ECO mode Peugeot 607 Dag 2009 User Guide

8
88
Operating check
The gearbox may be dama-
ged if you: - press the accelerator and brake pedals at the same
time,
- force the lever from position P to
another position when the battery
is fl at.
ELECTRONICALLY
CONTROLLED SUSPENSION
 Press switch 1 , the in-
dicator light and the

SPORT indicator light will
come on.
In this position, the suspension is
maintained in the SPORT position,
the shock absorption and the steering
assistance become fi rmer.
Selecting the SPORT position

 Press switch 1 again. The
indicator light will go out
and the AUTO indicator
light comes on, accompa-
nied by an audible signal.
Return to automatic operation
If the switch light fl ashes or if
the indicator light comes on,
accompanied by an audible
signal and a message, contact
a PEUGEOT dealer.
Operating check
This is confi rmed by the switch light
and the indicator lights. The switch li-
ght comes on for approximately three
seconds every time the ignition is swit-
ched on.
Any operating abnormality is
indicated by lighting of this
warning light, accompanied
by an audible signal and a
message on the multifunc-
tion display.
In this situation the gearbox opera-
tes in downgrade mode (locked in
3rd gear). You may feel a substantial
knock when changing from P to R and
from N to R (this will not cause any da-
mage to the gearbox).
Do not exceed 60 mph (100 km/h) or
keep within local speed limits.
Consult a PEUGEOT dealer.
The suspension adapts automatically
and instantly to different driving styles
and road characteristics, improving
the comfort of the occupants and the
vehicle's road holding capabilities.
The suspension favours a smooth
shock absorption, ensuring a comfor-
table ride, but as soon as conditions
demand a change (sporty driving, ti-
ght bends, avoidance action, etc.), it
automatically selects fi rmer shock ab-
sorption, guaranteeing optimum road
holding.
When the ignition is switched on, the
electronic suspension is always active
in automatic operation mode.

8
89
CRUISE CONTROL/
SPEED LIMITER
Selecting the function

 Place switch 1 in the CRUISE
position. The cruise control is not
yet active and no speed has been
memorised. The display indicates: Cancelling the memorised speed
If you wish to cancel the memorised
speed:

 Press button 4 or the brake or
clutch pedal.
The display indicates (e.g. at 70 mph
(110 km/h)):
Switching the function off

 Place switch 1 in position 0 or LIMIT
to switch the system off.
First activation/memorising a
speed
As soon as you reach the cho-
sen speed, press button "set-" 2 or
"set+" 3 . This memorises the speed,
which will be maintained automatically.
The display indicates (e.g. at 70 mph
(110 km/h)):

Note: It is possible to acce-
lerate and drive momentarily
at a speed greater than the
memorised speed. The value
memorised fl ashes. When the accele-
rator pedal is released, the vehicle will
return to the memorised speed.
Note: the speed memorised
is cancelled automatically if
the vehicle speed is less than
25 mph (40 km/h), or if the
manual gearbox is in a gear lower than
fourth (second gear for the automatic
gearbox) or if the ESP is activated.
On a steep descent, the cruise
control, which does not act on
the brakes, will not be able to
prevent the vehicle from excee-
ding the programmed speed.
The cruise control cannot, in any circums-
tances, replace the need to comply with
speed limits or the need for vigilance and
responsibility on the part of the driver.
It is advisable to keep your feet near
the pedals at all times.
Cruise control function
This enables the vehicle to maintain a
steady speed programmed by the driver.
In order for it to be memorised, the
vehicle speed must be greater than
25 mph (40 km/h) with at least fourth
gear engaged for vehicles fi tted with a
manual gearbox.
On vehicles fi tted with an automatic
gearbox, the lever must be in position D
or at least second gear must be enga-
ged in sequential driving mode.

1010
110
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position

 Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
ENERGY ECONOMY MODE
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, sunroof, electric seats,
audio equipment, telephone, dipped
headlamps, video, etc.) can only be
used for a limited combined duration,
to prevent discharging of the battery.
Once this period has elapsed, a
switching to economy mode message
appears on the multifunction display
and the active functions are put on
standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to exit the economy mode and
resume the use of these functions im-
mediately, the engine must be started
and left to run for a few minutes.
If the engine has been running for at
least 10 minutes, all of the functions
are active for 30 minutes.
If the engine has been running for
less than 10 minutes, this duration
before returning to economy mode is
5 minutes. All of these functions are
available when the engine is
running.
If the telephone is being used
when economy mode starts, it will still
be possible to fi nish the call.
LOAD REDUCTION FUNCTION
When driving, certain functions (air con-
ditioning, heated rear screen, heating
system for passenger compartment of
diesel vehicles, etc.) may be switched
off temporarily, depending on the level
of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
suffi cient.

Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated manually.
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. A fl at battery prevents the en-
gine from starting.
If the doors or boot are opened
several times or if the alarm is
triggered, this may result in activation
of the energy economy mode.

1010
113
TOWING A TRAILER,
CARAVAN, BOAT, ETC...
We recommend the use of original
PEUGEOT towbars and their harnesses
which have been tested and approved
from the design stage of your vehicle and
that you entrust the fi tting of the towbar to
a PEUGEOT dealer.
If the towbar is not fi tted by a PEUGEOT
dealer, it is imperative that it is fi tted us-
ing the electrical pre-equipment installed
at the rear of the vehicle, in accordance
with the manufacturer's instructions.
Note: in certain cases of par-
ticularly arduous use (towing
the maximum load in high
temperatures on a steep
slope), the engine automatically lim-
its its power and selects the appropri-
ate automatic gearbox gear in manual
mode. In this case, cutting off the air
conditioning allows the engine power
to be recovered, and therefore the
towing capacity to be increased. Automatic adjustment
To avoid causing a nuisance to other
road users, this system automatical-
ly corrects the height of the beam of
xenon bulbs in relation to the vehicle
load after approximately 2 minutes.
The driver is then assured of having
optimum lighting.
Driving advice

Distribution of loads: distribute the
load in the trailer so that the heavi-
est loads are as close as possible to
the axle and the nose weight is close
to the maximum authorised without,
however, exceeding it.
Lighting

Tyres: check the tyre pressures of the
towing vehicle (label on the central
door pillar on the driver's side) and of
the trailer towed, observing the recom-
mended pressure.
If the coolant temperature
warning light comes on, stop
the vehicle and switch off the
engine as soon as possible.
In the case of vehicles fi tted with an
HDI engine, it is advisable, following
intensive use (towing on a motorway,
prolonged driving, ...), to leave the en-
gine running at idle for approximately
20 seconds before switching off the
ignition. This limits any increase in the
temperature of the engine after it has
been switched off.
In all cases, pay attention to the coolant
temperature.

Brakes: towing increases the braking
distance. Drive at a moderate speed,
change down early and brake gradually.

Side wind: sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed.

Cooling: towing a trailer on a slope in-
creases the coolant temperature.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.

157
1
4
2
3
3
3
4
4
2
4
3
4
4
4
4
4
3
2
3
4
4
4
4
3
3
3
3
4
4
3
3
5
5
5
3
3
2
3
5
5
3
2
4
3
5
4
3
4
3
4
4
3
3
4
4
4
4
4
3
5
4
5
5
2
3
4
4
current album
current track
eject CD
receive by infrared
exchange with SIM card
send all records to SIM
send one record to SIM
receive all SIM fi les
receive a SIM fi le
exchange with Bluetooth
TELEMATICS
call list
dial
directory
mailbox
services
customer contact centre
PEUGEOT assistance
PEUGEOT service
messages received
USB
copy USB to Jukebox
complete disc
multiple selection
current album
current track
eject USB
CALL
DIRECTORY
managing directory fi les
consult or modify a fi le
add a fi le
delete a fi le
delete all fi les
confi gure directory
select a directory
name directory
select starting directory
fi le transfer
exchange by infrared
send all records
send one record
TEXT MESSAGES (SMS)
read received text messages
send a text message
write a text message
delete list of text messages
TELEPHONE FUNCTIONS
network
network search mode
automatic mode
manual mode
networks available
length of calls
reset
manage PIN code
activate/deactivate
save PIN code
JUKEBOX
jukebox management
jukebox confi guration
hi-fi (320 kbps)
high (192 kbps)
normal (128 kbps)
playlist management
delete jukebox data
Jukebox status