check engine Peugeot 607 Dag 2009 User Guide
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: 607 Dag, Model: Peugeot 607 Dag 2009Pages: 182, PDF Size: 10.7 MB
Page 107 of 182
8
90
Changing a memorised speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:
press button 3 ;
A brief press increases by 1 mph (1 km/h).
A maintained press increases in steps
of 5 mph (5 km/h).
Using the accelerator:
exceed the memorised speed until
the required speed is reached,
press button 2 or 3 .
To memorise a speed lower than the
previous one:
press button 2 ;
A brief press decreases by 1 mph
(1 km/h).
A maintained press decreases in steps
of 5 mph (5 km/h).
Reactivating the memorised speed
After cancellation, press button
4 . Your
vehicle will return to the last memorised
speed. The display indicates (e.g. at
70 mph (110 km/h)): Cancelling the memorised speed
When the vehicle is stationary, af-
ter the ignition has been switched
off, the system no longer stores
any speed.
Operating check
In the event of a cruise control malfunc-
tion, the memorised speed is erased,
t h e d a s h e s fl a s h f o r a f e w s e c o n d s :
Do not use the cruise control
on slippery roads or in heavy
t r a f fi c .
Contact a PEUGEOT dealer to have
the system checked. This prevents the vehicle speed ex-
ceeding the speed programmed by
the driver (minimum speed of 18 mph
(30 km/h)).
The operations must be carried out:
- while stationary, with the engine
running,
or
- while the vehicle is moving.
Speed limiter function
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat is positioned
correctly,
- n e v e r fi t o n e m a t o n t o p o f a n o t h e r .
Page 111 of 182
9
95
BONNET
Closing
Lower the bonnet and release it at
the end of its travel.
Check that it is locked.
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is nec-
essary to re-prime the circuit.
If the engine does not start after
15 seconds, repeat the repriming ope-
ration.
Opening
Pull the lever, located on the left
beneath the dashboard, down-
wards.
Lift the catch and raise the bonnet.
Bonnet struts open the bonnet and
keep it open.
2 litre 16V HDI engine
- fi l l t h e f u e l t a n k w i t h a t l e a s t fi v e l i - tres of diesel,
- unclip the style cover to gain ac- cess to the repriming pump,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is seen
escaping via the degas screw,
- retighten the degas screw,
- operate the starter until the engine starts.
2.7 litre 24V V6 HDI engine
- fi l l t h e f u e l t a n k w i t h a t l e a s t fi v e l i -tres of diesel,
- switch on the ignition and wait 15 seconds before operating the
starter.
Page 114 of 182
9
98
CHECKING THE LEVELS
There are two marks on
the dipstick:
A = maximum
N e v e r fi l l p a s t t h i s m a r k .
B = minimum
To maintain the reliability
of engines and emission
control systems, the use
of additives in engine oil is
prohibited.
Dipstick
Oil change
According to the information given in
the servicing booklet.
The level must always be between the
DANGER and MAXIMUM marks in the
reservoir.
If the level drops substantially, contact
a PEUGEOT dealer immediately.
Windscreen and headlamp wash level
For best quality cleaning and for your
safety, we advise that you use prod-
ucts recommended by PEUGEOT
(reservoir capacity 4 litres or 6.5 litres
with headlamp wash).
Viscosity selection
In all cases, the oil selected must meet
the manufacturer's requirements. Fluid change:
- must be carried out according
to the manufacturer's servicing
schedule.
- u s e fl u i d s r e c o m m e n d e d b y t h e m a n u f a c t u r e r , w h i c h f u l fi l D O T 4
standards.
Used oil
Prevent used oil from coming
into prolonged contact with
the skin.
B r a k e a n d c l u t c h fl u i d i s h a r m f u l t o
health and very corrosive.
Do not dispose of used oil, brake and
c l u t c h fl u i d o r c o o l a n t i n t o d r a i n s o r
onto the ground.
Power steering reservoir
Open the reservoir, with the engine
cold at ambient temperature. The
level should always be above the
MINI mark and close to the MAXI
mark.
Oil level
Check the level regularly and top
up between changes.
Carry out this check with the vehicle
level, engine cold, using the oil level
gauge on the instrument panel or the
dipstick. C h a r a c t e r i s t i c s o f t h e fl u i d
For best quality cleaning and to pre-
v e n t f r e e z i n g , t h i s fl u i d m u s t n o t b e
topped up or replaced with water.
Page 115 of 182
9
99
CHECKS Handbrake
Where the handbrake travel
is too great or there is a re-
duction in the performance of the
system, the handbrake should be ad-
justed. Have the system checked by a
PEUGEOT dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent quality
a n d s p e c i fi c a t i o n .
To ensure best performance from
components as important as the pow-
er steering and the braking system,
P E U G E O T s e l e c t s a n d o f f e r s s p e c i fi c
products.
To prevent damage to the electrical
units, high pressure washing of the en-
gine compartment is strictly prohibited .
In order to check the main levels
and certain components, in accord-
ance with the manufacturer's servi-
cing schedule, refer to the pages of
the servicing booklet which corres-
pond to your vehicle's engine. Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Air filter and passenger compartment filter
H a v e t h e fi l t e r e l e m e n t s r e -
placed regularly. If you drive
in dusty conditions, change them
twice as often .
Particulate emission filter - Additive reservoir (Diesel)
Maintenance of the particulate emis-
s i o n fi l t e r a n d fi l l i n g o f t h e a d d i t i v e
reservoir must be carried out by a
PEUGEOT dealer, according to the
manufacturer's servicing schedule.
Brake pads
Brake pad wear depends on
the style of driving, in particu-
lar for vehicles which are used in town,
over short distances.
Manual gearbox
This does not need an oil change.
Have the level checked, according to
the manufacturer's servicing schedule.
Automatic gearbox
This does not need an oil change. Have
the level checked by a PEUGEOT
dealer, according to the manufacturer's
servicing schedule.
Oil filter
C h a n g e t h e fi l t e r r e g u l a r l y , i n a c c o r d -
ance with the servicing schedule.
It may be necessary to check
the thickness of the pads,
even between services.
Disc wear condition
For any information relating to check-
ing of the disc wear condition, contact
a PEUGEOT dealer.
Page 132 of 182
1010
113
TOWING A TRAILER,
CARAVAN, BOAT, ETC...
We recommend the use of original
PEUGEOT towbars and their harnesses
which have been tested and approved
from the design stage of your vehicle and
t h a t y o u e n t r u s t t h e fi t t i n g o f t h e t o w b a r t o
a PEUGEOT dealer.
I f t h e t o w b a r i s n o t fi t t e d b y a P E U G E O T
d e a l e r , i t i s i m p e r a t i v e t h a t i t i s fi t t e d u s -
ing the electrical pre-equipment installed
at the rear of the vehicle, in accordance
with the manufacturer's instructions.
Note: in certain cases of par-
ticularly arduous use (towing
the maximum load in high
temperatures on a steep
slope), the engine automatically lim-
its its power and selects the appropri-
ate automatic gearbox gear in manual
mode. In this case, cutting off the air
conditioning allows the engine power
to be recovered, and therefore the
towing capacity to be increased. A u t o m a t i c a d j u s t m e n t
To avoid causing a nuisance to other
road users, this system automatical-
ly corrects the height of the beam of
xenon bulbs in relation to the vehicle
load after approximately 2 minutes.
The driver is then assured of having
optimum lighting.
D r i v i n g a d v i c e
D i s t r i b u t i o n o f l o a d s : distribute the
load in the trailer so that the heavi-
est loads are as close as possible to
the axle and the nose weight is close
to the maximum authorised without,
however, exceeding it.
Lighting
Tyres: check the tyre pressures of the
towing vehicle (label on the central
door pillar on the driver's side) and of
the trailer towed, observing the recom-
mended pressure.
If the coolant temperature
warning light comes on, stop
the vehicle and switch off the
engine as soon as possible.
I n t h e c a s e o f v e h i c l e s fi t t e d w i t h a n
HDI engine, it is advisable, following
intensive use (towing on a motorway,
prolonged driving, ...), to leave the en-
gine running at idle for approximately
20 seconds before switching off the
ignition. This limits any increase in the
temperature of the engine after it has
been switched off.
In all cases, pay attention to the coolant
temperature.
Brakes: towing increases the braking
distance. Drive at a moderate speed,
change down early and brake gradually.
S i d e w i n d : sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed.
Cooling: towing a trailer on a slope in-
creases the coolant temperature.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.