brake sensor Peugeot Bipper 2008 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2008, Model line: Bipper, Model: Peugeot Bipper 2008Pages: 131, PDF Size: 1.44 MB
Page 103 of 131

94
   Towing a trailer   
  In certain cases of particularly arduous  
use (towing the maximum load up a steep 
slope in high temperatures), the engine 
automatically limits its power. In this 
case, the automatic cutting off of the air 
conditioning allows the engine power to be 
recovered.  If the coolant temperature 
warning light comes on, stop the 
vehicle and switch off the engine 
as soon as possible. 
 See the "Levels" section of chapter 7. 
  
Tyres:   check the tyre pressures of the 
towing vehicle (see the "Identification  
features" section of chapter 7) and of 
the trailer, observing the recommended 
pressure.  
  
Brakes:   towing increases the braking 
distance. Drive at a moderate speed,  
change down early and brake gradually.    
Side wind:   sensitivity to side wind is 
increased. Drive smoothly and at a 
moderate speed.  
  
ABS:   the system only controls the vehicle, 
not the trailer. 
  
Rear parking assistance:   the 
assistance will be deactivated 
automatically when an original  PEUGEOT   
towbar is used (see the "Rear parking 
assistance" section of chapter 4). 
 We recommend the use of original  
 PEUGEOT  towbars and their harnesses, 
which have been tested and approved from 
the design stage of your vehicle, and that 
the fitting of this equipment is entrusted to a 
 PEUGEOT dealer . 
 If this equipment is not fitted by a  PEUGEOT 
dealer , it is essential that it is fitted using 
the electrical pre-equipment located at the 
rear of the vehicle in accordance with the 
manufacturer ’s instructions. 
 The operation of the sensors is deactivated 
automatically when the pin of the trailer 
cable is inserted in the towbar socket. 
 When the trailer cable pin is removed, the 
sensors are re-activated.  
  
Distribution of loads   
 Distribute the load in the trailer so that the 
heaviest objects are as close as possible 
to the axle and the nose weight is close to 
the maximum authorised without, however, 
exceeding it. The air density decreases with 
altitude, so reducing the performance of 
the engine. The maximum towed load must 
be reduced by 10 % for each 1 000 metres 
of altitude. Refer to the "Technical data" 
chapter for details of the weights and 
towed loads applicable to your vehicle and 
also to the administrative documents (V5 
registration document, ...).   
Page 131 of 131

121
7
TROUBLESHOOTING
   Checks   
  CHECKS 
  
Bleeding the water contained in the  
diesel filter   
 If this warning light comes on, 
bleed the filter, otherwise bleed 
regularly each time the engine is 
drained. 
 To evacuate the water, unscrew the bleed 
screw or the water in diesel sensor, located 
at the base of the filter. Operate until all 
of the water has been drained out. Then 
tighten the bleed screw or the water sensor. 
 HDi engines use advanced technology. All 
work requires a special qualification which is 
guaranteed by a  PEUGEOT dealer .  
  
Battery   
 At the start of winter,  have it checked by a  
PEUGEOT dealer .    
Air filter and passenger compartment 
filter   
   A   c l o g g e d   p a s s e n g e r   c o m p a r t m e n t   fi   l t e r   m a y  
reduce the performance of the air conditioning 
system and generate undesirable odours. The 
replacement intervals for these components 
are indicated in the servicing booklet. 
 Depending on the environment (dusty 
atmosphere...) and the use of the vehicle 
(urban driving...), change them twice as often 
if necessary, refer to the "Under the bonnet" 
section of chapter 7.  
  
Brake pads   
 Brake pad wear depends on the style of  
driving, in particular for vehicles which are 
used in town, over short distances. It may 
be necessary to check the thickness of the 
pads, even between services. 
 Unless there is a leak on the circuit, a drop 
in the brake fluid level indicates that the 
brake pads are worn.  
  
Brake disc/drum wear status   
 For any information relating to checking  
the brake disc/drum wear status,  consult a 
PEUGEOT dealer .    
Handbrake   
 Where the handbrake travel is too great 
or there is a reduction in the performance 
of the system, the handbrake should be 
adjusted, even between services. 
  Have it checked by a PEUGEOT dealer .  
  
Oil filter   
 Change the filter regularly, in accordance  
with the servicing schedule.  
  Manual gearbox 
 Have the level checked in accordance with  
the manufacturer ’s servicing schedule.  
 To check the main levels and certain  
components, in accordance with the 
manufacturer ’s servicing schedule, refer 
to the pages of the servicing booklet which 
correspond to your vehicle’s engine. 
 Only use products recommended by  
 PEUGEOT  or products of equivalent quality 
and characteristics. 
 In order to optimise the operation of units as 
important as the braking circuit,  PEUGEOT  
selects and offers specific products. 
 In order to avoid damaging the electrical 
units, high pressure washing to clean the 
engine compartment is strictly prohibited.