fuel gauge.
7 Righthand direction indicator.
8 Speedometer. 9 Front fog lamps indicator light.
10
ABS antilock braking system
warning light.
11 Rear fog lamps indicator light.
12 Engine diagnostics warning
light.
13 Coolant temperature indicator.
14 CHECK button.
15 Trip recorder zero reset.
16 Service indicator and total
distance recorder. 17
Warning/status screen.
18 Illumination button +.
19 Illumination button .
20 Engine oil level indicator.
20Engine oil temperature
indicator.
INSTRUMENT PANEL DIALS: DIESEL

INSTRUMENTS AND CONTROLS31
Coolant temperature warning light
This symbol is accompanied by an audible signal and the message
'Engine temperature too high'
on the multifunction display.
It is linked to the STOPwarning light. Stop immediately.
Warning: wait for the engine to cool.
If necessary, top up the level.
With the engine running and the vehicle moving
The instrument panel display temporarily shows:
– lights indicating warnings, when these occur,
– vehicle function status indicator lights, when a change occu rs.
Certain warning lights may be accompanied by an audib le signal and a
message on the multifunction display.
List of warning symbols MANUAL CHECK
(vehicle autotest)
 Press the "CHECK"button on
the instrument panel.
With the ignition key in the acces
sories position, with the ignition
switched on, with the engine running
or when the vehicle is moving, this
function informs you at all times of
the following: – any current warnings,
– the status of functions which it is possible to switch on or off (wind
screen wipers, automatic switch
ing on of lights, cruise control, dis
arming of passenger air bag, etc.).
The corresponding warning lights
are displayed in succession on the
instrument panel screen.
If a warning or a change of status
occurs during the CHECKmode, the
corresponding indicator lights will be
displayed at the end of this mode.
CHECK mode entry indi
cator light (vehicle
autotest)
This comes on when you
press the 'CHECK' button.
CHECK mode exit indica
tor light (vehicle autotest)
This comes on at the end of
the CHECK mode.
Engine oil pressure warning light
This symbol is accompanied by an audible signal and the message
'Insufficient engine oil pressure' or 'Engine oil pressure too low' on
the multifunction display.
It is linked to the STOPwarning light.
Stop immediately if this comes on when the engine is running.
If there is a lack of oil in the lubrication circuit, top up the level.
Contact a PEUGEOT dealer as soon as possible.
Puncture warning light
This symbol comes on accompanied by an audible signal and the me s
sage 'Punctured tyre(s) detected' on the multifunction display.
It is linked to the STOPwarning light. Stop immediately.
Change the damaged wheel.
Have it repaired by a PEUGEOT dealer.