tow PEUGEOT 807 2002.5 User Guide

YOUR 807 IN DETAIL93
THE REAR SEATS
Forwards/backwards
adjustment
Lift bar Aand slide the seat towards
the front or the rear.
From the third row you can pull on
strap B and slide the seat towards
the front.
This makes it easier for passengers
to exit the 3rd row of seats, when
folding down the second row seat.
Adjusting the angle of the seat
back
Push lever Cupwards and adjust the
angle as required.
Release the lever to lock.
Folding a side seat
Access to the third row:
Place the head restraint in the low
position.
Push control Cupwards as far as
possible.
Tilt the seat back towards the front
until the rear anchorages are
unlocked.
Fold the seat back onto the seat
cushion.
Place the seat in the closed position.
Exiting the third row:
Place the head restraint in the low
position.
Push control Dupwards as far as
possible.
Tilt the seat back towards the front
until the rear anchorages are
unlocked.
Fold the seat back onto the seat cushion.
Place the seat in the closed position. Table position of a side seat
Fold the corresponding seat.
Tilt the fold seat rearwards, until the
rear anchorages lock.
You now have a shelf with two cup
holders.
Folding a side seat from the table
position
Lift the seat back.
Fold as described opposite.
18-11-2002

Removing a seat
Fold the corresponding seat.
Grasp the two bars Gunder the seat
and tighten them securely.
The front anchorages unlock.
Lift the seat and carry it using the
carrying handle H.
Refitting a seat
Check that there is no obstacle
obstructing the slides or preventing
correct locking of the seat.
Locate the front anchorages in the
slides (if necessary tighten the two
bars Gsecurely).
Tilt the folded seat towards the rear.
The rear anchorages lock.
Lift the seat back (for the centre seat,
move control E) Turning a seat round
The rear seats can be placed in the
'rearwards facing' position.
For this, after the seat has been fold
ed, carry out the removal and replac
ing operations for the seat and turn it
round.
YOUR 807 IN DETAIL
94
Table position of the centre seat
Place the head restraint in the low
position.
Push control Eupwards.
Tilt the seat back forwards.
You now have a table with two cup
holders.
Folding the centre seat
Place the seat in the table position.
Lift control F
Place the seat in the closed position. This turning operation
must be carried out with
the engine switched off.
It is prohibited to sit facing
the rear when the vehicle
is being driven.
Never use the adjusting straps to
remove, refit or transport a seat.
When the vehicle is being driven,
it is prohibited to place a side seat
in the closed position, when a
passenger is sitting in the 3rd row.
18-11-2002

THE REAR SEAT
Forwards/backwards
adjustment
Lift bar Aand slide the seat towards
the front or the rear.
Note: to make it easier to load the
vehicle through the tailgate, you can
pull on strap B and slide the seat for
wards. Rear parcel shelf position
Place the head restraints in the low
position.
Push control
Cupwards, from the
tailgate.
Tilt the seat back on the seat
cushion.
Folding the seat
Place the head restraints in the low
position.
Push control Cupwards, from the
tailgate.
Fold the seat back onto the seat
cushion.
Pull on strap Dto unlock the rear
anchorages.
Place the seat in the closed position.
When driving, attach the retaining
straps to the handles. Removing the seat
Fold down the seat.
Grasp the two bars
Eunderneath the
seat.
The front anchorages unlock.
Note: for removal and refitting, pass
the rear seat, in the "folded" position,
through the sliding side doors.
Refitting the seat
Check that there is nothing block
ing the runners which could pre
vet corrrect locking of the seat
anchorages.
Position the front anchorages at the
front stop of the runners.
Tilt the folded seat rearwards.
The rear anchorages then lock.
Unlock the seat back using control C
and pull it up using the strap.
YOUR 807 IN DETAIL 95
Never use the adjustment
straps to remove, refit or
transport the seat.
18-11-2002

YOUR 807 IN DETAIL109
T
ailgate release
This enables the tailgate to be
unlocked in the event of a central
locking fault.  Fold back a 2 nd
row rear seat,
 Fold back a 3 rd
row rear seat or
the bench seat to gain access to
the lock from inside the boot,
 Insert a small screwdriver into
hole Ain the lock and push it
towards the left to unlock the
tailgate .
TAILGATE
Simultaneous locking or unlock
ing of the tailgate and the doors
The tailgate is locked or unlocked by
the remote control or the driver's
door or passenger door lock.
To open, operate the handle
Aand
lift the tailgate.
Note: The tailgate locks automatical
ly when the vehicle is being driven at
more than 6 mph (10 km/h) and
unlocks when one of the doors is
opened.
"Tailgate open" warning
When the engine is running or the
vehicle is being driven, you are
warned if the tailgate is not closed
correctly by a diagram on the
multi–function display, accompanied
by an audible signal. Partially opening rear
windows
To partially open the rear windows,
tilt the lever
Aand push it fully to
lock the windows in the open posi
tion.
18-11-2002

Direction indicators
(flashers)Left:downwards.
Right: upwards.
YOUR 807 IN DETAIL
112
LIGHTING CONTROL
Front and rear lights
Selection is by turning ring
A.
Lights off
Side lights on Dipped beam/Main
beam
Automatic switching
on of lights Dipped beam/main beam change
Pull the stalk fully towards you.
Lightson buzzer
When the ignition is switched off,
when the driver's door or front pas
senger door is opened, a buzzer
sounds, accompanied by the mes
sage
"Side lights on" on the
multi–function display if you have left
your lights on.
Front and rear fog lights
Rotate ring Bforwards to switch on
and rearwards to switch off. The sta
tus is confirmed by the light on the
instrument panel.
Front fog lights (1 st
rotation
of the ring forwards)
These operate with the side lights
and the dipped beam headlamps. Front and rear fog
lights (2nd
rotation of
the ring forwards) These operate with the side lights
and the dipped beam headlamps.
Note:
to switch off the front and rear
fog lights, turn the ring rearwards
twice in succession.
In clear weather or in
rain, both day and night,
rear fog lights dazzle and
are prohibited.
Do not forget to switch
them off when they are no longer
needed.
Automatic switching on of the
lights switches off the rear fog
lamps, but the front fog lamps
remain on.
18-11-2002

YOUR 807 IN DETAIL
114
WINDSCREEN WIPER STALK
Front windscreen wiper stalk with
intermittent wipe
2 Fast wipe
(heavy rain).
1 Normal wipe
(moderate rain).
l Intermittent wipe.
0 Off.
Single wipe
(press downwards). Front windscreen wiper stalk with
automatic wipe
2 Fast wipe
(heavy rain).
1 Normal wipe
(moderate rain).
AUTO Automatic wipe.
0 Off.
Single wipe
(press downwards). Operation
In position
1or 2, when the vehicle
stops, the windscreen wiper
changes to a lower wiping speed,
then resumes its initial speed when
the vehicle starts again.
In the Intermittent position, the wip
ing speed is proportional to the
speed of the vehicle.
In the AUTOposition, the wiping
speed is proportional to the heavi
ness of the rain.
When the ignition has been
switched off for more than one
minute with the stalk in the wipe
position, it is necesary to reacti
vate this function. To do this, move
the stalk to any position, then move
it back to the required position.
Windscreen and headlamp wash
Pull the windscreen wiper stalk
towards you.
The windscreen wash then the wind
screen wipers operate for a fixed
period.
The windscreen wash and headlamp
wash operate simultaneously for a
few seconds, only if the dipped
beam or main beam headlamps
are on.
18-11-2002

Horn
Press one of the spokes or
the centre of the steering
wheel.
YOUR 807 IN DETAIL
122
Manual adjustment of the
headlamps
Depending on the load in your vehi
cle, adjusting the beam of your head
lamps is recommended.
0 1 or 2 people in the front seats.
1 5 people.
2 6 to 8 people.
3 Driver + maximum authorised
loads.
Initial setting is position 0.
Automatic adjustment of
headlamps
Refer to the paragraph on Lighting
under the section entitled 'Towing a
trailer...'. Hazard warning lights
Press the button, the direction indi
cators flash.
They can operate with the ignition
off.
Steering wheel height and
depth adjustment
When the vehicle is stationary,
unlock the steering wheel by lower
ing the lever
A.
Adjust the height and depth of the
steering wheel, then lock by pushing
lever Afully upwards.
Automatic lighting of hazard
warning lights*
When braking in an emergency,
depending on the force of decelera
tion, the hazard warning lights come
on automatically. They switch off
automatically the first time you accel
erate.
It is also possible to switch them off
by pressing the button on the fascia.
*According to destination.
18-11-2002

YOUR 807 IN DETAIL127
REAR INTERIOR LAYOUT
1. Access handle
2. Grab handle and coat hook
3. Door tray with storage for a
can and a bottle of water or for
the portable bin with ashtray
4. High load retaining net fasten ings
Open the covers of the upper
fastenings at the 3rd row.
Install the ends of the metal bar
in these fastenings.
Secure the two tray strap hooks
in the stowing rings on the floor.
Pull the two straps taut.
Secure the two hooks on the
elastic parts of the tray in these
rings.
Note: the rings are located
directly below the corresponding
upper fastenings. 5. Storage compartment
6. Can holder
7. Storage compartment
8. Bottle holder or portable bin
with ashtray
9. Luggage retaining net "low load" version fastenings
Fold the net in two.
Secure the two centre hooks in
the stowing rings on the floor.
Secure the net's remaining four
hooks on the tailgate pillars.
10. 12V socket for accessories
11. Luggage retaining net Secure the net's four hooks in
their stowing rings on the floor.
12. Tonneau To install it :
– position one end of the tonneau roller in the 2nd row, – compress the opposite end of
the roller and position it,
– release it to allow it to engage,
– unroll the tonneau as far as the rear shelf,
– secure the two hooks under the rear shelf,
To remove it:
– remove the tonneau hooks under the rear shelf,
– return the tonneau into its roller,
– compress it and remove it from its support at the 2nd row.
13. Rear shelf with umbrella holder
To remove the shelf:
– pull it rearward
– lift it slightly, then remove it
There are several options for
storing it:
– either hooked onto the ton neau
– or behind the seats or the rear bench seat
18-11-2002

When this warning light
comes on, connected to the
STOPwarning light,
accompanied by a buzzer
and the message "Braking
fault" , it indicates that there is a mal
function of the electronic brake force
distribution, which can cause a loss of
control of the vehicle when braking.
Stop immediately.
In both cases, consult a Peugeot
dealer.
ANTILOCK BRAKING
SYSTEM (ABS) AND THE
ELECTRONIC BRAKE FORCE
DISTRIBUTION (EBFD)
The ABS, in conjunction with the elec
tronic brake force distribution, increas
es the stability and manoevrability of
your vehicle, particularly on poor or
slippery road surfaces.
Note: when changing wheels (tyres
and rims), make sure that these are
approved.
The antilock braking system comes
into operation automatically when
there is a risk of wheel lock.
When this warning light
comes on, accompanied by
a buzzer and the message
"ABS fault" , it indicates
that there is a malfunction
of the ABS, which can cause a loss
of control of the vehicle when brak
ing.
YOUR 807 IN DETAIL
128
To return to normal operation, pull
the lever upwards until a click is
heard.Illumination of this light,
accompanied by an audible
signal and the message
"handbrake on" on the
multi–function display, indi
cates that the handbrake is still on or
has not been properly released.
HANDBRAKE
Applying
When parking, pull the handbrake to
immobilize your vehicle.
Warning : when parking on a slope,
direct your wheels towards the pave
ment and pull the handbrake.
Releasing
Pull on the handle and press the but
ton to release the handbrake.
Disengaging
Apply the handbrake.
Pull the button located at the end of
the handbrake forwards.
The handbrake lever lowers.
You can now pivot the seat. EMERGENCY BRAKING
ASSISTANCE SYSTEM
In an emergency, this system
enables the optimum braking pres
sure to be reached more quickly,
thus reducing the stopping distance.
It is triggered according to the speed
of activation of the brake pedal. The
effect of this is a reduction in the
resistance of the pedal and an
increase in braking efficiency. Normal operation of the ABS may
make itself felt by slight vibrations
of the brake system.
In emergency braking, press
very firmly without releasing
the pressure.
18-11-2002

YOUR 807 IN DETAIL131
REAR PARKING ASSISTANCE
This system consists of four proximity
sensors, located in the rear bumper,
and a special speaker fitted in the
fascia.
This detects any obstacle (person,
vehicle, tree, gate, pavement etc.)
behind the vehicle.
Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle
carrier is fitted (vehicle fitted with
towing attachment or bicycle carrier
recommended by PEUGEOT).
In wintry weather, ensure that the
sensors are not covered with frost or
snow.
Deactivation  Change to neutral, the system is
again inactive.
Activation
The system is activated as soon as
reverse gear is engaged; an audible
bleep shows that it is active.
The proximity information is given by
an audible signal, which becomes
more rapid as the vehicle approach
es the obstacle.
When the distance between the rear
of the vehicle and the obstacle is
less than approximately twentyfive
centimetres, the audible signal
becomes continuous.
Detection zone
If there is an operating
fault, the audible signal will
be a short bleep followed
by a long bleep when
changing to reverse gear.
18-11-2002