heating Peugeot 607 Dag 2009 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2009, Model line: 607 Dag, Model: Peugeot 607 Dag 2009Pages: 182, PDF Size: 10.7 MB
Page 16 of 182
1
19
DIESEL MANUAL AND AUTOMATIC GEARBOXES
INSTRUMENT PANEL
1. Engine oil temperature indicator.
2. H a n d b r a k e , l o w b r a k e fl u i d l e v e l a n d
electronic brake force distribution
warning light.
3. Seat belt not fastened/unfastened
warning light.
4. Dipped headlamps indicator light.
5. Main beam headlamps indicator
light.
6. Lighting rheostat buttons.
7. R e v c o u n t e r .
8. Anti-lock braking system (ABS)
warning light.
9. Diesel engine pre-heating warning
light.
10. Emission control system warning
light.
11. Left direction indicator.
12. L o w f u e l l e v e l w a r n i n g l i g h t .
13. Fuel gauge.
14. Functions display screen:
- Check.
- E n g i n e o i l l e v e l g a u g e .
- Warning and status indicator lights.
- Cruise control/speed limiter.
- Automatic gearbox.
- Trip computer.
- S a t e l l i t e n a v i g a t i o n s y s t e m .
15. Right direction indicator.
16. Speedometer.
17. S e r v i c e i n d i c a t o r , t o t a l a n d t r i p
distance recorders.
18. Trip distance recorder zero reset
button.
19. Manual check button.
20. Rear fog lamps indicator light.
21. Front fog lamps indicator light.
22.
Passenger air bag disarmed warning light *
23. Coolant temperature indicator.
* According to country.
Page 18 of 182
1
21
Seat belt not fastened/
unfastened warning light
W i t h t h e v e h i c l e s t a t i o n a r y ,
when the ignition is switched
on, the warning light comes
o n i f t h e d r i v e r a n d / o r t h e
front passenger has not fas-
tened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
fl a s h e s a c c o m p a n i e d b y a n i n c r e a s -
ingly loud audible signal. Once these
t w o m i n u t e s h a v e e l a p s e d , t h e w a r n -
i n g l i g h t r e m a i n s o n u n t i l t h e d r i v e r o r
front passenger fastens his seat belt.
W h e n t h e v e h i c l e i s m o v i n g , t h e w a r n -
i n g l i g h t c o m e s o n i f t h e d r i v e r o r o n e
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
I f t h e t e m p e r a t u r e i s s u f fi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
o f v e h i c l e f u n c t i o n s . I f t h e s e i n d i c a t o r
lights are present, the CHECK OK in-
dicator light will come on after these.
You may start your vehicle.
If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
v e h i c l e f u n c t i o n s m a y a l s o c o m e o n ,
followed by the CHECK OK indicator
light.
You can start your vehicle; h o w e v e r ,
contact a PEUGEOT dealer as soon
as possible.
If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
s h o w i n g t h e s t a t u s o f v e h i c l e f u n c t i o n s
may also come on. The CHECK OK
indicator light does not come on.
Do not start your vehicle. Consult a
PEUGEOT dealer.
Following this, the following information appears on the instrument panel display:
T h e e n g i n e o i l l e v e l a p p e a r s f o r a p -
proximately 7 seconds; at the same
t i m e , t h e s e r v i c e i n d i c a t o r a p p e a r s o n
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle carries out an automatic test which appears on the instrument panel display:
Page 49 of 182
3
48
Memorising driving and mirror positions
Memorising using the controls on
the driver's door
To memorise:
Place the key in the ignition on po-
sition,
Adjust your seat and mirrors,
Press button M , then button 1 " fi r s t
driving position" or button 2 "sec-
ond driving position" within four
seconds.
A n a u d i b l e s i g n a l c o n fi r m s t h a t a p o s i t i o n
has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
I g n i t i o n o n , v e h i c l e s t a t i o n a r y
B r i e fl y p r e s s b u t t o n 1 or 2 to recall
the corresponding memorised po-
sition. The end of the setting is in-
dicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0
: Off.
1
: Low.
2
: Medium.
3
: H i g h . The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving
Keep button 1 or 2 pressed down
until the bleep indicates that set-
ting of the corresponding memo-
rised position is complete.
Page 50 of 182
3
48
Memorising driving and mirror positions
Memorising using the controls on
the driver's door
To memorise:
Place the key in the ignition on po-
sition,
Adjust your seat and mirrors,
Press button M , then button 1 " fi r s t
driving position" or button 2 "sec-
ond driving position" within four
seconds.
A n a u d i b l e s i g n a l c o n fi r m s t h a t a p o s i t i o n
has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
I g n i t i o n o n , v e h i c l e s t a t i o n a r y
B r i e fl y p r e s s b u t t o n 1 or 2 to recall
the corresponding memorised po-
sition. The end of the setting is in-
dicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0
: Off.
1
: Low.
2
: Medium.
3
: H i g h . The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving
Keep button 1 or 2 pressed down
until the bleep indicates that set-
ting of the corresponding memo-
rised position is complete.
Page 126 of 182
1010
108
E n g i n e c o m p a r t m e n t f u s e s
F u s e N ° Rating
F u n c t i o n s
F1 20 A Engine management control unit.
F2 15 A Horn.
F3 10 A Rear electric blind.
F4 20 A Headlamp wash.
F5 15 A Fuel pump (except 2 litre HDI 16V), diesel heater (2 litre HD
I 16V), turbocharger and diesel
pre-heat unit (2.7 litre HDI 24V).
F6 10 A Power steering, suspension control unit, automatic gearbox, aut
omatic headlamp
adjustment unit.
F7 10 A ESP control unit.
F8 25 A Starter coil.
F9 10 A Coolant level sensor, passenger compartment heating (HDI), S TOP switch.
F10 30 A Engine management actuators (injectors, ignition coil, solen oid valves, oxygen sensors).
To access the fuses located in the en-
gine compartment, remove the cover
and unclip the fuse box lid.
W h e n y o u h a v e fi n i s h e d , c l o s e t h e l i d
carefully to guarantee the sealing of
t h e f u s e b o x a n d r e fi t t h e c o v e r .
Page 128 of 182
1010
110
C H A N G I N G A W I N D S C R E E N
W I P E R B L A D E
Placing the wiper blades in the
maintenance position
Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
E N E R G Y E C O N O M Y M O D E
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, sunroof, electric seats,
audio equipment, telephone, dipped
headlamps, video, etc.) can only be
used for a limited combined duration,
to prevent discharging of the battery.
Once this period has elapsed, a
switching to economy mode message
appears on the multifunction display
and the active functions are put on
standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to exit the economy mode and
resume the use of these functions im-
mediately, the engine must be started
and left to run for a few minutes.
If the engine has been running for at
least 10 minutes, all of the functions
are active for 30 minutes.
If the engine has been running for
less than 10 minutes, this duration
before returning to economy mode is
5 minutes. All of these functions are
available when the engine is
running.
If the telephone is being used
when economy mode starts, it will still
b e p o s s i b l e t o fi n i s h t h e c a l l .
L O A D R E D U C T I O N F U N C T I O N
When driving, certain functions (air con-
ditioning, heated rear screen, heating
system for passenger compartment of
diesel vehicles, etc.) may be switched
off temporarily, depending on the level
of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
s u f fi c i e n t .
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated manually.
Replacing a blade
Lift the arm, then unclip the blade
and remove it.
Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. A fl a t b a t t e r y p r e v e n t s t h e e n -
gine from starting.
If the doors or boot are opened
several times or if the alarm is
triggered, this may result in activation
of the energy economy mode.